Skip to Content

Proposed Rule

Approval and Promulgation of Air Quality Implementation Plans; Wisconsin

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Proposed rule.

SUMMARY:

EPA is proposing to approve a revision to the Wisconsin State Implementation Plan (SIP) for an alternative volatile organic compounds (VOC) control device for Serigraph, Incorporated (Serigraph). On May 18, 2005, the Wisconsin Department of Natural Resources submitted a request to revise the Wisconsin SIP. The proposed revision approves Serigraph's use of a biofilter to control VOC emissions from its printing facility in Washington County, Wisconsin. The biofilter system will reliably control emissions at or below the level of the control methods listed in the SIP. Serigraph has designed one of its plants as a permanent total enclosure (PTE), which captures all VOC emissions and routes them to the biofilter. There are no fugitive emissions from the plant. This reduces the total VOC emissions from Serigraph's facility.

In the final rules section of this Federal Register, EPA is approving the SIP revision as a direct final rule without prior proposal, because EPA views this as a noncontroversial revision and anticipates no adverse comments. A detailed rationale for the approval is set forth in the direct final rule. We do not intend to take any further action in relation to this proposed rule unless we receive adverse comment this action. If EPA receives adverse comment, we will withdraw the direct final rule and will respond to all public comments in a subsequent final rule based on this proposed rule. EPA will not institute a second comment period on this action. Any parties interested in commenting on this action should do so at this time.

DATES:

Written comments must be received on or before November 14, 2005.

ADDRESSES:

Submit comments, identified by Regional Material in EDocket (RME) ID No. R05-OAR-2005-WI-0002 by one of the following methods:

Federal eRulemaking Portal: http://www.regulations.gov. Follow the on-line instructions for submitting comments.

Agency Web site: http://docket.epa.gov/​rmepub/​.

RME, EPA's electronic public docket and comment system, is EPA's preferred method for receiving comments. Once in the system, select “quick search,” then key in the appropriate RME Docket identification number. Follow the online instructions for submitting comments.

E-mail: mooney.john@epa.gov.

Fax: (312) 886-5824.

Mail: You may send written comments to: John M. Mooney, Chief, Criteria Pollutant Section, (AR-18J), U.S. Environmental Protection Agency, 77 West Jackson Boulevard, Chicago, Illinois 60604.

Hand delivery: Deliver your comments to: John M. Mooney, Chief, Criteria Pollutant Section (AR-18J), U.S. Environmental Protection Agency, Region 5, 77 West Jackson Boulevard, 18th floor, Chicago, Illinois 60604.

Such deliveries are only accepted during the Regional Office's normal hours of operation. The Regional Office's official hours of business are Monday through Friday, 8:30 a.m. to 4:30 p.m. excluding Federal holidays.

Instructions: Direct your comments to RME ID No. R05-OAR-2005-WI-0002. EPA's policy is that all comments received will be included in the public docket without change, including any personal information provided, unless the comment includes information claimed to be Confidential Business Information (CBI) or other information whose disclosure is restricted by statute. Do not submit information that you consider to be CBI or otherwise protected through RME, regulations.gov, or e-mail. The EPA RME Web site and the Federal regulations.gov Web site are “anonymous access” systems, which means EPA will not know your identity or contact information unless you provide it in the body of your comment. If you send an e-mail comment directly to EPA without going through RME or regulations.gov, your e-mail address will be automatically captured and included as part of the comment that is placed in the public docket and made available on the Internet. If you submit an electronic comment, EPA recommends that you include your name and other contact information in the body of your comment and with any disk or CD-ROM you submit. If EPA cannot read your comment due to technical difficulties and cannot contact you for clarification, EPA may not be able to consider your comment. Electronic files should avoid the use of special characters, any form of encryption, and be free of any defects or viruses. For additional instructions on submitting comments, go to Section I(B) of the SUPPLEMENTARY INFORMATION section of this document.

Docket: All documents in the electronic docket are listed in the RME index at http://www.epa.gov/​rmepub/​. Although listed in the index, some information is not publicly available, i.e., CBI or other information the disclosure of which is restricted by statute. Publicly available docket materials are available either electronically in RME or in hard copy at Environmental Protection Agency, Region 5, Air and Radiation Division, 77 West Jackson Boulevard, Chicago, Start Printed Page 60038Illinois 60604. Please telephone Matt Rau at (312) 886-6524 before visiting the Region 5 Office.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Matt Rau, Environmental Engineer, Criteria Pollutant Section, Air Programs Branch (AR-18J), USEPA, Region 5, 77 West Jackson Boulevard, Chicago, Illinois 60604, (312) 886-6524. Rau.matthew@epa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

I. General Information

A. Does This Action Apply to Me?

B. What Should I Consider as I Prepare My Comments for EPA?

II. What Action Is EPA Taking Today?

III. Where Can I Find More Information About This Proposal and the Corresponding Direct Final Rule?

I. General Information

A. Does This Action Apply to Me?

This action applies to a single source, Serigraph, Incorporated of Washington County, Wisconsin.

B. What Should I Consider as I Prepare My Comments for EPA?

1. Submitting CBI. Do not submit CBI to EPA through RME, regulations.gov or e-mail. Clearly mark the part or all of the information that you claim to be CBI. For CBI information in a disk or CD ROM that you mail to EPA, mark the outside of the disk or CD ROM as CBI and then identify electronically within the disk or CD ROM the specific information that is claimed as CBI. In addition to one complete version of the comment that includes information claimed as CBI, a copy of the comment that does not contain the information claimed as CBI must be submitted for inclusion in the public docket. Information so marked will not be disclosed except in accordance with procedures set forth in 40 CFR part 2.

2. Tips for Preparing Your Comments. When submitting comments, remember to:

a. Identify the rulemaking by docket number and other identifying information (subject heading, Federal Register date and page number).

b. Follow directions—The agency may ask you to respond to specific questions or organize comments by referencing a Code of Federal Regulations (CFR) part or section number.

c. Explain why you agree or disagree; suggest alternatives and substitute language for your requested changes.

d. Describe any assumptions and provide any technical information and/or data that you used.

e. If you estimate potential costs or burdens, explain how you arrived at your estimate in sufficient detail to allow for it to be reproduced.

f. Provide specific examples to illustrate your concerns, and suggest alternatives.

g. Explain your views as clearly as possible, avoiding the use of profanity or personal threats.

h. Make sure to submit your comments by the comment period deadline identified.

II. What Action Is EPA Taking Today?

EPA is proposing to approve a revision to the Wisconsin VOC SIP for Serigraph. The revision approves Serigraph's use of a biofilter to control VOC emissions from several lines in Plant 2 at its facility. This is an alternative to the controls listed in the SIP. Section NR 422.04(2)(d) of the Wisconsin Administrative Code allows an alternative control method that is demonstrated to reliably control emissions to a level at or below the applicable SIP limit and is approved by the Wisconsin Department of Natural Resources. The biofilter will reliably control VOC emissions at a level in line with other control techniques for surface printing facilities. An eighty percent overall control efficiency for VOC emissions is required for a control device. Overall control efficiency includes both capture and destruction efficiencies. Plant 2 is designed as a PTE ensuring all the emissions are captured and exhausted into the biofilter. Serigraph has operated its biofilter since May 1997. An average of 54 tons of VOC emissions are vented to the biofilter each year. The average exhaust from the biofilter is about 8 tons of VOC per year. This comfortably exceeds the control requirement.

III. Where Can I Find More Information About This Proposal and the Corresponding Direct Final Rule?

For additional information, see the Direct Final Rule which is located in the Rules section of this Federal Register. Copies of the request and the EPA's analysis are available electronically at RME or in hard copy at the above address. Please telephone Matt Rau at (312) 886-6524 before visiting the Region 5 Office.

Start Signature

Dated: September 15, 2005.

Bharat Mathur,

Acting Regional Administrator, Region 5.

End Signature End Supplemental Information

[FR Doc. 05-20613 Filed 10-13-05; 8:45 am]

BILLING CODE 6560-50-P