Notice of proposed rulemaking (NPRM).
We propose to adopt a new airworthiness directive (AD) for certain Bombardier Inc. Model DHC-8-400 series airplanes. This proposed AD was prompted by reports that the automatic de-icing mode became unavailable due to a failure of the timer and monitor unit (TMU). This proposed AD would require replacing the TMU. We are proposing this AD to prevent loss of the automatic de-icing mode and consequent increased workload for the flight crew, which, depending on additional failures, could lead to loss of control of the airplane.
We must receive comments on this proposed AD by May 4, 2012.
You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Bombardier, Inc., Q-Series Technical Help Desk, 123 Garratt Boulevard, Toronto, Ontario M3K 1Y5, Canada; telephone 416-375-4000; fax 416-375-4539; email firstname.lastname@example.org; Internet http://www.bombardier.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call (425) 227-1221.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT:
Cesar Gomez, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE-171, FAA, New York Aircraft Certification Office, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone (516) 228-7318; fax (516) 794-5531.
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-0267; Directorate Identifier 2011-NM-174-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-2011-34, dated August 16, 2011 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
There have been multiple reports of in-service incidents where the automatic deicing mode became unavailable due to a failure of the Timer and Monitor Unit (TMU).
Investigation has revealed that the failures were attributed to overstressed capacitors installed in the circuit board of the TMU “Module 300” power supply. The failure of the capacitors leads to failure of the TMU “Module 300” power supply and subsequent loss of the automatic deicing mode.
This [TCCA] directive mandates the replacement of the TMU, part number (P/N) 4100S018-06, with a new improved unit, P/N 4100S018-07.
The unsafe condition is loss of the automatic de-icing mode and consequent increased workload for the flight crew, which, depending on additional failures, could lead to loss of control of the airplane. You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information
Bombardier, Inc. has issued Service Bulletin 84-30-14, dated May 20, 2011. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance
Based on the service information, we estimate that this proposed AD would affect about 81 products of U.S. registry. We also estimate that it would take about 3 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $0 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $20,655, or $255 per product.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. The FAA amends § 39.13 by adding the following new AD:
Bombardier, Inc.: Docket No. FAA-2012-0267; Directorate Identifier 2011-NM-174-AD.
(a) Comments Due Date
We must receive comments by May 4, 2012.
(b) Affected ADs
This AD applies to Bombardier, Inc. Model DHC-8-400, -401, and -402 airplanes, certificated in any category, serial numbers 4001 and subsequent, equipped with Aerazur timer and monitor unit, part number (P/N) 4100S018-06.
Air Transport Association (ATA) of America Code 30: Ice and rain protection.
This AD was prompted by reports that the automatic de-icing mode became unavailable due to a failure of the timer and monitor unit (TMU). We are issuing this AD to prevent loss of the automatic de-icing mode and consequent increased workload for the flight crew, which, depending on additional failures, could lead to loss of control of the airplane.
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Replace the TMU
Within 3,000 flight hours or 18 months after the effective date of this AD, whichever occurs first: Replace TMU P/N 4100S018-06 with new TMU P/N 4100S018-07, by incorporating Bombardier ModSum 4-126525, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 84-30-14, dated May 20, 2011.
(h) Parts Installation
As of the effective date of this AD, no person may install a TMU, P/N 4100S018-06, on any airplane.
(i) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(j) Related Information
Refer to MCAI Canadian Airworthiness Directive CF-2011-34, dated August 16, 2011; and Bombardier Service Bulletin 84-30-14, dated May 20, 2011; for related information.
Issued in Renton, Washington, on March 7, 2012.
Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 2012-6626 Filed 3-19-12; 8:45 am]
BILLING CODE 4910-13-P