Federal Aviation Administration (FAA), Department of Transportation (DOT).
Notice of proposed rulemaking (NPRM).
The FAA proposes to adopt a new airworthiness directive (AD) for all Boeing Model 767 airplanes. This proposed AD would require a one-time inspection to determine the material of the forward and aft gray water drain masts. For airplanes having composite gray water drain masts, this proposed AD would also require installation of a ground bracket and a copper bonding jumper between a ground bracket and the clamp on the tube of the forward and aft gray water composite drain masts. This proposed AD results from a report of charred insulation blankets and burned wires around the forward gray water composite drain mast found during an inspection of the forward cargo compartment. We are proposing this AD to prevent a fire near a composite drain mast and possible disruption of the electrical power system caused by a lightning strike on a composite drain mast, which could result in the loss of several functions essential for safe flight.
We must receive comments on this proposed AD by October 15, 2007.
Use one of the following addresses to submit comments on this proposed AD.
- DOT Docket Web site: Go to http://dms.dot.gov and follow the instructions for sending your comments electronically.
- Government-wide rulemaking Web site: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
- Mail: U.S. Department of Transportation, Docket Operations, M-Start Printed Page 5027730, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue, SE., Washington, DC 20590.
- Fax: (202) 493-2251.
- Hand Delivery: Room W12-140 on the ground floor of the West Building, 1200 New Jersey Avenue, SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
Contact Boeing Commercial Airplanes, P.O. Box 3707, Seattle, Washington 98124-2207, for the service information identified in this proposed AD.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Marcia Smith, Aerospace Engineer, Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 917-6484; fax (425) 917-6590.End Further Info End Preamble Start Supplemental Information
We invite you to submit any relevant written data, views, or arguments regarding this proposed AD. Send your comments to an address listed in the ADDRESSES section. Include the docket number “FAA-2007-29063; Directorate Identifier 2007-NM-049-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the proposed AD. We will consider all comments received by the closing date and may amend the proposed AD in light of those comments.
We will post all comments we receive, without change, to http://dms.dot.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of that Web site, anyone can find and read the comments in any of our dockets, including the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78), or you may visit http://dms.dot.gov.
Examining the Docket
You may examine the AD docket on the Internet at http://dms.dot.gov, or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The Docket Operations office (telephone (800) 647-5527) is located on the ground floor of the West Building at the DOT street address stated in the ADDRESSES section. Comments will be available in the AD docket shortly after the Docket Management System receives them.
We have received a report indicating that, during an inspection of the forward cargo compartment on a Model 767-300F airplane, an operator found charred insulation blankets and burned wires around the forward gray water composite drain mast. Additional charring on the insulation blankets was noticed several feet away along the routing of the drain mast's ground wire and power wires. Analysis of the damaged parts revealed that a lightning strike on the composite drain mast caused the damage to the wires and insulation blankets. This condition, if not corrected, could cause disruption of electrical power and fire and heat damage to equipment in the event of a lightning strike on the composite drain mast, which could result in the potential loss of several functions essential for safe flight.
A design review of the gray water composite drain mast installation on Model 737, 757, 767, and 777 airplanes revealed that the installation of a heavier bonding jumper is necessary to provide adequate lightning protection to the gray water composite drain mast installation. We are currently considering additional rulemaking to address the identified unsafe condition on Model 737, 757, and 777 airplanes.
Relevant Service Information
We have reviewed Boeing Special Attention Service Bulletin 767-30-0047, dated January 25, 2007 (for Boeing Model 767-200, -300, and -300F series airplanes); and Boeing Special Attention Service Bulletin 767-30-0048, dated January 25, 2007 (for Boeing Model 767-400ER series airplanes). The service bulletins describe procedures for installing a new ground bracket and a 135-ampere copper bonding jumper between the ground bracket and the clamp on the tube of the forward and aft gray water composite drain masts. Accomplishing the actions specified in the service information is intended to adequately address the unsafe condition.
FAA's Determination and Requirements of the Proposed AD
We have evaluated all pertinent information and identified an unsafe condition that is likely to exist or develop on other airplanes of this same type design. For this reason, we are proposing this AD, which would require accomplishing the actions specified in the service information described previously.
Costs of Compliance
There are about 86 airplanes of the affected design in the worldwide fleet. The following table provides the estimated costs for U.S. operators to comply with this proposed AD.
|Action||Work hours||Average labor rate per hour||Parts||Cost per airplane||Number of U.S.-registered airplanes||Fleet cost|
|Inspection to determine gray water drain mast material||1||$80||None||$80||41||$3,280.|
|Installation of bonding jumper||4||80||Up to $654||Up to $974||Up to 41||Up to $39,934.|
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition Start Printed Page 50278that is likely to exist or develop on products identified in this rulemaking action.
We have determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that the proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket. See the ADDRESSES section for a location to examine the regulatory evaluation.Start List of Subjects
List of Subjects in 14 CFR Part 39End List of Subjects
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:Start Part
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. The Federal Aviation Administration (FAA) amends § 39.13 by adding the following new airworthiness directive (AD):
Boeing: Docket No. FAA-2007-29063; Directorate Identifier 2007-NM-049-AD.
Comments Due Date
(a) The FAA must receive comments on this AD action by October 15, 2007.
(c) This AD applies to all Boeing Model 767-200, -300, -300F, and -400ER series airplanes, certificated in any category.
(d) This AD results from a report of charred insulation blankets and burned wires around the forward gray water composite drain mast found during an inspection of the forward cargo compartment. We are issuing this AD to prevent a fire near a composite drain mast and possible disruption of the electrical power system caused by a lightning strike on a composite drain mast, which could result in the loss of several functions essential for safe flight.
(e) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
Inspection To Determine Material of Gray Water Drain Mast
(f) Within 60 months after the effective date of this AD, inspect the forward and aft gray water drain masts to determine whether the drain mast is made of aluminum or composite. A review of airplane maintenance records is acceptable in lieu of this inspection if the material of the forward and aft gray water drain masts can be conclusively determined from that review.
(1) For any aluminum gray water drain mast identified during the inspection or records check required by paragraph (f) of this AD, no further action is required by this AD for that drain mast only.
(2) For any composite gray water drain mast identified during the inspection or records check required by paragraph (f) of this AD, do the actions specified in paragraph (g) of this AD.
Installation of New Ground Bracket and Bonding Jumper
(g) For any composite gray water drain mast identified during the inspection or records check required by paragraph (f) of this AD: Within 60 months after the effective date of this AD, install a 135-ampere copper bonding jumper between the new ground bracket and the clamp on the tube of the gray water composite drain mast, in accordance with the Accomplishment Instructions of Boeing Special Attention Service Bulletin 767-30-0047, dated January 25, 2007 (for Model 767-200, -300, and -300F series airplanes); and Boeing Special Attention Service Bulletin 767-30-0048, dated January 25, 2007 (for Model 767-400ER series airplanes).
Alternative Methods of Compliance (AMOCs)
(h)(1) The Manager, Seattle Aircraft Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested in accordance with the procedures found in 14 CFR 39.19.
(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.
Issued in Renton, Washington, on August 17, 2007.
Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. E7-17294 Filed 8-30-07; 8:45 am]
BILLING CODE 4910-13-P