Skip to Content

Notice

Small Business Size Standards: Waiver of the Nonmanufacturer Rule

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

U.S. Small Business Administration.

ACTION:

Notice of waiver of the Nonmanufacturer Rule for Paper Products Manufacturing product number 8540.

SUMMARY:

The U.S. Small Business Administration (SBA) is granting a waiver of the Nonmanufacturer Rule for Paper Products Manufacturing.

The basis for waiver is that no small business manufacturers are supplying this class of product to the Federal government. The effect of a waiver would be to allow otherwise qualified regular dealers to supply the products of any domestic manufacturer on a Federal contract set aside for small businesses; service-disabled veteran-owned small businesses or SBA's 8(a) Business Development Program.

DATE:

This waiver is effective May 16, 2008.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Pamela M. McClam, Program Analyst, by telephone at (202) 205-7408; by FAX at (202) 481-4783; or by e-mail at Pamela.McClam@sba.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Section 8(a)(17) of the Small Business Act, (Act) 15 U.S.C. 637(a)(17), requires that recipients of Federal contracts set aside for small businesses, service-disabled veteran-owned small businesses, or SBA's 8(a) Business Development Program provide the product of a small business manufacturer or processor, if the recipient is other than the actual manufacturer or processor of the product. This requirement is commonly referred to as the Nonmanufacturer Rule. The SBA regulations imposing this requirement are found at 13 CFR 121.406 (b). Section 8(a)(17)(b)(iv) of the Act authorizes SBA to waive the Nonmanufacturer Rule for any “class of products” for which there are no small business manufacturers or processors available to participate in the Federal market.

As implemented in SBA's regulations at 13 CFR 121.1202 (c), in order to be considered available to participate in the Federal market for a class of products, a small business manufacturer must have submitted a proposal for a contract solicitation or received a contract from the Federal government within the last 24 months. The SBA defines “class of products” based on six digit coding systems. The first coding system is the Office of Management and Budget North American Industry Classification System (NAICS). The second is the Product and Service Code required as a data entry field by the Federal Procurement Data System.

The SBA received a request on February 22, 2008, to waive the Nonmanufacturer Rule for Paper Products Manufacturing.

In response, on April 8, 2008, SBA published in the Federal Register a notice of intent to waive the Nonmanufacturer Rule for Paper Products Manufacturing. SBA explained in the notice that it was soliciting comments and sources of small business manufacturers of this class of products. No comments were received in response to this notice. SBA has determined that there are no small business manufacturers of this class of products, and is therefore granting the waiver of the Nonmanufacturer Rule for Paper Products Manufacturing. NAICS code 326111 product number 8540.

Start Authority

Authority: 15 U.S.C. 637(a)(17).

End Authority Start Signature

Dated: April 25, 2008.

Linda S. Korbol,

Acting Director for Government Contracting.

End Signature End Supplemental Information

[FR Doc. E8-9550 Filed 4-30-08; 8:45 am]

BILLING CODE 8025-01-P