Federal Aviation Administration (FAA), DOT.
Final special conditions; request for comments.
These special conditions are issued for Boeing Model 747-200/-300 series airplanes modified by Hollingsead International, Inc. These modified airplanes will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The modification incorporates the installation of new Liquid Crystal Flight Instruments as Attitude Directional Indicators (ADI), the Horizontal Situation Indicators (HSI) and Engine Display Interface System (EDIS). The liquid crystal flight instruments will utilize electrical and electronic systems that perform critical functions. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for the protection of these systems from the effects of high-intensity-radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
The effective date of these special conditions is October 25, 2001. Comments must be received on or before December 24, 2001.
Comments on these special conditions may be mailed in duplicate to: Federal Aviation Administration, Transport Airplane Directorate, Attention: Rules Docket (ANM-113), Docket No. NM199, 1601 Lind Avenue SW., Renton, Washington 98055-4056; or delivered in duplicate to the Transport Airplane Directorate at the above address. All comments must be marked: Docket No. NM199. Comments may be inspected in the Rules Docket weekdays, except Federal holidays, between 7:30 a.m. and 4:00 p.m.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Greg Dunn, FAA, Airplane and Flight Crew Interface Branch, ANM-111, Transport Airplane Directorate, Aircraft Certification Service, 1601 Lind Avenue SW., Renton, Washington 98055-4056; telephone (425) 227-2799; facsimile (425) 227-1149.End Further Info End Preamble Start Supplemental Information
The FAA has determined that notice and opportunity for prior public comment hereon are impracticable because these procedures would significantly delay certification of the airplane and thus delivery of the affected aircraft. The FAA therefore finds that good cause exists for making these special conditions effective upon issuance.
Interested persons are invited to submit such written data, views, or arguments as they may desire. Communications should identify the rules docket number and be submitted in duplicate to the address specified above. The Administrator will consider all communications received on or before the closing date for comments. The special conditions may be changed in light of the comments received. All comments received will be available in the Rules Docket for examination by interested persons, both before and after the closing date for comments. A report summarizing each substantive public contact with FAA personnel concerning this rulemaking will be filed in the docket. Persons wishing the FAA to acknowledge receipt of their comments submitted in response to these special conditions must include with those comments a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket No. NM199.” The postcard will be date stamped and returned to the commenter.
On October 13, 1997, Hollingsead International, Inc., 7416 Hollister Avenue, Goleta, California 93117-2538, applied for a Supplemental Type Certificate (STC) for the Boeing Model 747-200/-300 series airplanes. The Boeing Model 747-200/-300 series airplanes are equipped with four CF650E2 turbofan engines. The aircraft have a crew of three with additional seating for one, consisting of a jump seat in the cockpit. The aircraft are operated by KLM Royal Dutch airlines in “freighter,” “combi,” and “full Start Printed Page 56198passenger” configurations. The Boeing 747-200/-300 airplanes will incorporate Smiths Industries 5-ATI liquid crystal flight instruments. The modified airplanes are scheduled for certification in November 2001.
The functions of the liquid crystal flight instruments can be susceptible to disruption of both command and response signals as a result of electrical and magnetic interference caused by HIRF external to the airplane. This disruption of signals could result in loss of critical flight displays and annunciations, or could present misleading information to the pilot.
Type Certification Basis
Under the provisions of 14 CFR 21.101, Hollingsead International, Inc, must show that the Boeing 747-200/-300 series airplanes, as changed, continue to meet the applicable provisions of the regulations incorporated by reference in Type Certificate No. A20WE, or the applicable regulations in effect on the date of application for the change. The regulations incorporated by reference in the type certificate are commonly referred to as the “original type certification basis.” The regulations included in the certification basis for the Boeing Model 747-200/-300 series airplanes include 14 CFR part 25, as amended by Amendment 25-1 through Amendment 25-91.
If the Administrator finds that the applicable airworthiness regulations (i.e., part 25, as amended) do not contain adequate or appropriate safety standards for the Boeing Model 747-200/300 series airplanes because of a novel or unusual design feature, special conditions are prescribed under the provisions of § 21.16.
In addition to the applicable airworthiness regulations and special conditions, the Boeing Model 747-200/-300 series airplanes must comply with the fuel vent and exhaust emission requirement of 14 CFR part 34 and the noise certification requirement of 14 CFR part 36.
Special conditions, as defined in § 11.19, are issued in accordance with § 11.38 and become part of the airplane's type certification basis in accordance with § 21.101(b)(2).
Special conditions are initially applicable to the model for which they are issued. Should the applicant apply for a supplemental type certificate to modify any other model included on the same type certificate to incorporate the same novel or unusual design features, these special conditions would also apply to the other model under the provisions of § 21.101(a)(1).
Novel or Unusual Design Features
The Boeing Model 747-200/-300 series airplanes will incorporate the Smiths Industries 5-ATI liquid crystal flight instruments as ADI, HSI and EDIS, which perform critical functions. The liquid crystal flight instruments contain electronic equipment for which the current airworthiness standards (14 CFR part 25) do not contain adequate or appropriate safety standards that address protecting this equipment from the adverse effects of HIRF. These instruments may be vulnerable to HIRF external to the airplane. Accordingly, these instruments are considered to be a novel or unusual design feature.
There is no specific regulation that addresses protection requirements for electrical and electronic systems from HIRF. Increased power levels from ground-based radio transmitters and the growing use of sensitive avionics/electronics and electrical systems to command and control airplanes have made it necessary to provide adequate protection.
To ensure that a level of safety is achieved that is equivalent to that intended by the regulations incorporated by reference, special conditions are needed for the Boeing Model 747-200/-300 airplanes modified to include the Smiths Industries 5-ATI liquid crystal flight instruments as ADI, HSI and EDIS. These special conditions will require that these instruments, which perform critical functions, be designed and installed to preclude component damage and interruption of function due to both the direct and indirect effects of HIRF.
High-Intensity Radiated Fields (HIRF)
With the trend toward increased power levels from ground-based transmitters, plus the advent of space and satellite communications coupled with electronic command and control of the airplane, the immunity of critical avionics/electronics and electrical systems to HIRF must be established.
It is not possible to precisely define the HIRF to which the airplane will be exposed in service. There is also uncertainty concerning the effectiveness of airframe shielding for HIRF. Furthermore, coupling of electromagnetic energy to cockpit-installed equipment through the cockpit window apertures is undefined. Based on surveys and analysis of existing HIRF emitters, an adequate level of protection exists when compliance with the HIRF protection special condition is shown in accordance with either paragraph 1 or 2 below:
1. A minimum threat of 100 volts rms per meter electric field strength from 10 KHz to 18 GHz.
a. The threat must be applied to the system elements and their associated wiring harnesses without the benefit of airframe shielding.
b. Demonstration of this level of protection is established through system tests and analysis.
2. A threat external to the airframe of the following field strengths for the frequency ranges indicated. Both peak and average field strength components from the Table are to be demonstrated.
|Frequency||Field strength (volts per meter)|
|10 kHz-100 kHz||50||50|
|100 kHz-500 kHz||50||50|
|500 kHz-2 MHz||50||50|
|2 MHz-30 MHz||100||100|
|30 MHz-70 MHz||50||50|
|70 MHz-100 MHz||50||50|
|100 MHz-200 MHz||100||100|
|200 MHz-400 MHz||100||100|
|400 MHz-700 MHz||700||50|
|700 MHz-1 GHz||700||100|
|1 GHz-2 GHz||2000||200|
|2 GHz-4 GHz||3000||200|
|4 GHz-6 GHz||3000||200|
|Start Printed Page 56199|
|6 GHz-8 GHz||1000||200|
|8 GHz-12 GHz||3000||300|
|12 GHz-18 GHz||2000||200|
|18 GHz-40 GHz||600||200|
|The field strengths are expressed in terms of peak of the root-mean-square (rms) over the complete modulation period.|
The threat levels identified above are the result of an FAA review of existing studies on the subject of HIRF, in light of the ongoing work of the Electromagnetic Effects Harmonization Working Group of the Aviation Rulemaking Advisory Committee.
As discussed above, these special conditions are applicable to the Boeing Model 747-200/-300 series airplanes modified by Hollingsead International, Inc. to include the Smiths Industries 5-ATI liquid crystal flight instruments, as ADI, HSI and EDIS. Should Hollingsead International apply at a later date for a supplemental type certificate to modify any other model included on Type Certificate No. A20WE to incorporate the same novel or unusual design features, these special conditions would apply to that model as well under the provisions of § 21.101(a)(1).
This action affects only certain novel or unusual design features on the Boeing Model 747-200/-300 series airplanes modified by Hollingsead International, Inc. It is not a rule of general applicability and affects only the applicant who applied to the FAA for approval of these features on the airplanes.
The substance of these special conditions has been subjected to the notice and comment period in several prior instances and has been derived without substantive change from those previously issued. Because a delay would significantly affect the certification of the airplane, which is imminent, the FAA has determined that prior public notice and comment are unnecessary and impracticable, and good cause exists for adopting these special conditions upon issuance. The FAA is requesting comments to allow interested persons to submit views that may not have been submitted in response to the prior opportunities for comment described above.Start List of Subjects
List of Subjects in 14 CFR Part 25
- Aviation safety
- Reporting and recordkeeping requirements
The authority citation for these special conditions is as follows:
The Special ConditionsStart Amendment Part
Accordingly, pursuant to the authority delegated to me by the Administrator, the following special conditions are issued as part of the supplemental type certification basis for the Boeing Model 747-200/-300 series airplanes modified by Hollingsead International, Inc.End Amendment Part Start Amendment Part
1. Protection from Unwanted Effects of High-Intensity Radiated Fields (HIRF). Each electrical and electronic system that performs critical functions must be designed and installed to ensure that the operation and operational capability of these systems to perform critical functions are not adversely affected when the airplane is exposed to high-intensity radiated fields.End Amendment Part Start Amendment Part
2. For the purpose of these special conditions, the following definition applies: Critical Functions: Functions whose failure would contribute to or cause a failure condition that would prevent the continued safe flight and landing of the airplane.End Amendment Part Start Signature
Issued in Renton, Washington, on October 25, 2001.
Kalene C. Yanamura,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 01-27986 Filed 11-6-01; 8:45 am]
BILLING CODE 4910-13-P