Federal Aviation Administration (FAA), DOT.
Notice of proposed rulemaking (NPRM).
We propose to adopt a new airworthiness directive (AD) for certain Boeing Model 757 airplanes. This proposed AD would require replacing the power control relays for the fuel boost pumps and override pumps with new relays having a ground fault interrupt (GFI) feature. This proposed AD results from fuel system reviews conducted by the manufacturer. We are proposing this AD to prevent damage to the fuel pumps caused by electrical arcing that could introduce an ignition source in the fuel tank, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
We must receive comments on this proposed AD by December 3, 2009.
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
- Fax: 202-493-2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
- Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, Washington 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; e-mail email@example.com; Internet https://www.myboeingfleet.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221 or 425-227-1152.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Georgios Roussos, Aerospace Engineer, Systems and Equipment Branch, ANM-130S, FAA, Seattle Aircraft Certification Office, 1601 Lind Avenue SW., Renton, Washington 98057-3356; telephone (425) 917-6482; fax (425) 917-6590.End Further Info End Preamble Start Supplemental Information
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2009-0908; Directorate Identifier 2009-NM-067-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
The FAA has examined the underlying safety issues involved in fuel tank explosions on several large transport airplanes, including the adequacy of existing regulations, the service history of airplanes subject to those regulations, and existing maintenance practices for fuel tank systems. As a result of those findings, we issued a regulation titled “Transport Airplane Fuel Tank System Design Review, Flammability Reduction and Maintenance and Inspection Requirements” (66 FR 23086, May 7, 2001). In addition to new airworthiness standards for transport airplanes and new maintenance requirements, this rule included Special Federal Aviation Regulation No. 88 (“SFAR 88,” Amendment 21-78, and subsequent Amendments 21-82 and 21-83).
Among other actions, SFAR 88 requires certain type design (i.e., type certificate (TC) and supplemental type certificate (STC)) holders to substantiate that their fuel tank systems can prevent ignition sources in the fuel tanks. This requirement applies to type design holders for large turbine-powered transport airplanes and for subsequent modifications to those airplanes. It requires them to perform design reviews and to develop design changes and maintenance procedures if their designs do not meet the new fuel tank safety standards. As explained in the preamble to the rule, we intended to adopt airworthiness directives to mandate any changes found necessary to address Start Printed Page 53437unsafe conditions identified as a result of these reviews.
In evaluating these design reviews, we have established four criteria intended to define the unsafe conditions associated with fuel tank systems that require corrective actions. The percentage of operating time during which fuel tanks are exposed to flammable conditions is one of these criteria. The other three criteria address the failure types under evaluation: single failures, Single failures in combination with a latent condition(s), and in-service failure experience. For all four criteria, the evaluations included consideration of previous actions taken that may mitigate the need for further action.
We have determined that the actions identified in this AD are necessary to reduce the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
As part of the SFAR 88 required review, Boeing determined that the power control relays for the fuel boost pumps and override pumps should be replaced with new relays having a ground fault interrupt (GFI) feature. The relays are located in the P33 and P37 equipment panels in the main equipment center. The GFI feature is intended to protect the fuel pumps from damage caused by electrical arcing by removing electrical power from the pump if a ground fault is detected. Electrical arcing, if not prevented, could introduce an ignition source in the fuel tank, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
Relevant Service Information
We have reviewed Boeing Alert Service Bulletin 757-28A0078, dated July 16, 2008 (for Boeing Model 757-200, 757-200CB, and 757-200PF series airplanes); and Boeing Alert Service Bulletin 757-28A0079, dated July 16, 2008 (for Boeing Model 757-300 series airplanes). These service bulletins describe procedures for replacing the power control relays for the fuel boost pumps and override pumps with new relays having a ground fault interrupt (GFI) feature. The replacement also includes an operational test of the fuel boost pumps, override pumps, and new relays.
FAA's Determination and Requirements of This Proposed AD
We are proposing this AD because we evaluated all relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of the same type design. This proposed AD would require accomplishing the actions specified in the service information described previously.
Airworthiness Limitation (AWL) 28-AWL-21, of Section 9 of the Boeing 757 Maintenance Planning Document (MPD) Document, D622N001-9, Revision March 2008, which was required by AD 2008-10-11, is also related to this proposed AD by including a repetitive operational test of the GFI relays, and repair of any failed GFI relay to ensure continued functionality of the GFI circuit.
Costs of Compliance
We estimate that this proposed AD would affect 696 airplanes of U.S. registry. The following table provides the estimated costs for U.S. operators to comply with this proposed AD.
|Action||Work hours||Average labor rate per hour||Parts||Cost per product||Number of U.S.-registered airplanes||Fleet cost|
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866,
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979), and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
You can find our regulatory evaluation and the estimated costs of compliance in the AD Docket.Start List of Subjects
List of Subjects in 14 CFR Part 39End List of Subjects
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:Start Part
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. The FAA amends § 39.13 by adding the following new AD:
Boeing: Docket No. FAA-2009-0908; Directorate Identifier 2009-NM-067-AD.
Comments Due Date
(a) We must receive comments by December 3, 2009.Start Printed Page 53438
(c) This AD applies to Boeing Model 757-200, -200PF, -200CB, and -300 series airplanes, certificated in any category; as identified in the applicable service bulletin in paragraphs (c)(1) or (c)(2) of this AD.
(1) For Model 757-200, -200PF, and -200CB series airplanes: Boeing Alert Service Bulletin 757-28A0078, dated July 16, 2008.
(2) For Model 757-300 series airplanes: Boeing Alert Service Bulletin 757-28A0079, dated July 16, 2008.
(d) Air Transport Association (ATA) of America Code 28: Fuel.
(e) This AD results from fuel system reviews conducted by the manufacturer. The Federal Aviation Administration is issuing this AD to prevent damage to the fuel pumps caused by electrical arcing that could introduce an ignition source in the fuel tank, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
(f) You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Within 60 months after the effective date of this AD: Replace the power control relays for the fuel boost pumps and override pumps with new relays having a ground fault interrupt (GFI) feature, and do an operational test, in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin 757-28A0078, dated July 16, 2008 (for Model 757-200, -200CB, and -200PF airplanes); or Boeing Alert Service Bulletin 757-28A0079, dated July 16, 2008 (for Model 757-300 airplanes).
Alternative Methods of Compliance (AMOCs)
(h)(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Georgios Roussos, Aerospace Engineer, Systems and Equipment Branch, ANM-130S, FAA, Seattle ACO, 1601 Lind Avenue, SW., Renton, Washington 98057-3356; telephone (425) 917-6482; fax (425) 917-6590. Or, e-mail information to 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.
(2) To request a different method of compliance or a different compliance time for this AD, follow the procedures in 14 CFR 39.19. Before using any approved AMOC on any airplane to which the AMOC applies, notify your principal maintenance inspector (PMI) or principal avionics inspector (PAI), as appropriate, or lacking a principal inspector, your local Flight Standards District Office. The AMOC approval letter must specifically reference this AD.
Issued in Renton, Washington, on September 30, 2009.
Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. E9-24987 Filed 10-16-09; 8:45 am]
BILLING CODE 4910-13-P