Occupational Safety and Health Administration (OSHA), Labor.
Request for public comment.
OSHA solicits comments concerning its request for an extension of the information collection requirements contained in 29 CFR 1926.652, Requirements for Protective Systems.
Comments must be submitted (postmarked, sent, or received) by April 14, 2008.
Electronically: You may submit comments and attachments electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal. Follow the instructions online for submitting comments.
Facsimile: If your comments, including attachments, are not longer than 10 pages, you may fax them to the OSHA Docket Office at (202) 693-1648.
Mail, hand delivery, express mail, messenger, or courier service: When using this method, you must submit three copies of your comments and attachments to the OSHA Docket Office, OSHA Docket No. OSHA-2008-0008, U.S. Department of Labor, Occupational Safety and Health Administration, Room N-2625, 200 Constitution Avenue, NW., Washington, DC 20210. Deliveries (hand, express mail, messenger, and courier service) are accepted during the Department of Labor's and Docket Office's normal business hours, 8:15 a.m. to 4:45 p.m., e.t.
Instructions: All submissions must include the Agency name and OSHA docket number for the ICR (OSHA-2008-0008). All comments, including any personal information you provide, are placed in the public docket without change, and may be made available online at http://www.regulations.gov. For further information on submitting comments see the “Public Participation” heading in the section of this notice titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the docket, go to http://www.regulations.gov or the OSHA Docket Office at the address above. All documents in the docket (including this Federal Register notice) are listed in the http://www.regulations.gov index; however, some information (e.g., copyrighted material) is not publicly available to read or download through the Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. You may also contact Michael Buchet at the address below to obtain a copy of the ICR.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Michael Buchet, Directorate of Construction, OSHA, U.S. Department of Labor, Room N-3468, 200 Constitution Avenue, NW., Washington, DC 20210; telephone (202) 693-2020.End Further Info End Preamble Start Supplemental Information
The Department of Labor, as part of its continuing effort to reduce paperwork and respondent (i.e., employer) burden, conducts a preclearance consultation program to provide the public with an opportunity to comment on proposed and continuing information collection requirements in accordance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3506(c)(2)(A)). This program ensures that information is in the desired format, reporting burden (time and costs) is minimal, collection instruments are clearly understood, and OSHA's estimate of the information collection burden is accurate. The Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C. 651, et seq.) authorizes information collection by employers as necessary or appropriate for enforcement of the Act or for developing information regarding the causes and prevention of occupational injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also requires that OSHA obtain such information with minimum burden upon employers, especially those operating small businesses, and to reduce to the maximum extent feasible unnecessary duplication of efforts in obtaining information (29 U.S.C. 657).
Paragraphs (b) and (c) of § 1926.652 (“Requirements for Protective Systems”; the “Standard”) contain paperwork requirements that impose burden hours or costs on employers. These paragraphs require employers to use protective systems to prevent cave-ins during excavation work; these systems include sloping the side of the trench, benching the soil away from the excavation, or using a support system or shield (such as a trench box). The Standard specifies allowable configuration and slopes for excavations, and provides appendices to assist employers in designing protective systems. However, paragraphs (b)(3) and (b)(4) of the Standard permit employers to design sloping or benching systems based on tabulated data (Option 1), or to use a design approved by a registered professional engineer (Option 2).
Under Option 1, employers must provide the tabulated data in a written form that also identifies the registered professional engineer who approved the data and the parameters used to select the sloping or benching system drawn from the data, as well as the limitations of the data (including the magnitude and configuration of slopes determined to be safe); the document must also provide any explanatory information necessary to select the correct benching system based on the data. Option 2 Start Printed Page 8375requires employers to develop a written design approved by a registered professional engineer. The design information must include the magnitude and configuration of the slopes determined to be safe, and the identity of the registered professional engineer who approved the design.
Paragraphs (c)(2), (c)(3), and (c)(4) allow employers to design support systems, shield systems, and other protective systems based on tabulated data provided by a system manufacturer (Option 3) or obtained from other sources and approved by a registered professional engineer (Option 4); they can also use a design approved by a registered professional engineer (Option 5). If they select Option 3, employers must complete a written form that provides the manufacturer's specifications, recommendations, and limitations, as well as any deviations approved by the manufacturer. The paperwork requirements of Option 4 are the same as for Option 1. Option 5 requires a written form that provides a plan indicting the sizes, types, and configurations of the materials used in the protective system and the identity of the registered professional engineer who approved the design.
Each of these provisions requires employers to maintain a copy of the documents described in these options at the jobsite during construction. After construction is complete, employers may store the documents off-site provided they make them available to an OSHA compliance officer on request. These documents provide both the employer and the compliance officer with information needed to determine if the selection and design of a protective system are appropriate to the excavation work, thereby assuring employees of maximum protection against cave-ins.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
- Whether the proposed information collection requirements are necessary for the proper performance of the Agency's functions, including whether the information is useful;
- The accuracy of OSHA's estimate of the burden (time and costs) of the information collection requirements, including the validity of the methodology and assumptions used;
- The quality, utility, and clarity of the information collected; and
- Ways to minimize the burden on employers who must comply; for example, by using automated or other technological information collection and transmission techniques.
III. Proposed Actions
The Agency is requesting that OMB extend its approval of the information collection requirements contained in 29 CFR 1926.652, Requirements for Protective Systems. The Agency will summarize the comments submitted in response to this notice and will include this summary in the request to OMB to extend the approval of the information collection requirements contained in the Standard.
Type of Review: Extension of currently approved information collection requirements.
Title: Design of Cave-in Protection System.
OMB Number: 1218-0137.
Affected Public: Business or other for-profits.
Number of Respondents: 20,000.
Frequency of Response: On occasion.
Total Responses: 20,000.
Average Time per Response: Two hours to obtain information on the design of cave-in protection systems.
Estimated Total Burden Hours: 20,022 hours.
Estimated Cost (Operation and Maintenance): $815,400.
IV. Public Participation—Submission of Comments on this Notice and Internet Access to Comments and Submissions
You may submit comments in response to this document as follows: (1) Electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal; (2) by facsimile (FAX); or (3) by hard copy. All comments, attachments, and other material must identify the Agency name and the OSHA docket number for the ICR (Docket No. OSHA-2008-0008). You may supplement electronic submissions by uploading document files electronically. If you wish to mail additional materials in reference to an electronic or facsimile submission, you must submit them to the OSHA Docket Office (see the section of this notice titled ADDRESSES). The additional materials must clearly identify your electronic comments by your name, date, and the docket number so the Agency can attach them to your comments.
Because of security procedures, the use of regular mail may cause a significant delay in the receipt of comments. For information about security procedures concerning the delivery of materials by hand, express delivery, messenger, or courier service, please contact the OSHA Docket Office at (202) 693-2350 (TTY (877) 889-5627).
Comments and submissions are posted without change at http://www.regulations.gov. Therefore, OSHA cautions commenters about submitting personal information such as social security numbers and date of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted material) is not publicly available to read or download through this Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. Information on using the http://www.regulations.gov Web site to submit comments and access the docket is available at the Web site's “User Tips” link. Contact the OSHA Docket Office for information about materials not available through the Web site, and for assistance in using the Internet to locate docket submissions.
V. Authority and Signature
Edwin G. Foulke, Jr., Assistant Secretary of Labor for Occupational Safety and Health, directed the preparation of this notice. The authority for this notice is the Paperwork Reduction Act of 1995 (44 U.S.C. 3506, et seq.) and Secretary of Labor's Order No. 5-2007 (72 FR 31159).Start Signature
Signed at Washington, DC, on February 7, 2008.
Edwin G. Foulke, Jr.,
Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. E8-2624 Filed 2-12-08; 8:45 am]
BILLING CODE 4510-26-P