Notice of Proposed Rulemaking (NPRM).
We propose to adopt a new airworthiness directive (AD) for Alpha Aviation Concept Limited Model R2160 Airplanes. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as possible installation of non-conforming air filter elements that are not fitted with metallic mesh and could internally collapse resulting in disruption of the powerplant operation. We are issuing this proposed AD to require actions to address the unsafe condition on these products.
We must receive comments on this proposed AD by September 13, 2012.
You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
Fax: (202) 493-2251.
Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Alpha Aviation, 59 Hautapu Road, RD 1, Cambridge 3493, New Zealand; telephone: +64 7 827 0528; fax: +64 7 929 2878; Internet: www.alphaaviation.co.nz. You may review copies of the referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT:
Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090; email: email@example.com.
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-0798; Directorate Identifier 2012-CE-023-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.
We will post all comments we receive, without change, to http://regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
The Civil Aviation Authority (CAA), which is the aviation authority for New Zealand, has issued DCA/R2000/41, dated June 8, 2012 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
This emergency AD with the effective date 11 June 2012 is prompted by a report from EASA of finding a non conforming air filter fitted to an overseas aircraft during maintenance. Investigation revealed that air filters with P/N 57.34.00.010 supplied by CEAPR between June 2009 and April 2012 may not have the metallic mesh inside the filter. This AD mandates an inspection of air filters with P/N 57.34.00.010 to determine if a metallic mesh is fitted.
Relevant Service Information
Alpha Aviation has issued Service Bulletin AA-SB-71-006, dated May 2012. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of the Proposed AD
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with this State of Design Authority, they have notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance
We estimate that this proposed AD will affect 10 products of U.S. registry. We also estimate that it would take about .5 work-hour per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour.
Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $425, or 42.50 per product.
In addition, we estimate that any necessary follow-on actions would take about .5 work-hour and require parts costing $100 for a cost of $142.50 per product. We have no way of determining the number of products that may need these actions.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a “significant regulatory action” under Executive Order 12866,
(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. The FAA amends § 39.13 by adding the following new AD:
Alpha Aviation Concept Limited: Docket No. FAA-2012-0798; Directorate Identifier 2012-CE-023-AD.
(a) Comments Due Date
We must receive comments by September 13, 2012.
(b) Affected ADs
This AD applies to Alpha Aviation Concept Limited Model R2160 airplanes, all serial numbers, certificated in any category.
Air Transport Association of America (ATA) Code 71, Power Plant.
This AD was prompted by reports of possible installation of non-conforming air filter elements that are not fitted with metallic mesh and could internally collapse resulting in disruption of the powerplant operation. We are issuing this proposed AD to inspect the air filter element and replace if applicable.
(f) Actions and Compliance
Unless already done, do the following actions following Alpha Aviation Service Bulletin AA-SB-71-006, dated May 2012:
(1) Within the next 30 days time-in-service (TIS) after the effective date of this AD, inspect the air filter part number (P/N) 57.34.00.010 to determine if it has been fitted with a perforated metal liner.
(2) If, after the inspection required in paragraph (f)(1) of this AD, the air filter part number (P/N) 57.34.00.010 is found to include the perforated metal liner, no further action is required.
(3) If, after the inspection required in paragraph (f)(1) of this AD, the air filter is found to not contain the perforated metal liner, before further flight, replace the air filter with a new air filter P/N 57.34.00.010 that does contain the perforated metal liner.
(4) After the effective date of this AD, do not install any air filter P/N 57.34.00.010 that does not have the perforated metal liner depicted in Alpha Aviation Service Bulletin AA-SB-71-006, dated May 2012.
(g) Other FAA AD Provisions
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, Standards Office, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. Send information to ATTN: Karl Schletzbaum, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4146; fax: (816) 329-4090; email: firstname.lastname@example.org. Before using any approved AMOC on any airplane to which the AMOC applies, notify your appropriate principal inspector (PI) in the FAA Flight Standards District Office (FSDO), or lacking a PI, your local FSDO.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(3) Reporting Requirements: For any reporting requirement in this AD, a federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.
(h) Related Information
Refer to MCAI DCA/R2000/41 issued by the Civil Aviation Authority (CAA), which is the aviation authority for New Zealand, dated June 8, 2012; and Alpha Aviation Service Bulletin AA-SB-71-006, dated May 2012, for related information. For service information related to this AD, contact Alpha Aviation, 59 Hautapu Road, RD 1, Cambridge 3493, New Zealand; telephone: +64 7 827 0528; fax: +64 7 929 2878; Internet: www.alphaaviation.co.nz. You may review copies of the referenced service information at the FAA, Small Airplane Directorate, 901 Locust, Kansas City, Missouri 64106. For information on the availability of this material at the FAA, call (816) 329-4148.
Issued in Kansas City, Missouri, on July 24, 2012.
Acting Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. 2012-18461 Filed 7-27-12; 8:45 am]
BILLING CODE 4910-13-P