Skip to Content

Correction

Training Standards for Shaft and Slope Construction Workers at Underground Mines and Surface Areas of Underground Mines

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble Start Printed Page 3613 End Preamble Start Supplemental Information

Correction

In rule document 05-24624 beginning on page 77716 in the issue of Friday, December 30, 2005, make the following corrections:

1. On page 77718, in Table 2, in the third column, in the first and second lines of the column heading, “UG & ≤ surf.” should read “UG & surf.”.

2. On page 77721, in the first column, in the second full paragraph, in the first line, “Shaft and slope workers” should read, ““Shaft and slope workers”.

End Supplemental Information Start Preamble End Preamble Start Supplemental Information

Correction

In rule document 06-413 beginning on page 2897 in the issue of Wednesday, January 18, 2006, make the following correction:

On page 2897, in the second column, footnote 1 at the bottom of the column should read “1 As pertinent to this rule, a CMV is a motor vehicle used in commerce that is designed to transport at least 16 passengers, including the driver. 49 U.S.C. 31301(4)(B)”.

End Supplemental Information

[FR Doc. C5-24624 Filed 1-20-06; 8:45 am]

BILLING CODE 1505-01-D

[FR Doc. C6-413 Filed 1-20-06; 8:45 am]

BILLING CODE 1505-01-D