This site displays a prototype of a “Web 2.0” version of the daily Federal Register. It is not an official legal edition of the Federal Register, and does not replace the official print version or the official electronic version on GPO’s govinfo.gov.
The documents posted on this site are XML renditions of published Federal Register documents. Each document posted on the site includes a link to the corresponding official PDF file on govinfo.gov. This prototype edition of the daily Federal Register on FederalRegister.gov will remain an unofficial informational resource until the Administrative Committee of the Federal Register (ACFR) issues a regulation granting it official legal status. For complete information about, and access to, our official publications and services, go to About the Federal Register on NARA's archives.gov.
The OFR/GPO partnership is committed to presenting accurate and reliable regulatory information on FederalRegister.gov with the objective of establishing the XML-based Federal Register as an ACFR-sanctioned publication in the future. While every effort has been made to ensure that the material on FederalRegister.gov is accurately displayed, consistent with the official SGML-based PDF version on govinfo.gov, those relying on it for legal research should verify their results against an official edition of the Federal Register. Until the ACFR grants it official status, the XML rendition of the daily Federal Register on FederalRegister.gov does not provide legal notice to the public or judicial notice to the courts.
Occupational Safety and Health Administration (OSHA), Labor.
Request for public comment.
OSHA solicits comments concerning its proposal to extend OMB approval of the information collection requirements contained in the Standard on Servicing Multi-Piece and Single Piece Rim Wheels (29 CFR 1910.177). The paperwork provisions of the Standard include a requirement that the manufacturer or a Registered Professional Engineer certify that repaired restraining devices and barriers meet the strength requirements specified in the Standard, and a requirement that defective wheels and wheel components be marked or tagged.
Comments must be submitted (postmarked, sent, or received) by October 3, 2008.
Electronically: You may submit comments and attachments electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal. Follow the instructions online for submitting comments.
Facsimile: If your comments, including attachments, are not longer than 10 pages, you may fax them to the OSHA Docket Office at (202) 693-1648.
Mail, hand delivery, express mail, messenger, or courier service: When using this method, you must submit three copies of your comments and attachments to the OSHA Docket Office, Docket No. OSHA-2008-0025, U.S. Department of Labor, Occupational Safety and Health Administration, Room N-2625, 200 Constitution Avenue, NW., Washington, DC 20210. Deliveries (hand, express mail, messenger, and courier service) are accepted during the Department of Labor's and Docket Office's normal business hours, 8:15 a.m. to 4:45 p.m., e.t.
Instructions: All submissions must include the Agency name and OSHA docket number for the ICR (OSHA-2008-0025). All comments, including any personal information you provide, are placed in the public docket without change, and may be made available online at http://www.regulations.gov. For further information on submitting comments see the “Public Participation” heading in the section of this notice titled SUPPLEMENTARY INFORMATION.
Docket: To read or download comments or other material in the docket, go to http://www.regulations.gov or the OSHA Docket Office at the address above. All documents in the docket (including this Federal Register notice) are listed in the http://www.regulations.gov index; however, some information (e.g., copyrighted material) is not publicly available to read or download through the Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. You may also contact Theda Kenney at the address below to obtain a copy of the ICR.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Theda Kenney or Todd Owen, Directorate of Standards and Guidance, OSHA, U.S. Department of Labor, Room N-3609, 200 Constitution Avenue, NW., Washington, DC 20210; telephone (202) 693-2222.End Further Info End Preamble Start Supplemental Information
The Department of Labor, as part of its continuing efforts to reduce paperwork and respondent (i.e., employer) burden, conducts a preclearance consultation program to provide the public with an opportunity to comment on proposed and continuing information collection requirements in accordance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3506(c)(2)(A)). This program ensures that information is in the desired format, reporting burden (time and costs) is minimal, collection instruments are clearly understood, and OSHA's estimate of the information collection burden is accurate. The Occupational Safety and Health Act of 1970 (the OSH Act) (29 U.S.C. 651 et seq. ) authorizes information collection by employers as necessary or appropriate for enforcement of the Act or for developing information regarding the causes and prevention of occupational injuries, illnesses, and accidents (29 U.S.C. 657). The OSH Act also requires that OSHA obtain such information with minimum burden upon employers, especially those operating small businesses, and to reduce to the maximum extent feasible unnecessary duplication of efforts in obtaining information (29 U.S.C. 657).
Certification of repair (1910.177(d)(3)(iv)). This paragraph Start Printed Page 45251requires that when restraining devices and barriers are removed from service because they are defective, they shall not be returned to service until they are repaired and reinspected. If the repair is structural, the manufacturer or a Registered Professional Engineer must certify that the strength requirements specified in (d)(3)(i) of the Standard have been met.
The certification records are used to assure that equipment has been properly repaired. The certification records also provide the most efficient means for OSHA compliance officers to determine that an employer is complying with the Standard.
Marking or tagging of wheel components (1910.177(e)(2)). This paragraph requires that defective wheels and wheel components “be marked or tagged unserviceable and removed from the service area.” Under this requirement, OSHA is providing employers with sufficient information from which they can derive the wording to use in marking the object or constructing a tag. Therefore, this provision imposes no paperwork burden because it falls within the portion of 5 CFR 1320(c)(2) that states, “The public disclosure of information originally supplied by the Federal government to the recipient for the purpose of disclosure to the public is not included within this definition [of ‘collection of information’]”.
II. Special Issues for Comment
OSHA has a particular interest in comments on the following issues:
- Whether the proposed information collection requirements are necessary for the proper performance of the Agency's functions, including whether the information is useful;
- The accuracy of OSHA's estimate of the burden (time and costs) of the information collection requirements, including the validity of the methodology and assumptions used;
- The quality, utility, and clarity of the information collected; and
- Ways to minimize the burden on employers who must comply; for example, by using automated or other technological information collection and transmission techniques.
III. Proposed Actions
OSHA is requesting that OMB extend its approval of the information collection requirements contained in the Standard on Servicing Multi-Piece and Single Piece Rim Wheels (29 CFR 1910.177). OSHA is proposing to retain its current burden hour estimate of one (1) hour. The Agency will summarize the comments submitted in response to this notice and will include this summary in the request to OMB.
Type of Review: Extension of a currently approved collection.
Title: Servicing Multi-Piece and Single Piece Rim Wheels (29 CFR 1910.177).
OMB Number: 1218-0219.
Affected Public: Business or other for-profits; Not-for-profit organizations; Federal Government; State, Local, or Tribal Government.
Number of Respondents: 80.
Frequency of Response: On occasion.
Average Time per Response: Three (3) minutes (.05 hour) to maintain a certificate verifying proper repair of a restraining device or barrier and to disclose to an OSHA Compliance Officer.
Estimated Total Burden Hours: 1.
Estimated Cost (Operation and Maintenance): $0.
IV. Public Participation—Submission of Comments on This Notice and Internet Access to Comments and Submissions
You may submit comments in response to this document as follows: (1) Electronically at http://www.regulations.gov, which is the Federal eRulemaking Portal; (2) by facsimile (FAX); or (3) by hard copy. All comments, attachments, and other material must identify the Agency name and the OSHA docket number for the ICR (Docket No. OSHA-2008-0025). You may supplement electronic submissions by uploading document files electronically. If you wish to mail additional materials in reference to an electronic or facsimile submission, you must submit them to the OSHA Docket Office (see the section of this notice titled ADDRESSES). The additional materials must clearly identify your electronic comments by your name, date, and the docket number so the Agency can attach them to your comments.
Because of security procedures, the use of regular mail may cause a significant delay in the receipt of comments. For information about security procedures concerning the delivery of materials by hand, express delivery, messenger, or courier service, please contact the OSHA Docket Office at (202) 693-2350 (TTY (877) 889-5627).
Comments and submissions are posted without change at http: //www.regulations.gov. Therefore, OSHA cautions commenters about submitting personal information such as Social Security numbers and date of birth. Although all submissions are listed in the http://www.regulations.gov index, some information (e.g., copyrighted material) is not publicly available to read or download through this Web site. All submissions, including copyrighted material, are available for inspection and copying at the OSHA Docket Office. Information on using the http://www.regulations.gov Web site to submit comments and access the docket is available at the Web site's “User Tips” link. Contact the OSHA Docket Office for information about materials not available through the Web site, and for assistance in using the Internet to locate docket submissions.
V. Authority and Signature
Edwin G. Foulke, Jr., Assistant Secretary of Labor for Occupational Safety and Health, directed the preparation of this notice. The authority for this notice is the Paperwork Reduction Act of 1995 (44 U.S.C. 3506 et seq.) and Secretary of Labor's Order No. 5-2007 (72 FR 31159).Start Signature
Signed at Washington, DC, this 29th day of July 2008.
Edwin G. Foulke, Jr.
Assistant Secretary of Labor for Occupational Safety and Health.
[FR Doc. E8-17753 Filed 8-1-08; 8:45 am]
BILLING CODE 4510-26-P