National Highway Traffic Safety Administration, DOT.
Grant of Petition for Decision of Inconsequential Noncompliance.
Goodyear Tire and Rubber Company, (Goodyear),
has determined that approximately 14,826 passenger car replacement tires manufactured between August of 2007 and May of 2009, do not fully comply with paragraph S5.5(f) of Federal Motor Vehicle Safety Standard (FMVSS) No. 139, New Pneumatic Radial Tires for Light Vehicles. Goodyear has filed an appropriate report pursuant to 49 CFR part 573, Defect and Noncompliance Start Printed Page 73008Responsibility and Reports (Dated July 8, 2009).
Pursuant to 49 U.S.C. 30118(d) and 30120(h) (see implementing rule at 49 CFR part 556), Goodyear has petitioned for an exemption from the notification and remedy requirements of 49 U.S.C. Chapter 301 on the basis that this noncompliance is inconsequential to motor vehicle safety.
Notice of receipt of Goodyear's petition was published, with a 30-day public comment period, on June 25, 2010, in the Federal Register (75 FR 36472). No comments were received. To view the petition and all supporting documents log onto the Federal Docket Management System Web site at: http://www.regulations.gov/. Then follow the online search instructions to locate docket number “NHTSA-2010-0080.”
For further information on this decision, contact Mr. George Gillespie, Office of Vehicle Safety Compliance, the National Highway Traffic Safety Administration (NHTSA), telephone (202) 366-5299, facsimile (202) 366-7002.
Affected are approximately 14,826 sizes P195/55R15 84V and P225/60R16 97H Goodyear brand Arizonian Silver Edition Plus model passenger car tires manufactured between August of 2007 and May of 2009 at Goodyear's plant located in Otrokovice, Czech Republic.
Goodyear explains that the noncompliance is that, due to a mold labeling error, the sidewall marking on the reference side of the tires incorrectly describes the actual number of plies in the tread area of the tires as required by paragraph S5.5(f). Specifically, the tires in question were inadvertently manufactured with “Tread Plies: 2 Polyester + 2 steel.” The labeling should have been “Tread Plies: 2 Polyester + 1 polyamide + 2 steel.
Goodyear also explains that while the non-compliant tires are mislabeled “the tires meet or exceed all applicable Federal Motor Vehicle Safety Standards.”
Goodyear argues that this noncompliance is inconsequential to motor vehicle safety because the noncompliant sidewall marking does not create an unsafe condition and all other labeling requirements have been met.
Goodyear points out that NHTSA has previously granted similar petitions for noncompliances in sidewall marking.
Goodyear additionally states that it has corrected the affected tire molds and all future production will have the correct material shown on the sidewall.
In summation, Goodyear believes that the described noncompliance of its tires to meet the requirements of FMVSS No. 139 is inconsequential to motor vehicle safety, and that its petition, to exempt from providing recall notification of noncompliance as required by 49 U.S.C. 30118 and remedying the recall noncompliance as required by 49 U.S.C. 30120, and should be granted.
NHTSA Decision: The agency agrees with Goodyear that the noncompliances are inconsequential to motor vehicle safety. The agency believes that the true measure of inconsequentiality to motor vehicle safety in this case is that there is no effect of the noncompliances on the operational safety of the vehicles on which these tires are mounted. The safety of people working in the tire retread, repair, and recycling industries must also be considered. Although tire construction affects the strength and durability, neither the agency nor the tire industry provides information relating tire strength and durability to the number of plies and types of ply cord material in the tread and sidewall. Therefore, tire dealers and customers should consider the tire construction information along with other information such as load capacity, maximum inflation pressure, and tread wear, temperature, and traction ratings, to assess performance capabilities of various tires. In the agency's judgment, the incorrect labeling of the tire construction information will have an inconsequential effect on motor vehicle safety because most consumers do not base tire purchases or vehicle operation parameters on the ply material in a tire.
The agency also believes the noncompliance will have no measurable effect on the safety of the tire retread, repair, and recycling industries. The use of steel cord construction in the sidewall and tread is the primary safety concern of these industries. In this case, since the tire sidewalls do not contain steel plies, this potential safety concern does not exist.
NHTSA notes that the statutory provisions (49 U.S.C. 30118 (d) and 30120(h)) that permit manufacturers to file petitions for a determination of inconsequentiality allow NHTSA to exempt manufacturers only from the duties found in sections 30118 and 30120, respectively, to notify owners, purchasers, and dealers of a defect or noncompliance and to remedy the defect or noncompliance. Therefore, this decision only applies to the 14,826 
tires that Goodyear no longer controlled at the time that it determined that a noncompliance existed in the subject tires.
In consideration of the foregoing, NHTSA has decided that Goodyear has met its burden of persuasion that the subject FMVSS No. 139 labeling noncompliances are inconsequential to motor vehicle safety. Accordingly, Goodyear's petition is granted and the petitioner is exempted from the obligation of providing notification of, and a remedy for, the subject noncompliance under 49 U.S.C. 30118 and 30120.
Issued on: November 18, 2011.
Claude H. Harris,
Director, Office of Vehicle Safety Compliance.
[FR Doc. 2011-30569 Filed 11-25-11; 8:45 am]
BILLING CODE 4910-59-P