Skip to Content

Rule

Airworthiness Directives; BAe Systems (Operations) Limited Model Avro 146-RJ85A and 146-RJ100A Series Airplanes

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Final rule; request for comments.

SUMMARY:

This amendment adopts a new airworthiness directive (AD), applicable to certain BAe Systems (Operations) Limited Model Avro 146-RJ85A and 146-RJ100A series airplanes. This action requires replacement of bolts in the wing rear spar at the center fuel tank. This action is prompted by mandatory continuing airworthiness information from a foreign civil airworthiness authority. This action is necessary to prevent the failure of bolts in the wing rear spar at the center fuel tank, which could result in reduced structural integrity of the airplane. This action is intended to address the identified unsafe condition.

DATES:

Effective September 7, 2001.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of September 7, 2001.

Comments for inclusion in the Rules Docket must be received on or before September 24, 2001.

ADDRESSES:

Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket Number 2001-NM-223-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: 9-anm-iarcomment@faa.gov. Comments sent via fax or the Internet must contain “Docket No. 2001-NM-223-AD” in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.

The service information referenced in this AD may be obtained from British Start Printed Page 44294Aerospace Regional Aircraft American Support, 13850 Mclearan Road, Herndon, Virginia 20171. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Todd Thompson, Aerospace Engineer, International Branch, ANM-116, FAA, Transport Airplane Directorate, Renton, Washington; telephone (425) 227-1175; fax (425) 227-1149.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

The Civil Aviation Authority (CAA), which is the airworthiness authority for the United Kingdom, notified the FAA that an unsafe condition may exist on certain BAe Systems (Operations) Limited Model Avro 146-RJ85A and 146-RJ100A series airplanes. The CAA advises that it has received a manufacturer's quality alert which identifies batches of bolts which possibly are of low strength. These bolts are on the wing rear spar at the center fuel tank. This condition, if not corrected, could lead to failure of the bolts on the wing rear spar at the center fuel tank, which could result in reduced structural integrity of the airplane.

Explanation of Relevant Service Information

BAe Systems (Operations) Limited has issued Inspection Service Bulletin ISB.57-064, dated March 8, 2001, which describes procedures for replacement of 8 bolts (4 on the left and 4 on the right side) on the wing rear spar at the center fuel tank with new bolts. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition. The CAA classified this service bulletin as mandatory and issued British airworthiness directive 004-03-2001, in order to assure the continued airworthiness of these airplanes in Great Britain.

FAA's Conclusions

These airplane models are manufactured in the United Kingdom and are type certificated for operation in the United States under the provisions of § 21.29 of the Federal Aviation Regulations (14 CFR 21.19) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, the CAA has kept the FAA informed of the situation described above. The FAA has examined the findings of the CAA, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.

Explanation of Requirements of the Rule

Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design that may be registered in the United States at some time in the future, this AD is being issued to prevent failure of the bolts on the wing rear spar at the center fuel tank. This AD requires replacement of 8 bolts on the wing rear spar at the center fuel tank. The actions are required to be accomplished in accordance with the service bulletin described previously.

Cost Impact

None of the Model Avro 146-RJ85A and 146-RJ100A series airplanes affected by this action are on the U.S. Register. All airplanes included in the applicability of this rule currently are operated by non-U.S. operators under foreign registry; therefore, they are not directly affected by this AD action. However, the FAA considers that this rule is necessary to ensure that the unsafe condition is addressed in the event that any of these subject airplanes are imported and placed on the U.S. Register in the future.

Should an affected airplane be imported and placed on the U.S. Register in the future, it would require approximately 3 work hours to accomplish the required actions, at an average labor rate of $60 per work hour. Based on these figures, the cost impact of this AD would be $180 per airplane.

Determination of Rule's Effective Date

Since this AD action does not affect any airplane that is currently on the U.S. register, it has no adverse economic impact and imposes no additional burden on any person. Therefore, prior notice and public procedures hereon are unnecessary and the amendment may be made effective in less than 30 days after publication in the Federal Register.

Comments Invited

Although this action is in the form of a final rule and was not preceded by notice and opportunity for public comment, comments are invited on this rule. Interested persons are invited to comment on this rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified under the caption ADDRESSES. All communications received on or before the closing date for comments will be considered, and this rule may be amended in light of the comments received. Factual information that supports the commenter's ideas and suggestions is extremely helpful in evaluating the effectiveness of the AD action and determining whether additional rulemaking action would be needed.

Submit comments using the following format:

  • Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
  • For each issue, state what specific change to the AD is being requested.
  • Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify the rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report that summarizes each FAA-public contact concerned with the substance of this AD will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this rule must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket Number 2001-NM-223-AD.” The postcard will be date stamped and returned to the commenter.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Start Printed Page 44295Docket at the location provided under the caption ADDRESSES.

Start List of Subjects

List of Subjects in 14 CFR Part 39

End List of Subjects

Adoption of the Amendment

Start Amendment Part

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (

End Amendment Part Start Part

PART 39—AIRWORTHINESS DIRECTIVES

End Part Start Amendment Part

1. The authority citation for part 39 continues to read as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]
Start Amendment Part

2. Section 39.13 is amended by adding the following new airworthiness directive:

End Amendment Part

2001-16-15 BAE Systems (Operations) Limited (Formerly British Aerospace Regional Aircraft): Amendment 39-12384. Docket 2001-NM-223-AD.

Applicability: Model Avro 146-RJ85A series airplanes, serial numbers E2302, E2303, E2304, E2305, and E2306; and Avro 146-RJ100A series airplanes, serial number E3301; certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent failure of the bolts in the wing rear spar at the center fuel tank, which could result in reduced structural integrity of the airplane, accomplish the following:

Replacement

(a) At the next internal access of the center fuel tank but no later than 4,000 flight cycles after the effective date of this AD: Replace the 8 bolts in the wing rear spar at the center fuel tank with new bolts, in accordance with BAe Systems (Operations) Limited Inspection Service Bulletin ISB.57-064, dated March 8, 2001.

Alternative Methods of Compliance

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.

Note 2:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Manager, International Branch.

Special Flight Permits

(c) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Incorporation by Reference

(d) The replacement shall be done in accordance with BAe Systems (Operations) Limited Inspection Service Bulletin ISB.57-064, dated March 8, 2001. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from British Aerospace Regional Aircraft American Support, 13850 Mclearen Road, Herndon, Virginia 20171. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Note 3:

The subject of this AD is addressed in British airworthiness directive 004-03-2001.

Effective Date

(e) This amendment becomes effective on September 7, 2001.

Start Signature

Issued in Renton, Washington, on August 15, 2001.

Vi L. Lipski,

Manager, Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. 01-21104 Filed 8-22-01; 8:45 am]

BILLING CODE 4910-13-P