Skip to Content

Proposed Rule

Airworthiness Directives; Raytheon Model Hawker 800XP Airplanes

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration, DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain Raytheon Model Hawker 800XP airplanes. This proposal would require installing jumper wires on the computer control switches to power the digital electronic engine control when overspeed protection is selected, and tying and stowing the jumper wires on the switches. The actions specified by the proposed AD are intended to prevent loss of the overspeed protection function without the flightcrew's awareness, due to missing jumper wires, which could result in engine overspeed and possible uncommanded engine shutdown. This action is intended to address the identified unsafe condition.

DATES:

Comments must be received by November 12, 2002.

ADDRESSES:

Submit comments in triplicate to the Federal Aviation Start Printed Page 60192Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-315-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: 9-anm-nprmcomment@faa.gov. Comments sent via fax or the Internet must contain “Docket No. 2001-NM-315-AD” in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.

The service information referenced in the proposed rule may be obtained from Raytheon Aircraft Company, Department 62, P.O. Box 85, Wichita, Kansas 67201-0085. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Jeff Pretz, Aerospace Engineer, Airframe and Propulsion Branch, ACE-118W, FAA, Wichita Aircraft Certification Office, 1801 Airport Road, Room 100, Mid-Continent Airport, Wichita, Kansas 67209; telephone (316) 946-4153; fax (316) 946-4407.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Comments Invited

Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.

Submit comments using the following format:

  • Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
  • For each issue, state what specific change to the proposed AD is being requested.
  • Include justification (e.g., reasons or data) for each request.

Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.

Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket 2001-NM-315-AD.” The postcard will be date stamped and returned to the commenter.

Availability of NPRMs

Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-315-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.

Discussion

The FAA received a report that the jumper wires, which provide power from the computer control switches to the digital electronic engine control (DEEC), were missing on a Raytheon Model Hawker 800XP airplane. Power to the DEEC is necessary so when the flightcrew places the computer control switches in the overspeed protection position, the overspeed protection mode will be activated. Investigation by the manufacturer revealed that the jumper wires were omitted from the production drawing. Such conditions, if not corrected, could result in loss of the overspeed protection function without the flightcrew's awareness. This situation could result in engine overspeed, and possible uncommanded engine shutdown.

Explanation of Relevant Service Information

The FAA has reviewed and approved Raytheon Service Bulletin SB 76-3480, dated August 2001, which describes procedures for installing jumper wires on the computer control switches to power the digital electronic engine control (DEEC) when overspeed protection is selected, and tying and stowing the jumper wires on the switches. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition.

Explanation of Requirements of Proposed Rule

Since an unsafe condition has been identified that is likely to exist or develop on other products of this same type design, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.

Cost Impact

There are approximately 250 Model 800XP airplanes of the affected design in the worldwide fleet. The FAA estimates that 193 airplanes of U.S. registry would be affected by this proposed AD. It would take approximately 5 work hours per airplane for airplanes with two oxygen bottles, and 6 work hours per airplane for airplanes with three oxygen bottles, to accomplish the proposed actions, at an average labor rate of $60 per work hour. The cost of required parts would be nominal. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $300 per airplane (for airplanes with two oxygen bottles) or $360 per airplane (for airplanes with three oxygen bottles).

The cost impact figures discussed above are based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.

Regulatory Impact

The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.

For the reasons discussed above, I certify that this proposed regulation (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities Start Printed Page 60193under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.

Start List of Subjects

List of Subjects in 14 CFR Part 39

End List of Subjects

The Proposed Amendment

Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

Start Part

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]

2. Section 39.13 is amended by adding the following new airworthiness directive:

Ratheon Aircraft Company: Docket 2001-NM-315-AD.

Applicability: Model Hawker 800XP airplanes, as listed in Raytheon Service Bulletin SB 76-3480, dated August 2001; certificated in any category.

Note 1:

This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.

Compliance: Required as indicated, unless accomplished previously.

To prevent loss of the overspeed protection function without the flightcrew's awareness, due to missing jumper wires, which could result in engine overspeed and possible uncommanded engine shutdown, accomplish the following:

Jumper Wire Installation

(a) Within 3 months or 300 flight hours after the effective date of this AD, whichever occurs first, do the actions specified in paragraphs (a)(1), (a)(2), and (a)(3) of this AD per Raytheon Service Bulletin SB 76-3480, dated August 2001.

(1) Install a four-inch jumper wire between terminals 1 and 3 on the computer control switch “NF.”

(2) Install a six-inch jumper wire between terminals 1 and 3 on the computer control switch “NG.”

(3) Tie and stow the jumper wires on the computer control switches “NF” and “NG” using tie-wrap.

Alternative Methods of Compliance

(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Wichita Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Wichita ACO.

Note 2:

Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Wichita ACO.

Special Flight Permits

(c) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.

Start Signature

Issued in Renton, Washington, on September 16, 2002.

Vi L. Lipski,

Manager, Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Part End Supplemental Information

[FR Doc. 02-24308 Filed 9-24-02; 8:45 am]

BILLING CODE 4910-13-P