Skip to Content

Notice

Agency Information Collection Activities; Submission to OMB for Review and Approval; Comment Request; NESHAP for Area Sources: Acrylic and Modacrylic Fibers Production, Carbon Black Production, Chemical Manufacturing: Chromium Compounds, Flexible Polyurethane Foam Production and Fabrication, Lead Acid Battery Manufacturing, and Wood Preserving (Renewal)

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Notice.

SUMMARY:

In compliance with the Paperwork Reduction Act (44 U.S.C. 3501 et seq.), this document announces that an Information Collection Request (ICR) has been forwarded to the Office of Management and Budget (OMB) for review and approval. This is a request to renew an existing approved collection. The ICR which is abstracted below describes the nature of the collection and the estimated burden and cost.

DATES:

Additional comments may be submitted on or before October 7, 2010.

ADDRESSES:

Submit your comments, referencing docket ID number EPA-HQ-OECA-2010-0350 to (1) EPA online using http://www.regulations.gov (our preferred method), or by e-mail to docket.oeca@epa.gov, or by mail to: EPA Docket Center (EPA/DC), Environmental Protection Agency, Enforcement and Compliance Docket and Information Center, mail code 28221T, 1200 Pennsylvania Avenue, NW., Washington, DC 20460, and (2) OMB at: Office of Information and Regulatory Affairs, Office of Management and Budget (OMB), Attention: Desk Officer for EPA, 725 17th Street, NW., Washington, DC 20503.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Learia Williams, Compliance Assessment and Media Programs Division, Office of Compliance, Mail Code 2223A, Environmental Protection Agency, 1200 Pennsylvania Avenue, NW., Washington, DC 20460; telephone number: (202) 564-4113; fax number: (202) 564-0050; e-mail address: williams.learia@epa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

EPA has submitted the following ICR to OMB for review and approval according to the procedures prescribed in 5 CFR 1320.12. On June 2, 2010 (75 FR 30813), EPA sought comments on this ICR pursuant to 5 CFR 1320.8(d). EPA received no comments. Any additional comments on this ICR should be submitted to EPA and OMB within 30 days of this notice.

EPA has established a public docket for this ICR under docket ID number EPA-HQ-OECA-2010-0350, which is available for public viewing online at http://www.regulations.gov, in person viewing at the Enforcement and Compliance Docket in the EPA Docket Center (EPA/DC), EPA West, Room 3334, 1301 Constitution Avenue, NW., Washington, DC. The EPA Docket Center Public Reading Room is open from 8:30 a.m. to 4:30 p.m., Monday through Friday, excluding legal holidays. The telephone number for the Reading Room is (202) 566-1744, and the telephone number for the Enforcement and Compliance Docket is (202) 566-1752.

Use EPA's electronic docket and comment system at http://www.regulations.gov, to submit or view public comments, access the index listing of the contents of the docket, and to access those documents, whether submitted electronically or in paper will be made available for public viewing at http://www.regulations.gov, as EPA receives them and without change, unless the comment contains copyrighted material, Confidential Business Information (CBI), or other information whose public disclosure is restricted by statute. For further information about in the docket that are available electronically. Once in the system, select “docket search,” then key in the docket ID number identified above. Please note that EPA's policy is that public comments the electronic docket, go to http://www.regulations.gov.

Title: NESHAP for Area Sources: Acrylic and Modacrylic Fibers Production, Carbon Black Production, Chemical Manufacturing: Chromium Compounds, Flexible Polyurethane Foam Production and Fabrication, Lead Acid Battery Manufacturing, and Wood Preserving (Renewal).

ICR Numbers: EPA ICR Number 2256.03, OMB Control Number 2060-0598.

ICR Status: This ICR is scheduled to expire on October 31, 2010. Under OMB regulations, the Agency may continue to conduct or sponsor the collection of information while this submission is pending at OMB. An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB control number. The OMB control numbers for EPA's regulations in title 40 of the CFR, after appearing in the Federal Register when approved, are listed in 40 CFR part 9, and displayed either by publication in the Federal Register or by other appropriate means, such as on the related collection instrument or form, if applicable. The display of OMB control numbers in certain EPA regulations is consolidated in 40 CFR part 9.

Abstract: The National Emission Standards for Hazardous Air Pollutants (NESHAP) for Area Sources: Acrylic and Modacrylic Fibers Production, Carbon Black Production, Chemical Manufacturing: Chromium Compounds, Flexible Polyurethane Foam Production and Fabrication, Lead Acid Battery Manufacturing, and Wood Preserving were proposed on April 4, 2007, and promulgated on July 16, 2007.

Owners and operators of NESHAP for Area Sources: Acrylic and Modacrylic Fibers Production, Carbon Black Production, Chemical Manufacturing: Chromium Compounds, Flexible Polyurethane Foam Production and Fabrication, Lead Acid Battery Manufacturing, and Wood Preserving, must submit an initial notification of applicability, a notification of compliance status, initial performance test, and periodic reports and results. Owners and operators of an existing affected source are also required to comply with the requirements of any startup, shutdown, or malfunction in the operation of an affected facility. Semiannual reports are also required.

Any owner or operator subject to the provisions of this part shall maintain a file of these measurements, and retain the file for at least five years following the date of such measurements, maintain reports and records. Performance tests reports are required as this is the Agency's record of a source's initial capability to comply with the emission standard, and they serve as a record of the operating conditions under which compliance was achieved.Start Printed Page 54337

All reports are sent to the delegated State or local authority. In the event that there is no such delegated authority, the reports are sent directly to the EPA regional office. This information is being collected to assure compliance with 40 CFR part 63, subpart LLLLLL, 40 CFR part 63, subpart MMMMMM, 40 CFR part 63, subpart NNNNNN, 40 CFR part 63, subpart OOOOOO, 40 CFR part 63, subpart PPPPPP, and 40 CFR part 63, subpart QQQQQQ, as authorized in sections 112 and 114(a) of the Clean Air Act. The required information consists of emissions data and other information that have been determined to be private.

An agency may not conduct or sponsor, and a person is not required to respond to, a collection of information unless it displays a currently valid OMB Control Number. The OMB Control Number for EPA's regulations are list in 40 CFR part 9 and 48 CFR chapter 15, and are identified on the form and/or instrument, if applicable.

Burden Statement: The annual public reporting and recordkeeping burden for this collection of information are estimated to average 12 hours per response. Burden means the total time, effort, or financial resources expended by persons to generate, maintain, retain, or disclose or provide information to or for a Federal agency. This includes the time needed to review instructions; develop, acquire, install, and utilize technology and systems for the purpose of collecting, validating, and verifying information, processing and maintaining, information, and disclosing and providing information. All existing ways will have to adjust to comply with any previously applicable instructions and requirements that have subsequently changed; train personnel to be able to respond to a collection of information; search data sources; complete and review the collection of information; and transmit or otherwise disclose the information.

Respondents/Affected Entities: Acrylic and Modacrylic Fibers Production, Carbon Black Production, Chemical Manufacturing: Chromium Compounds, Flexible Polyurethane Foam Production and Fabrication, Lead Acid Battery Manufacturing, and Wood Preserving.

Estimated Number of Respondents: 319.

Frequency of Response: Initially, semiannually, and occasionally.

Estimated Total Annual Hour Burden: 4,233.

Estimated Total Annual Cost: $399,523, which includes $399,523 in labor costs, no capital/startup costs, and no operation and maintenance (O&M) costs.

Changes in the Estimates: There is a decrease in the number of affected facilities due to a more accurate accounting of existing sources. This decrease is not due to any program changes.

There is an increase in the estimated labor burden hours and cost as currently identified in the OMB Inventory of Approved Burdens. The increase is due to more accurate calculations, and the use of more recent labor rates.

Start Signature

Dated: August 26, 2010.

John Moses,

Director, Collection Strategies Division.

End Signature End Supplemental Information

[FR Doc. 2010-22184 Filed 9-3-10; 8:45 am]

BILLING CODE 6560-50-P