Airworthiness Directives; Fokker Services B.V. Airplanes
Notice Of Proposed Rulemaking (Nprm).
We propose to adopt a new airworthiness directive (AD) for certain Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. This proposed AD was prompted by reports of burned contacts in a certain production break plug and its corresponding receptacle. This proposed AD would require modifying galley power supply wiring by disconnecting it from the affected plug/receptacle and reconnecting the power supply wiring through splices. We are proposing this AD to prevent a high electrical load which may lead to overheating of the galley power supply wiring and/or the electrical connector and consequent smoke or fire in the galley area, which could result in damage to the airplane and injury to occupants.
1 action from November 2013
- Actions Will Continue Through
Table of Contents Back to Top
- Examining the AD Docket
- FOR FURTHER INFORMATION CONTACT:
- SUPPLEMENTARY INFORMATION:
- Comments Invited
- Relevant Service Information
- FAA's Determination and Requirements of This Proposed AD
- Costs of Compliance
- Authority for This Rulemaking
- Regulatory Findings
- List of Subjects in 14 CFR Part 39
- The Proposed Amendment
- PART 39—AIRWORTHINESS DIRECTIVES
- (a) Comments Due Date
- (b) Affected ADs
- (c) Applicability
- (d) Subject
- (e) Reason
- (f) Compliance
- (g) Modification
- (h) Other FAA AD Provisions
- (i) Related Information
DATES: Back to Top
We must receive comments on this proposed AD by July 27, 2012.
ADDRESSES: Back to Top
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
- Fax: (202) 493-2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
- Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Fokker Services B.V., Technical Services Dept., P.O. Box 231, 2150 AE Nieuw-Vennep, the Netherlands; telephone +31 (0)252-627-350; fax +31 (0)252-627-211; email: firstname.lastname@example.org; Internet http://www.myfokkerfleet.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221.
Examining the AD Docket Back to Top
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Back to Top
Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: (425) 227-1137; fax: (425) 425-227-1149; email: email@example.com.
SUPPLEMENTARY INFORMATION: Back to Top
Comments Invited Back to Top
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-0593; Directorate Identifier 2011-NM-238-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion Back to Top
The European Aviation Safety Agency (EASA), which is the aviation authority for the Member States of the European Community, has issued EASA Airworthiness Directive 2011-0183, dated September 23, 2011 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
Reports have been received about burned contacts in production break plug P4259B and corresponding receptacle J 4259A. After investigation, it was concluded that the high electrical load on the contacts M, L and X, in combination with the electrical loads on the adjacent connections, may have resulted in these occurrences.
This condition, if not detected and corrected, can lead to overheating of the galley power supply wiring and/or the electrical connector and consequent smoke or fire in the galley area, possibly resulting in damage to the aeroplane and injury to occupants.
For the reasons described above, this [EASA] AD requires modification of the galley power supply wiring by disconnecting it from the affected plug/receptacle and reconnecting the power supply wiring through splices.
You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information Back to Top
Fokker Services B.V has issued Fokker Service Bulletin SBF100-24-044, dated July 14, 2011, which includes the following attachment:
- Fokker Manual Change Notification—Maintenance Documentation MCNM-F100-148, dated July 14, 2011.
The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD Back to Top
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance Back to Top
Based on the service information, we estimate that this proposed AD would affect about 4 products of U.S. registry. We also estimate that it would take about 4 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $210 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $2,200, or $550 per product.
Authority for This Rulemaking Back to Top
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings Back to Top
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
The Proposed Amendment Back to Top
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES Back to Top
1. The authority citation for part 39 continues to read as follows:
§ 39.13 [Amended]
2. The FAA amends § 39.13 by adding the following new AD:
Fokker Services B.V.: Docket No. FAA-2012-0593; Directorate Identifier 2011-NM-238-AD.
(a) Comments Due Date Back to Top
We must receive comments by July 27, 2012.
(b) Affected ADs Back to Top
(c) Applicability Back to Top
This AD applies to Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes; certificated in any category; serial number (s/n) 11340 through 11343 inclusive, 11347, 11348, 11350 through 11356 inclusive, 11359, 11360, 11361, 11367 through 11371 inclusive, 11374 through 11378 inclusive, 11382 through 11385 inclusive, 11387 through 11390 inclusive, 11394 through 11397 inclusive, 11400 through 11423 inclusive, 11425 through 11432 inclusive, 11434 through 11439 inclusive, 11441 through 11453 inclusive, and 11456 through 11585 inclusive.
(d) Subject Back to Top
Air Transport Association (ATA) of America Code 24, Electrical Power.
(e) Reason Back to Top
This AD was prompted by reports of burned contacts in a certain production break plug and its corresponding receptacle. We are issuing this AD to prevent a high electrical load which may lead to overheating of the galley power supply wiring and/or the electrical connector and consequent smoke or fire in the galley area, which could result in damage to the airplane and injury to occupants.
(f) Compliance Back to Top
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Modification Back to Top
Within 24 months after the effective date of this AD: Modify the galley power supply wiring, in accordance with the Accomplishment Instructions of Fokker Service Bulletin SBF100-24-044, dated July 14, 2011, which includes Fokker Manual Change Notification—Maintenance Documentation MCNM-F100-148, dated July 14, 2011.
(h) Other FAA AD Provisions Back to Top
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Tom Rodriguez, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 227-1137; fax (425) 227-1149. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(i) Related Information Back to Top
Refer to MCAI EASA Airworthiness Directive 2011-0183, dated September 23, 2011; and Fokker Service Bulletin SBF 100-24-044, dated July 14, 2011, which includes Fokker Manual Change Notification—Maintenance Documentation MCNM-F100-148, dated July 14, 2011; for related information.
Issued in Renton, Washington, on May 31, 2012.
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 2012-14211 Filed 6-11-12; 8:45 am]
BILLING CODE 4910-13-P