Federal Aviation Administration (FAA), DOT.
This action modifies Class E airspace at Winona, MN. An Area Navigation (RNAV) Standard Instrument Approach Procedures (SIAP) has been developed for Brainered-Crow Winona Municipal-Max Conrad Airport. Controlled airspace extending upward from 700 feet or more above the surface of the earth is needed to contain aircraft executing this approach. This action increases the radius of the existing controlled airspace for Winona Municipal-Max Conrad Airport.
0901 UTC, June 13, 2002.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Denis C. Burke, Air Traffic Division, Airspace Branch, AGL-520, Federal Aviation Administration, 2300 East Devon Avenue, Des Plaines, Illinois 60018, telephone (847) 294-7568.End Further Info End Preamble Start Supplemental Information
On Wednesday, January 16, 2002, the FAA proposed to amend 14 CFR part 71 to modify Class E airspace at Winona, MN (67 FR 2149). The proposal was to modify controlled airspace extending upward from 700 feet above the surface of the earth to contain Instrument Flight Rules (IFR) operations in controlled airspace during portions of the terminal operation and while transiting between the enroute and terminal environments.
Interested parties were invited to participate in this rulemaking proceeding by submitting written comments on the proposal to the FAA. No comments objecting to the proposal were received. Class E airspace designations for airspace areas extending upward from 700 feet or more above the surface of the earth are published in paragraph 6005, of FAA Order 7400.9J dated August 31, 2001, and effective September 16, 2001, which is incorporated by reference in 14 CFR 71.1. The Class B and Class E airspace designations listed in this document will be published subsequently in the Order.
This amendment to 14 CFR part 71 modifies Class E airspace at Winona, MN, to accommodate aircraft executing instrument flight procedures into an out of Winona Municipal-Max Conrad Airport. The area will be depicted on appropriate aeronautical charts.
The FAA has determined that this regulation only involves an established body of technical regulations for which frequent and routine amendments are necessary to keep them operationally current. Therefore, this regulation—(1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034; February 26, 1979); and (3) does not warrant preparation of a Regulatory Evaluation as the anticipated impact is so minimal. Since this is a routine matter that will only affect air traffic procedures and air navigation, it is certified that this rule will not have a significant economic impact on a Start Printed Page 30781substantial number of small entities under the criteria of the Regulatory flexibility Act.Start List of Subjects
List of Subjects in 14 CFR Part 71End List of Subjects
Adoption of the AmendmentStart Amendment Part
In consideration of the forgoing, the Federal Aviation Administration amendsEnd Amendment Part Start Part
PART 71—DESIGNATION OF CLASS A, CLASS B, CLASS C, CLASS D, AND CLASS E AIRSPACE AREAS; AIRWAYS; ROUTES; AND REPORTING POINTSEnd Part Start Amendment Part
1. The authority citation for part 71 continues to read as follows:End Amendment Part
2. The incorporation by reference inEnd Amendment Part
Paragraph 6005 Class E airspace areas extending upward from 700 feet or more above the surface of the earth.
AGL MN E5 Winona, MN [Revised]
Winona Municipal-Max Conrad Airport, MN
(Lat. 40°04′ 38″ N., long. 91°42′30″ W.)
That airspace extending upward from 700 feet above the surface within a 7-mile radius of the Winona Municipal-Max Conrad Airport, and within 2 miles each side of the 108° bearing extending from the 7-mile radius to 9.5 miles southeast of the airport excluding that airspace within the LaCrosse WI Class E airspace area.
Issued in Des Plaines, Illinois on March 29, 2002.
Nancy B. Shelton,
Manager, Air Traffic Division, Great Lakes Region.
[FR Doc. 02-11502 Filed 5-7-02; 8:45 am]
BILLING CODE 4910-13-M