Federal Aviation Administration (FAA), Department of Transportation (DOT).
Notice of proposed rulemaking (NPRM).
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an airworthiness authority of another country to identify and correct an unsafe condition on an aviation product. The proposed AD would require actions that are intended to address an unsafe condition described in the MCAI.
We must receive comments on this proposed AD by September 1, 2006.
Use one of the following addresses to comment on this proposed AD:
- DOT Docket Web site: Go to http://dms.dot.gov and follow the instructions for sending your comments electronically.
- Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
- Mail: Docket Management Facility; U.S. Department of Transportation, 400 Seventh Street, SW., Nassif Building, Room PL-401, Washington, DC 20590.
- Fax: (202) 493-2251.
- Hand delivery: Room PL-401 on the plaza level of the Nassif Building, 400 Seventh Street, SW., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in the proposed AD, contact EADS SOCATA, Direction des Services, 65921 Tarbes Cedex 9, France; telephone: 33 (0)5 62.41.73.00; fax: 33 (0)5 220.127.116.11; or SOCATA AIRCRAFT, INC., North Perry Airport, 7501 Airport Road, Pembroke Pines, Florida 33023; telephone: (954) 893-1400; fax: (954) 964-4141.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Gunnar Berg, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4141; facsimile: (816) 329-4090.End Further Info End Preamble Start Supplemental Information
Streamlined Issuance of AD
The FAA is implementing a new process for streamlining the issuance of ADs related to MCAI. We are prototyping this process and specifically request your comments on its use. You can find more information in FAA draft Order 8040.2, “Airworthiness Directive Process for Mandatory Continuing Airworthiness Information” which is currently open for comments at http://www.faa.gov/aircraft/draft_docs. This streamlined process will allow us to adopt MCAI safety requirements in a more efficient manner and will reduce safety risks to the public.
This process continues to follow all existing AD issuance processes to meet legal, economic, Administrative Procedure Act, and Federal Register requirements. We also continue to follow our technical decision-making processes in all aspects to meet our responsibilities to determine and correct unsafe conditions on U.S.-certificated products.
This proposed AD references the MCAI and related service information that we considered in forming the engineering basis to correct the unsafe condition. The proposed AD contains text copied from the MCAI and for this reason might not follow our plain language principles.
The comment period for this proposed AD is open for 30 days to allow time for comment on both the process and the AD content. In the future, ADs using this process will have a 15-day comment period. The comment period is reduced because the airworthiness authority and manufacturer have already published the documents on which we based our decision, making a longer comment period unnecessary. Start Printed Page 43677
We invite you to send any written data, views, or arguments regarding this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include the docket number, “FAA-2006-25332; Directorate Identifier 2006-CE-40-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We are also inviting comments, views, or arguments on the new MCAI process. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.
We will post all comments we receive, without change, to http://dms.dot.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive concerning this proposed AD.
The Direction Générale de L'Aviation Civile (DGAC), which is the airworthiness authority for France, has issued AD No. F-2005-034, Issue date: February 16, 2005, (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states that the aircraft manufacturer has determined that unsatisfactory initial elevator trim actuator greasing may lead to the icing of the elevator trim and generate an untrimmed nose-up attitude after an autopilot disconnection. If not corrected, this condition could result in pitch-up, out-of-trim condition when the autopilot is disconnected. You may obtain further information by examining the MCAI in the docket.
Relevant Service Information
EADS SOCATA has issued TBM Aircraft Mandatory Service Bulletin SB70-124, Amendment 1, ATA No. 27, dated January 2005. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of the Proposed AD
This product is manufactured outside the United States and is type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral agreement. Pursuant to this bilateral airworthiness agreement, the State of Design's airworthiness authority has notified us of the unsafe condition described in the MCAI and service information referenced above. We have examined the airworthiness authority's findings, evaluated all pertinent information, and determined an unsafe condition exists and is likely to exist or develop on all products of this type design. We are issuing this proposed AD to correct the unsafe condition.
Differences Between the Proposed AD and the MCAI or Service Information
We have reviewed the MCAI and related service information and, in general, agree with their substance. But we might have found it necessary to use different words from those in the MCAI to ensure the AD is clear for U.S. operators and is enforceable in a U.S. court of law. In making these changes, we do not intend to differ substantively from the information provided in the MCAI and related service information.
We might also have proposed different actions in this AD from those in the MCAI in order to follow FAA policies. Any such differences are described in a separate paragraph of the proposed AD. These proposed requirements, if ultimately adopted, will take precedence over the actions copied from the MCAI.
Costs of Compliance
Based on the service information, we estimate that this proposed AD would affect about 256 products of U.S. registry. We also estimate that it would take about 1 work-hour per product to do the action and that the average labor rate is $80 per work-hour. Required parts would cost about $8 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these costs. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $22,528, or $88 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
Examining the AD Docket
You may examine the AD docket that contains the proposed AD, the regulatory evaluation, any comments received, and other information on the Internet at http://dms.dot.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Office (telephone (800) 647-5227) is located at the street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.Start List of Subjects
List of Subjects in 14 CFR Part 39End List of Subjects
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend 14 CFR part 39 as follows:Start Part
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. The FAA amends § 39.13 by adding the following new AD:
EADS SOCATA: FAA-2006-25332; Directorate Identifier 2006-CE-40-AD
Comments Due Date
(a) We must receive comments on this proposed airworthiness directive (AD) by September 1, 2006.
(c) This AD applies to the following Model TBM 700 airplanes that are certificated in any U.S. category: serial numbers 1 through 32, 34, 36 through 69, 71 through 76, 79, 81 through 92, 96 through 98, 101, 102, 107 through 109, 112 through 114, 116, 118 through 124, 126 through 130, 132 through 135, 137, 138, 140 through 145, 148 through 155, 157, 158, 161 through 268, and 270 through 304.
(d) The mandatory continuing airworthiness information (MCAI) states that the aircraft manufacturer has determined that unsatisfactory initial elevator trim actuator greasing may lead to the icing of the elevator trim and generate an untrimmed nose-up attitude after an autopilot disconnection. If not corrected, this condition could result in pitch-up, out-of-trim condition when the autopilot is disconnected.
Actions and Compliance
(e) Unless already done, do the following except as stated in paragraph (f) below.
(1) Within the next 25 hours time-in-service after the effective date of this AD, lubricate the elevator trim tab actuator rods without removal.
(2) Do the action required in paragraph (e)(1) of the AD following EADS SOCATA TBM Aircraft Mandatory Service Bulletin SB70-124, Amendment 1, ATA No. 27, dated January 2005.
FAA AD Differences
Other FAA AD Provisions
(g) The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Staff, FAA, Small Airplane Directorate, ATTN: Gunnar Berg, Aerospace Engineer, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4141; facsimile: (816) 329-4090, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19.
(2) Return to Airworthiness: When complying with this AD, perform FAA-approved corrective actions before returning the product to an airworthy condition.
(3) Reporting Requirements: For any reporting requirement in this AD, under the provisions of the Paperwork Reduction Act, the Office of Management and Budget (OMB) has approved the information collection requirements and has assigned OMB Control Number 2120-0056.
(h) This AD is related to MCAI French AD No. F-2005-034, Issue date: February 16, 2005, which references EADS SOCATA TBM Aircraft Mandatory Service Bulletin SB70-124, Amendment 1, ATA No. 27, dated January 2005.
Issued in Kansas City, Missouri, on July 25, 2006.
James E. Jackson,
Acting Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. E6-12419 Filed 8-1-06; 8:45 am]
BILLING CODE 4910-13-P