Skip to Content


Energy Conservation Program for Consumer Products: Decision and Order Granting a Waiver to BSH Corporation From the Department of Energy Residential Dishwasher Test Procedure

Document Details

Information about this document as published in the Federal Register.

Enhanced Content

Relevant information about this document from provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.


Decision and Order.


The U.S. Department of Energy (DOE) gives notice of the decision and order (Case No. DW-007) that grants to BSH Corporation (BSH) a waiver from the DOE dishwasher test procedure for certain basic models containing integrated or built-in water softeners. Under today's decision and order, BSH shall be required to test and rate its dishwashers with integrated water softeners using an alternate test procedure that takes this technology into account when measuring energy and water consumption.


This Decision and Order is effective October 1, 2012 through May 29, 2013.


Dr. Bryan Berringer, U.S. Department of Energy, Building Technologies Program, Mail Stop EE-2J, Forrestal Building, 1000 Independence Avenue SW., Washington, DC 20585-0121. Telephone: (202) 586-0371. Email:

Ms. Elizabeth Kohl, U.S. Department of Energy, Office of the General Counsel, Mail Stop GC-71, Forrestal Building, 1000 Independence Avenue SW., Washington, DC 20585-0103. Telephone: (202) 586-7796. Email:


In accordance with Title 10 of the Code of Federal Regulations (10 CFR 430.27(l)), DOE gives notice of the issuance of its decision and order as set forth below. The decision and order grants BSH a waiver from the applicable residential dishwasher test procedure in 10 CFR part 430, subpart B, appendix C for certain basic models of dishwashers with built-in or integrated water softeners, provided that BSH tests and rates such products using the alternate test procedure described in this notice. Today's decision prohibits BSH from making representations concerning the energy efficiency of these products unless the product has been tested consistent with the provisions of the alternate test procedure set forth in the decision and order below, and the representations fairly disclose the test results. Distributors, retailers, and private labelers are held to the same standard when making representations regarding the energy efficiency of these products. 42 U.S.C. 6293(c).

Issued in Washington, DC, on September 18, 2012.

Kathleen B. Hogan,

Deputy Assistant Secretary for Energy Efficiency, Energy Efficiency and Renewable Energy.

Decision and Order

In the Matter of: BSH Corporation (Case No. DW-007)

I. Background and Authority

Title III of the Energy Policy and Conservation Act (EPCA) sets forth a variety of provisions concerning energy efficiency. Part B of Title III provides for the “Energy Conservation Program for Consumer Products Other Than Automobiles.” [1] 42 U.S.C. 6291-6309. Part B includes definitions, test procedures, labeling provisions, energy conservation standards, and the authority to require information and reports from manufacturers. Further, Part B authorizes the Secretary of Energy to prescribe test procedures that are reasonably designed to produce results that measure energy efficiency, energy use, or estimated operating costs, and that are not unduly burdensome to conduct. 42 U.S.C. 6293(b)(3). The test procedure for residential dishwashers, the subject of today's notice, is contained in 10 CFR part 430, subpart B, appendix C.

DOE's regulations for covered products contain provisions allowing a person to seek a waiver for a particular basic model from the test procedure requirements for covered consumer products when (1) the petitioner's basic model for which the petition for waiver was submitted contains one or more design characteristics that prevent testing according to the prescribed test procedure, or (2) when prescribed test procedures may evaluate the basic model in a manner so unrepresentative of its true energy consumption characteristics as to provide materially inaccurate comparative data. 10 CFR 430.27(a)(1). Petitioners must include in their petition any alternate test procedures known to the petitioner to evaluate the basic model in a manner representative of its energy consumption characteristics.

The Assistant Secretary for Energy Efficiency and Renewable Energy (the Assistant Secretary) may grant a waiver subject to conditions, including adherence to alternate test procedures. 10 CFR 430.27(l). Waivers remain in effect pursuant to the provisions of 10 CFR 430.27(m).

Any interested person who has submitted a petition for waiver may also file an application for interim waiver of the applicable test procedure requirements. 10 CFR 430.27(a)(2). The Assistant Secretary will grant an interim waiver request if it is determined that the applicant will experience economic hardship if the interim waiver is denied, if it appears likely that the petition for waiver will be granted, and/or the Assistant Secretary determines that it would be desirable for public policy reasons to grant immediate relief pending a determination on the petition for waiver. 10 CFR 430.27(g).

II. BSH's Petition for Waiver: Assertions and Determinations

On December 7, 2011, BSH submitted the instant petition for waiver from the test procedure applicable to dishwashers set forth in 10 CFR part 430, subpart B, appendix C. BSH's petition was published in the Federal Register on April 2, 2012. 77 FR 19650. DOE received no comments on the BSH petition. In every respect except the introduction of new model numbers, the instant petition is identical to a petition submitted by BSH on February 4, 2011 (Case No. DW-005). DOE granted the earlier petition on June 29, 2011 (76 FR 38144).

BSH states that “hard” water can reduce customer satisfaction with dishwasher performance, resulting in increased pre-rinsing and/or hand washing as well as increased detergent and rinse agent usage. According to BSH, a dishwasher equipped with a water softener will minimize pre-rinsing and rewashing, and consumers will have less reason to periodically run their dishwasher through a clean-up cycle.

BSH also states that the amount of water consumed by the regeneration operation of a water softener in a dishwasher is very small, but that it varies significantly depending on the adjustment of the softener. The regeneration operation takes place infrequently, and the frequency is related to the level of water hardness. BSH included test results and calculations showing the water and energy use of the specified dishwasher models using the same method as that used by Whirlpool in its petition for waiver, which was granted previously by DOE. (75 FR 62127, Oct. 7, 2010). BSH states that the water used in the regeneration process is for the purpose of softening water rather than cleaning dishes. Therefore, according to BSH, this water and energy should not be included in the energy usage figures for washing dishes. As an alternate test procedure, BSH suggests using European Standard EN50242, “Electric Dishwashers for Household Use—Methods for Measuring the Performance”, which does not include the water or energy used in the water softening process in the dishwasher energy consumption calculation.

Use of EN 50242 would provide repeatable results, but would underestimate the energy and water use of the specified models. If water consumption of a regeneration operation were apportioned across all cycles of operation, manufacturers would need to make calculations regarding average water hardness and average water consumptions due to regeneration operations. In lieu of these calculations, constant values could also be used to approximate the energy and water use due to softener regeneration. In its petition, BSH requests that constant values of 47.6 gallons per year for water consumption and 8.0 kWh per year for energy consumption be used.

Consultations With Other Agencies

DOE consulted with the Federal Trade Commission (FTC) staff concerning the BSH petition for waiver. The FTC staff did not have any objections to granting a waiver to BSH.

III. Conclusion

After careful consideration of all the material submitted by BSH and consultation with the FTC staff, it is ordered that:

(1) The petition for waiver submitted by the BSH Corporation (Case No. DW-007) is hereby granted as set forth in the paragraphs below.

(2) BSH shall be required to test or rate the following models according to the alternate test procedure as set forth in paragraph (3) below:

Bosch brand:

  • Basic Model—SHE7ER5#UC
  • SHE7ER5#UC
  • SHV7ER5#UC
  • SHX7ER5#UC
  • SGE63E1#UC
  • SHE9ER5#UC
  • SHV9ER5#UC
  • SHX9ER5#UC
  • SHE8ER5#UC
  • SHX8ER5#UC
  • Basic Model—SPE5ES5#UC
  • SPE5ES5#UC
  • SPV5ES5#UC
  • SPX5ES5#

Thermador brand:

  • Basic Model—DWHD650G##
  • DWHD650G##
  • DWHD651GFP
  • Basic Model—DWHD640J##
  • DWHD640J##
  • Basic Model—DWHD651J##
  • DWHD650J##
  • DWHD651J##

(3) BSH shall be required to test the products listed in paragraph (2) above according to the test procedures for dishwashers prescribed by DOE at 10 CFR part 430, appendix C, except that, for the BSH products listed in paragraph (2) only:

In Section 4.1, Test cycle, add at the end, “The start of the DOE test should begin on a cycle immediately following a regeneration cycle.”

In Section 4.3, the water energy consumption, W or Wg, is calculated based on the water consumption as set forth below:

4.3 Water consumption. Measure the water consumption, V, expressed as the number of gallons of water delivered to the machine during the entire test cycle, using a water meter as specified in section 3.3 of this Appendix.

Where the regeneration of the water softener depends on demand and water hardness, and does not take place on every cycle, BSH shall measure the water consumption of dishwashers having water softeners without including the water consumed by the dishwasher during softener regeneration. If a regeneration operation takes place within the test, the water consumed by the regeneration operation shall be disregarded when declaring water and energy consumption. Constant values of 47.6 gallons/year of water and 8 kWh/year of energy shall be added to the values measured by appendix C.

(4) Representations. BSH may make representations about the energy use of its dishwashers containing integrated or built-in water softeners for compliance, marketing, or other purposes only to the extent that such products have been tested in accordance with the provisions outlined above and such representations fairly disclose the results of such testing.

(5) This waiver shall remain in effect consistent with the provisions of 10 CFR 430.27(m). The dishwasher test procedure final rule, issued on September 14, 2012 and available at, includes procedures to measure the energy and water use of integrated or built-in water softeners. The compliance date for these procedures is May 30, 2013. Therefore, this Decision and Order is valid through May 29, 2013. Beginning on May 30, 2013, all manufacturers must use the amended test procedures to determine the energy and water use associated with water softener regeneration.

(6) This waiver is granted for only those models specifically set out in BSH's petition, not future models that may be manufactured by BSH. BSH may submit a new or amended petition for waiver and request for grant of interim waiver, as appropriate, for additional dishwasher models for which it seeks a waiver from the DOE test procedure. Grant of this waiver also does not release BSH from the certification requirements set forth at 10 CFR Part 429.

(7) This waiver is issued on the condition that the statements, representations, and documentary materials provided by the petitioner are valid. DOE may revoke or modify this waiver at any time if it determines the factual basis underlying the petition for waiver is incorrect, or the results from the alternate test procedure are unrepresentative of the basic models' true energy consumption characteristics.

Issued in Washington, DC, on September 18, 2012.

Kathleen B. Hogan,

Deputy Assistant Secretary for Energy Efficiency, Energy Efficiency and Renewable Energy.


1.  For editorial reasons, on codification in the U.S. Code, Part B was re-designated Part A.

Back to Citation

[FR Doc. 2012-24093 Filed 9-28-12; 8:45 am]