Skip to Content

Rule

Airworthiness Directives; Raytheon Model DH.125, HS.125, BH.125, and BAe. 125 (U-125 and C-29A) Series Airplanes; Model Hawker 800, Hawker 800 (U-125A), Hawker 800XP, and Hawker 1000 Airplanes

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Final rule.

SUMMARY:

This amendment adopts a new airworthiness directive (AD), applicable to certain Raytheon Model DH.125, HS.125, BH.125, and BAe. 125 (U-125 and C-29A) series airplanes; Model Hawker 800, Hawker 800 (U-125A), Hawker 800XP, and Hawker 1000 airplanes, that requires an inspection for cracking or corrosion of the cylinder head lugs of the main landing gear (MLG) actuator and follow-on/corrective actions. This amendment is prompted by reports of attachment lugs cracking at the actuator cylinder head. The actions specified by this AD are intended to prevent separation of the cylinder head lugs, which could prevent the MLG from extending and result in a partial gear-up landing.

DATES:

Effective October 3, 2001.

The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of October 3, 2001.

ADDRESSES:

The service information referenced in this AD may be obtained from Raytheon Aircraft Company, Department 62, P.O. Box 85, Wichita, Kansas 67201-0085. This information may be examined at the Federal Start Printed Page 45576Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

David Ostrodka, Aerospace Engineer, Airframe Branch, ACE-118W, FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Wichita, Kansas 67209; telephone (316) 946-4129; fax (316) 946-4407.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Raytheon Model DH.125, HS.125, BH.125, and BAe 125 (U-125 and C-29A) series airplanes, and Hawker 800, Hawker 800 (U-125A), Hawker 800XP, and Hawker 1000 airplanes was published in the Federal Register on June 5, 2001 (66 FR 30107). That action proposed to require an inspection to detect cracking or corrosion of the cylinder head lugs of the main landing gear (MLG) and follow-on/corrective actions.

Comments

Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.

Conclusion

The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.

Cost Impact

There are approximately 1,000 airplanes of the affected design in the worldwide fleet. The FAA estimates that 650 airplanes of U.S. registry will be affected by this AD, that it will take approximately 20 work hours per airplane to accomplish the required inspection, and that the average labor rate is $60 per work hour. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $780,000, or $1,200 per airplane.

The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.

Start List of Subjects

List of Subjects in 14 CFR Part 39

End List of Subjects

Adoption of the Amendment

Start Amendment Part

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (

End Amendment Part Start Part

PART 39—AIRWORTHINESS DIRECTIVES

End Part Start Amendment Part

1. The authority citation for part 39 continues to read as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]
Start Amendment Part

2. Section 39.13 is amended by adding the following new airworthiness directive:

End Amendment Part

2001-17-26 Raytheon Aircraft Company: Amendment 39-12417. Docket 2000-NM-373-AD.

Applicability: Model DH.125, HS.125, BH.125, and BAe. 125 (U-125 and C-29A) series airplanes; Model Hawker 800, Hawker 800 (U-125A), Hawker 800XP, and Hawker 1000 airplanes; certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (d) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent separation of the cylinder head lugs, which could prevent the main landing gear (MLG) from extending and result in a partial gear-up landing, accomplish the following:

Inspection

(a) Perform an eddy current inspection of the actuator cylinder head lugs for cracking or corrosion per Raytheon Service Bulletin 32-3391, dated August 2000, at the time specified in paragraph (a)(1), (a)(2), (a)(3), or (a)(4) of this AD, as applicable.

(1) For actuator cylinder heads that have 3,000 or less total landings as of the effective date of this AD: Perform the eddy current inspection within 24 months after the effective date of this AD.

(2) For actuator cylinder heads that have 3,001 to 4,000 total landings as of the effective date of this AD: Perform the eddy current inspection within 6 months after the effective date of this AD.

(3) For actuator cylinder heads that have been in service for more than 7 years as of the effective date of this AD: Perform the eddy current inspection within 6 months of the effective date of this AD.

(4) For actuator cylinder heads that have 4,001 or more total landings as of the effective date of this AD: Perform the eddy current inspection within 10 landings after the effective date of this AD.

If No Cracking or Corrosion

(b) If no cracking or corrosion is found during the inspection required by paragraph (a) of this AD, before further flight, accomplish the follow-on actions (e.g., “vibro-etching” the MLG actuator data plate, painting a blue stripe on the actuator cylinder head to indicate 1/32 inch oversize bushings, replacing bushings, and applying corrosion protection to the lug bores), per Raytheon Service Bulletin 32-3391, dated August 2000.

If Any Cracking or Corrosion

(c) If any cracking or corrosion is found during the inspection required by paragraph (a) of this AD, before further flight, accomplish either of the actions specified in paragraph (c)(1) or (c)(2) of this AD, per Raytheon Service Bulletin 32-3391, dated August 2000.

(1) Replace the actuator of the MLG with a new or serviceable actuator, or

(2) Replace the actuator cylinder head with a new cylinder head.

Start Printed Page 45577

Note 2:

Raytheon Service Bulletin 32-3391, dated August 2000, references Precision Hydraulics Cylinder Maintenance Manual (CMM) 32-30-1105 as an additional source of service information.

Alternative Methods of Compliance

(d) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.

Note 3:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.

Special Flight Permit

(e) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Incorporation by Reference

(f) The actions shall be done in accordance with Raytheon Service Bulletin 32-3391, dated August 2000. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Raytheon Aircraft Company, Department 62, P.O. Box 85, Wichita, Kansas 67201-0085. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Wichita, Kansas; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.

Effective Date

(g) This amendment becomes effective on October 3, 2001.

Start Signature

Issued in Renton, Washington, on August 20, 2001.

Vi L. Lipski,

Manager, Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. 01-21491 Filed 8-28-01; 8:45 am]

BILLING CODE 4910-13-P