U.S. Small Business Administration.
Notice of denial to waive the Nonmanufacturer Rule for Forklifts Manufacturing.
The U.S. Small Business Administration (SBA) is denying a request for a waiver of the Nonmanufacturer Rule for Forklifts Manufacturing based on our recent discovery of a small business manufacturer for this class of products. Denying this waiver will require recipients of contracts set aside for small businesses, service-disabled veteran-owned small businesses, or SBA's 8(a) Business Development Program to provide the products of small business manufacturers or processors on such contracts.
This notice of denial is effective March 13, 2006.Start Further Info
FOR FURTHER INFORMATI0N CONTACT:
Edith Butler, Program Analyst, by telephone at (202) 619-0422; by FAX at (202) 481-1788; or by e-mail at email@example.com.End Further Info End Preamble Start Supplemental Information
Section 8(a)(17) of the Small Business Act (Act), Start Printed Page 963115 U.S.C. 637(a)(17), requires that recipients of Federal contracts set aside for small businesses, service-disabled veteran-owned small businesses, or SBA's 8(a) Business Development Program provide the product of a small business manufacturer or processor, if the recipient is other than the actual manufacturer or processor of the product. This requirement is commonly referred to as the Nonmanufacturer Rule.
The SBA regulations imposing this requirement are found at 13 CFR 121.406(b). Section 8(a)(17)(b)(iv) of the Act authorizes SBA to waive the Nonmanufacturer Rule for any “class of products” for which there are no small business manufacturers or processors available to participate in the Federal market.
As implemented in SBA's regulations at 13 CFR 121.1202 (c), in order to be considered available to participate in the Federal market for a class of products, a small business manufacturer must have submitted a proposal for a contract solicitation or received a contract from the Federal government within the last 24 months. The SBA defines “class of products” based on a six digit coding system. The coding system is the Office of Management and Budget North American Industry Classification System (NAICS).
The SBA received a request on October 3, 2005 to waive the Nonmanufacturer Rule for Forklifts Manufacturing. In response, on November 3, 2005, SBA published in the Federal Register a notice of intent to waive the Nonmanufacturer Rule for Forklifts Manufacturing. SBA explained in the notice that it was soliciting comments and sources of small business manufacturers of this class of products. In response to that November 3, 2005 notice, SBA received a comment from a small business manufacturer indicating that it has furnished this product to the Federal government. Accordingly, based on the available information, SBA has determined that there is a small business manufacturer of this class of products, and, is therefore denying the class waiver of the Nonmanufacturer Rule for Forklifts Manufacturing, NAICS 333924.Start Signature
Dated: February 14, 2006.
Karen C. Hontz,
Associate Administrator for Government Contracting.
[FR Doc. E6-2653 Filed 2-23-06; 8:45 am]
BILLING CODE 8025-01-P