Federal Aviation Administration (FAA), DOT.
Start Printed Page 8906
Notice of proposed rulemaking (NPRM).
We propose to adopt a new airworthiness directive (AD) for all Rolls-Royce Deutschland Ltd & Co KG (RRD) BR700-725A1-12 turbofan engines. This proposed AD was prompted by reports of wear on the receptors of the double-ended unions in the fuel metering unit (FMU) housing on BR700-725A1-12 engines causing fuel leakage. This proposed AD would require removal of the affected FMUs. We are proposing this AD to prevent failure of the FMU, which could lead to damage to one or more engines and damage to the airplane.
We must receive comments on this proposed AD by April 15, 2014.
You may send comments by any of the following methods:
Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803. For information on the availability of this material at the FAA, call 781-238-7125.
Examining the AD Docket
You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2013-0882; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the mandatory continuing airworthiness information (MCAI), the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (phone: 800-647-5527) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
Start Further Info
FOR FURTHER INFORMATION CONTACT:
Glorianne Niebuhr, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7132; fax: 781-238-7199; email: email@example.com.
End Further Info
Start Supplemental Information
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2013-0882; Directorate Identifier 2013-NE-29-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of the Web site, anyone can find and read the comments in any of our dockets, including, if provided, the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2013-0229R1, dated November 21, 2013 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
Occurrences have been reported of finding wear on the receptors of the double-ended unions in the Fuel Metering Unit (FMU) housing on BR700-725A1-12 engines.
This condition, if not corrected, could lead to fuel leak resulting in engine in-flight shutdown and consequent reduced control of the aeroplane.
Failure of the FMU due to these conditions will result in loss of thrust control and damage to the engine. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating it in Docket No. FAA-2013-0882.
FAA's Determination and Requirements of This Proposed AD
This product has been approved by the aviation authority of Germany, and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This proposed AD would require removal of the affected FMUs and their replacement with a part eligible for installation.
Costs of Compliance
We estimate that this proposed AD affects 24 RRD turbofan engines installed on aircraft of U.S. registry. We also estimate that it would take about 6 hours per engine to comply with this proposed AD. The average labor rate is $85 per hour. Required parts cost about $293,960 per engine. Based on these figures, we estimate the cost of this proposed AD on U.S. operators to be $7,067,280.
Authority for This Rulemaking
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This proposed regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and Start Printed Page 8907responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
(1) Is not a “significant regulatory action” under Executive Order 12866,
(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),
(3) Will not affect intrastate aviation in Alaska to the extent that it justifies making a regulatory distinction, and
(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
Start List of Subjects
End List of Subjects
- Air transportation
- Aviation safety
- Incorporation by reference
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES
Start Amendment Part
1. The authority citation for part 39 continues to read as follows: End Amendment Part
Start Amendment Part
2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD): End Amendment Part
Rolls-Royce Deutschland Ltd & Co KG: Docket No. FAA-2013-0882; Directorate Identifier 2013-NE-29-AD.
(a) Comments Due Date
We must receive comments by April 15, 2014.
(b) Affected ADs
This AD applies to all Rolls-Royce Deutschland Ltd & Co KG (RRD) BR700-725A1-12 turbofan engines.
This AD was prompted by reports of wear on the receptors of the double-ended unions in the fuel metering unit (FMU) housing on BR700-725A1-12 engines causing fuel leakage. We are issuing this AD to prevent failure of the FMU, which could lead to damage to one or more engines, and damage to the airplane.
(e) Actions and Compliance
Comply with this AD within the compliance times specified, unless already done.
(1) After the effective date of this AD, before the FMU has accumulated 650 flight hours (FHs) since new, or within 30 days, whichever occurs later, remove FMU part number (P/N) G3000FMU02 or P/N G3000FMU03, and replace it with a part eligible for installation.
(2) Thereafter, remove the FMU at intervals not to exceed 650 FHs and replace it with a part eligible for installation.
(f) Installation Prohibition
After the effective date of this AD, do not install FMU P/N G3000FMU02 onto any engine, or install any engine with FMU P/N G3000FMU02 onto any airplane.
For the purpose of this AD, an FMU eligible for installation is a new FMU or an FMU with P/N G3000FMU03 that has accumulated fewer than 650 FHs since installation on any airplane or since last repair using RRD Alert Non-Modification Service Bulletin (NMSB) No. ALERT SB-BR700-73-A900309, Revision 1, dated November 8, 2013.
(h) Alternative Methods of Compliance (AMOCs)
The Manager, Engine Certification Office, may approve AMOCs for this AD. Use the procedures found in 14 CFR 39.19 to make your request.
(i) Related Information
(1) For more information about this AD, contact Glorianne Niebuhr, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7132; fax: 781-238-7199; email: firstname.lastname@example.org.
(2) Refer to MCAI European Aviation Safety Agency AD 2013-0229R1, dated November 21, 2013. You may examine the MCAI in the AD docket on the Internet at http://www.regulations.gov by searching for and locating it in Docket No. FAA-2013-0882.
(3) RRD Alert NMSB No. ALERT SB-BR700-73-A900309, Revision 1, dated November 8, 2013, which is not incorporated by reference in this AD, can be obtained from RRD, using the contact information in paragraph (i)(4) of this AD.
(4) For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1944; fax: 49 0 33-7086-3276.
(5) You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.
End Supplemental Information
Issued in Burlington, Massachusetts, on February 6, 2014.
Colleen M. D'Alessandro,
Assistant Directorate Manager, Engine & Propeller Directorate, Aircraft Certification Service.
[FR Doc. 2014-03252 Filed 2-13-14; 8:45 am]
BILLING CODE 4910-13-P