Skip to Content
Notice

Draft Guidance for Industry and Food and Drug Administration Staff; Design Considerations for Devices Intended for Home Use; Availability

Action

Notice.

Summary

The Food and Drug Administration (FDA) is announcing the availability of the draft guidance entitled “Design Considerations for Devices Intended for Home Use.” This document is intended to assist manufacturers in designing and developing home use medical devices that comply with applicable standards of safety and effectiveness and other regulatory requirements. Home use devices are associated with unique risks created by the interactions among the user (often a layperson), the use environment, and the device. This document identifies several factors that manufacturers should consider, especially during device design and development, and provides recommendations for reducing or minimizing these unique risks. This draft guidance is not final nor is it in effect at this time.

 

Table of Contents Back to Top

DATES: Back to Top

Although you can comment on any guidance at any time (see 21 CFR 10.115(g)(5)), to ensure that the Agency considers your comment on this draft guidance before it begins work on the final version of the guidance, submit either electronic or written comments on the draft guidance by March 13, 2013.

ADDRESSES: Back to Top

Submit written requests for single copies of the draft guidance document entitled “Design Considerations for Devices Intended for Home Use” to the Division of Small Manufacturers, International, and Consumer Assistance, Center for Devices and Radiological Health (CDRH), Food and Drug Administration, 10903 New Hampshire Ave., Bldg. 66, Rm. 4613, Silver Spring, MD 20993-0002; or to the Office of Communication, Outreach and Development (HFM-40), Center for Biologics Evaluation and Research (CBER), Food and Drug Administration, 1401 Rockville Pike, Rockville, MD 20852-1448. Send one self-addressed adhesive label to assist that office in processing your request, or fax your request to 301-847-8149. See the SUPPLEMENTARY INFORMATION section for information on electronic access to the guidance.

Submit electronic comments on the draft guidance to http://www.regulations.gov. Submit written comments to the Division of Dockets Management (HFA-305), Food and Drug Administration, 5630 Fishers Lane, rm. 1061, Rockville, MD 20852. Identify comments with the docket number found in brackets in the heading of this document.

FOR FURTHER INFORMATION CONTACT: Back to Top

For information concerning the guidance as it relates to devices regulated by CDRH: Mary Brady, Center for Devices and Radiological Health, Food and Drug Administration, 10903 New Hampshire Ave., Bldg. 66, Rm. 5426, Silver Spring, MD 20993-0002, 301-796-6089.

For information concerning the guidance as it relates to devices regulated by CBER: Stephen Ripley, Center for Biologics Evaluation and Research (HFM-17), Food and Drug Administration, 1401 Rockville Pike, suite 200N, Rockville, MD 20852, 301-827-6210.

I. Background Back to Top

For a variety of reasons, use of devices outside professional healthcare facilities or clinical laboratories is on the rise. First, the U.S. population is aging, and the elderly are more likely to live with chronic diseases that require daily medical care at home. Second, due to medical advancements, many individuals with chronic diseases are living longer, but are dependent on home medical care. Finally, an increasing focus on reducing healthcare costs for patients of all ages has spurred the growth of the home health care market. Integral to the home health care market are home use devices. Although home use devices provide significant benefits to patients and families, including quality of life improvements and cost savings, home use devices are also associated with unique risks. Reducing or minimizing the risks posed by home use devices can greatly improve the public health.

This draft guidance provides recommendations for designing and developing medical devices intended for home use through considerations involving the physical environment, the user, the device or system, the labeling, and the utilization of human factors. This should result in a safe and easier-to-use device, minimize use error, and reduce the likelihood that adverse events will occur. The recommendations in the guidance apply to both prescription and over-the-counter medical devices that are intended for home use.

II. Significance of Guidance Back to Top

This draft guidance is being issued consistent with FDA's good guidance practices regulation (21 CFR 10.115). The draft guidance, when finalized, will represent the Agency's current thinking on the total product life cycle for devices intended for home use. It does not create or confer any rights for or on any person and does not operate to bind FDA or the public. An alternative approach may be used if such approach satisfies the requirements of the applicable statute and regulations.

III. Electronic Access Back to Top

Persons interested in obtaining a copy of the draft guidance may do so by using the Internet. A search capability for all CDRH guidance documents is available at http://www.fda.gov/MedicalDevices/DeviceRegulationandGuidance/GuidanceDocuments/default.htm. Guidance documents are also available at http://www.regulations.gov or from CBER at http://www.fda.gov/BiologicsBloodVaccines/GuidanceComplianceRegulatoryInformation/default.htm. To receive “Design Considerations for Devices Intended for Home Use” from CDRH, you may either send an email request to dsmica@fda.hhs.gov to receive an electronic copy of the document or send a fax request to 301-847-8149 to receive a hard copy. Please use the document number 1750 to identify the guidance you are requesting.

IV. Paperwork Reduction Act of 1995 Back to Top

This draft guidance refers to currently approved collections of information found in FDA regulations. These collections of information are subject to review by the Office of Management and Budget (OMB) under the Paperwork Reduction Act of 1995 (44 U.S.C. 3501-3520). The collections of information in 21 CFR part 801 and 21 CFR 809.10 have been approved under OMB control number 0910-0485; the collections of information in 21 CFR part 803 have been approved under OMB control number 0910-0437; the collections of information in 21 CFR part 807, subpart E have been approved under OMB control number 0910-0120; the collections of information in 21 CFR part 814 have been approved under OMB control number 0910-0231; the collections of information in 21 CFR part 820 have been approved under OMB control number 0910-0073; and the collections of information in Form FDA 3500A have been approved under OMB control number 0910-0291.

V. Comments Back to Top

Interested persons may submit either written comments regarding this document to the Division of Dockets Management (see ADDRESSES) or electronic comments to http://www.regulations.gov. It is only necessary to send one set of comments. Identify comments with the docket number found in brackets in the heading of this document. Received comments may be seen in the Division of Dockets Management between 9 a.m. and 4 p.m., Monday through Friday, and will be posted to the docket at http://www.regulations.gov.

Dated: December 5, 2012.

Leslie Kux,

Assistant Commissioner for Policy.

[FR Doc. 2012-30033 Filed 12-12-12; 8:45 am]

BILLING CODE 4160-01-P

Site Feedback