Skip to Content

Proposed Rule

Airworthiness Directives; Thielert Aircraft Engines GmbH (TAE) Model TAE 125-01 Reciprocating Engines

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as: Service has shown that the small outlet of the blow-by oil separators, part number 02-7250-18100R1; 02-7250-18100R2; 02-7250-18100R3; 02-7250-18100R4; 02-7250-18300R1; 02-7250-18300R2; 02-7250-18300R3; 02-7250-18300R4; or 02-7250-18300R5, may cause a blow-by gas pressure increase inside the crankcase of the engine in excess of the oil seal design pressure limits. Leaking engine oil may adversely affect the gearbox clutch or the engine lubrication system. This condition, if not corrected, could lead to in-flight cases of engine power loss or ultimately, shutdown. We are proposing this AD to prevent loss of engine power or uncommanded engine shutdown during flight due to excessive crankcase blow-by gas pressure.

DATES:

We must receive comments on this proposed AD by May 20, 2010.

ADDRESSES:

You may send comments by any of the following methods:

  • Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
  • Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue, SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
  • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
  • Fax: (202) 493-2251.

Contact Thielert Aircraft Engines GmbH, Platanenstrasse 14 D-09350, Lichtenstein, Germany, telephone: +49-37204-696-0; fax: +49-37204-696-55; e-mail: info@centurion-engines.com for the service information identified in this proposed AD.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov;​ or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (phone (800) 647-5527) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Tara Chaidez, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: tara.chaidez@faa.gov; telephone (781) 238-7773; fax (781) 238-7199.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2010-0308; Directorate Identifier 2010-NE-17-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of the Web site, anyone can find and read the comments in any of our dockets, including, if provided, the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).

Discussion

The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued AD 2010-0020, dated February 8, 2010 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:

Service has shown that the small outlet of the blow-by separators, part number 02-7250-18100R1; 02-7250-18100R2; 02-7250-18100R3; 02-7250-18100R4; 02-7250-18300R1; 02-7250-18300R2; 02-7250-18300R3; 02-7250-18300R4; or 02-7250-18300R5, may cause a blow-by gas pressure increase inside the crankcase of the engine in excess of the oil seal design pressure limits. Leaking engine oil may adversely affect the gearbox clutch or the engine lubrication system. This condition, if not corrected, could lead to in-flight cases of engine power loss or ultimately, shutdown.

You may obtain further information by examining the MCAI in the AD docket.

Relevant Service Information

TAE has issued Service Bulletin No. TM TAE 125-0019, Revision 1, dated March 5, 2009. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.

FAA's Determination and Requirements of This Proposed AD

This product has been approved by the aviation authority of Germany and is approved for operation in the United States. Pursuant to our bilateral agreement with Germany, EASA has notified us of the unsafe condition described in the MCAI. We are proposing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This proposed AD would require removing from service certain part number blow-by oil separators, within the next 110 flight hours after the effective date of the proposed AD.

Costs of Compliance

Based on the service information, we estimate that this proposed AD would affect about 250 engines installed on airplanes of U.S. registry. We also estimate that it would take about 1.5 work-hours per engine to comply with this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $1,500 per engine. Based on these figures, we Start Printed Page 17085estimate the cost of the proposed AD on U.S. operators to be $406,875.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify this proposed regulation:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.

Start List of Subjects

List of Subjects in 14 CFR Part 39

End List of Subjects

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

Start Part

PART 39—AIRWORTHINESS DIRECTIVES

1. The authority citation for part 39 continues to read as follows:

Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]

2. The FAA amends § 39.13 by adding the following new AD:

Thielert Aircraft Engines GmbH: Docket No. FAA-2010-0308; Directorate Identifier 2010-NE-17-AD.

Comments Due Date

(a) We must receive comments by May 20, 2010.

Affected Airworthiness Directives (ADs)

(b) None.

Applicability

(c) This AD applies to Thielert Aircraft Engines GmbH (TAE) model TAE 125-01 reciprocating engines with any of the following part number blow-by oil separators installed:

Table 1—Part Numbers of Affected Blow-By Oil Separators

02-7250-18100R102-7250-18100R202-7250-18100R3.
02-7250-18100R402-7250-18300R102-7250-18300R2.
02-7250-18300R302-7250-18300R402-7250-18300R5.

These engines are installed in, but not limited to, Diamond Aircraft Industries Model DA 40, Piper PA-28-161 (Supplemental Type Certificate (STC) No. SA03303AT), and Cessna 172 (STC No. SA01303WI) airplanes.

Reason

(d) Service has shown that the small outlet of the blow-by oil separators, part number 02-7250-18100R1; 02-7250-18100R2; 02-7250-18100R3; 02-7250-18100R4; 02-7250-18300R1; 02-7250-18300R2; 02-7250-18300R3; 02-7250-18300R4; or 02-7250-18300R5, may cause a blow-by gas pressure increase inside the crankcase of the engine in excess of the oil seal design pressure limits. Leaking engine oil may adversely affect the gearbox clutch or the engine lubrication system. This condition, if not corrected, could lead to in-flight cases of engine power loss or ultimately, shutdown. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. We are issuing this AD to prevent loss of engine power or uncommanded engine shutdown during flight due to excessive crankcase blow-by gas pressure.

Actions and Compliance

(e) Unless already done, do the following actions.

(1) Remove the blow-by oil separators listed by part number in Table 1 of this AD within the next 110 flight hours after the effective date of this AD.

(2) Use the Measures section of TAE Service Bulletin No. TM TAE 125-0019, Revision 1, dated March 5, 2009, to do the removal from service.

FAA AD Differences

(f) None.

Alternative Methods of Compliance (AMOCs)

(g) The Manager, Engine Certification Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19.

Related Information

(h) Refer to European Aviation Safety Agency AD 2010-0020, dated February 8, 2010, and TAE Service Bulletin No. TM TAE 125-0019, Revision 1, dated March 5, 2009, for related information. Contact Thielert Aircraft Engines GmbH, Platanenstrasse 14 D-09350, Lichtenstein, Germany, telephone: +49-37204-696-0; fax: +49-37204-696-55; e-mail: info@centurion-engines.com, for a copy of this service information.

(i) Contact Tara Chaidez, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: tara.chaidez@faa.gov; telephone (781) 238-7773; fax (781) 238-7199, for more information about this AD.

Start Signature

Issued in Burlington, Massachusetts, on March 30, 2010.

Peter A. White,

Assistant Manager, Engine and Propeller Directorate, Aircraft Certification Service.

End Signature End Part End Supplemental Information

[FR Doc. 2010-7590 Filed 4-2-10; 8:45 am]

BILLING CODE 4910-13-P