Skip to Content

Proposed Rule

Airworthiness Directives; The Boeing Company Airplanes

Document Details

Information about this document as published in the Federal Register.

Enhanced Content

Relevant information about this document from Regulations.gov provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Notice of proposed rulemaking (NPRM).

SUMMARY:

We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 767-200, -300, and -400ER series airplanes. This proposed AD was prompted by a report of the engine indication and crew alerting system (EICAS) display system malfunctioning during flight. This proposed AD would require an inspection for plastic couplings, corrective actions if necessary, and installation of new spray shrouds. We are proposing this AD to prevent an uncontrolled water leak from a defective potable water system coupling, which could cause the main equipment center (MEC) line replaceable units (LRUs) to become wet, resulting in an electrical short and potential loss of several functions essential for safe flight.

DATES:

We must receive comments on this proposed AD by September 29, 2014.

ADDRESSES:

You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:

  • Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
  • Fax: 202-493-2251.
  • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
  • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.

For service information identified in this proposed AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

Examining the AD Docket

You may examine the AD docket on the Internet at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0571; or in person at the Docket Management Facility between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Office (phone: 800-647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Stanley Chen, Aerospace Engineer, Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle Aircraft Certification Office (ACO), 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6585; fax: 425-917-6590; email: stanley.chen@faa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Comments Invited

We invite you to send any written relevant data, views, or arguments about this proposal. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2014-0571; Directorate Identifier 2014-NM-059-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD because of those comments.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.Start Printed Page 47598

Discussion

We received a report of the EICAS display system malfunctioning during flight. An investigation determined that the problems were caused by a water leak from a fractured plastic potable water coupling. We are proposing this AD to prevent an uncontrolled water leak from a defective potable water system coupling. This condition, if not corrected, could cause the MEC LRUs to become wet, resulting in an electrical short and potential loss of several functions essential for safe flight.

Relevant Service Information

We reviewed Boeing Alert Service Bulletin 767-38A0073, dated November 12, 2013. For information on the procedures and compliance times, see this service information at http://www.regulations.gov by searching for and locating Docket No. FAA-2014-0571.

FAA's Determination

We are proposing this AD because we evaluated all the relevant information and determined the unsafe condition described previously is likely to exist or develop in other products of these same type designs.

Proposed AD Requirements

This proposed AD would require accomplishing the actions specified in the service information described previously.

The phrase “corrective actions” is used in this proposed AD. “Corrective actions” are actions that correct or address any condition found. Corrective actions in an AD could include, for example, repairs.

Explanation of “RC” Steps in Service Information

The FAA worked in conjunction with industry, under the Airworthiness Directives Implementation Aviation Rulemaking Committee, to enhance the AD system. One enhancement was a new process for annotating which steps in the service information are required for compliance with an AD. Differentiating these steps from other tasks in the service information is expected to improve an owner's/operator's understanding of crucial AD requirements and help provide consistent judgment in AD compliance. The actions specified in the service information described previously include steps that are labeled as RC (required for compliance) because these steps have a direct effect on detecting, preventing, resolving, or eliminating an identified unsafe condition.

As noted in the specified service information, steps labeled as RC must be done to comply with the proposed AD. However, steps that are not labeled as RC are recommended. Those steps that are not labeled as RC may be deviated from, done as part of other actions, or done using accepted methods different from those identified in the service information without obtaining approval of an AMOC, provided the steps labeled as RC can be done and the airplane can be put back in a serviceable condition. Any substitutions or changes to steps labeled as RC will require approval of an alternative method of compliance.

Costs of Compliance

We estimate that this proposed AD affects 139 airplanes of U.S. registry.

We estimate the following costs to comply with this proposed AD:

Estimated Costs

ActionLabor costParts costCost per productCost on U.S. operators
Part 1—General visual inspectionUp to 3 work-hours × $85 per hour = $255$0$255$35,445
Part 2—General visual inspection (Groups 9 and 10)2 work-hours × 85 per hour = 17001705,440
Install spray shrouds3 work-hours × 85 per hour = 25533058581,315

We estimate the following costs to do any necessary replacements that would be required based on the results of the proposed inspection. We have no way of determining the number of aircraft that might need this replacement:

On-Condition Costs

ActionLabor costParts costCost per product
Replacement of coupling1 work-hour × $85 per hour = $85$53$183

According to the manufacturer, some of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all costs in our cost estimate.

Authority for This Rulemaking

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. Subtitle VII: Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701: “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings

We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.Start Printed Page 47599

For the reasons discussed above, I certify this proposed regulation:

(1) Is not a “significant regulatory action” under Executive Order 12866,

(2) Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979),

(3) Will not affect intrastate aviation in Alaska, and

(4) Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

Start List of Subjects

List of Subjects in 14 CFR Part 39

  • Air transportation
  • Aircraft
  • Aviation safety
  • Incorporation by reference
  • Safety
End List of Subjects

The Proposed Amendment

Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:

Start Part

PART 39—AIRWORTHINESS DIRECTIVES

End Part Start Amendment Part

1. The authority citation for part 39 continues to read as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701.

End Authority
[Amended]
Start Amendment Part

2. The FAA amends § 39.13 by adding the following new airworthiness directive (AD):

End Amendment Part

The Boeing Company: Docket No. FAA-2014-0571; Directorate Identifier 2014-NM-059-AD.

(a) Comments Due Date

We must receive comments by September 29, 2014.

(b) Affected ADs

None.

(c) Applicability

This AD applies to The Boeing Company Model 767-200,-300, and-400ER series airplanes, certificated in any category, as identified in Boeing Alert Service Bulletin 767-38A0073, dated November 12, 2013.

(d) Subject

Air Transport Association (ATA) of America Code 38, Water/Waste.

(e) Unsafe Condition

This AD was prompted by a report of the engine indication and crew alerting system (EICAS) display system malfunctioning during flight. We are issuing this AD to prevent an uncontrolled water leak from a defective potable water system coupling, which could cause the main equipment center (MEC) line replaceable units (LRUs) to become wet, resulting in an electrical short and potential loss of several functions essential for safe flight.

(f) Compliance

Comply with this AD within the compliance times specified, unless already done.

(g) Inspection and Installation

At the applicable times identified in paragraph 1.E., “Compliance,” of Boeing Alert Service Bulletin 767-38A0073, dated November 12, 2013, except as required by paragraph (h) of this AD: Do a general visual inspection for plastic potable water couplings, do all applicable corrective actions, and install new spray shrouds (including a new hose assembly, as applicable), in accordance with the Accomplishment Instructions of Boeing Alert Service Bulletin 767-38A0073, dated November 12, 2013. Do all applicable corrective actions within the compliance time identified in paragraph 1.E., “Compliance,” of Boeing Alert Service Bulletin 767-38A0073, dated November 12, 2013, except as required by paragraph (h) of this AD.

(h) Exception to the Service Information

Where paragraph 1.E., “Compliance,” of Boeing Alert Service Bulletin 767-38A0073, dated November 12, 2013, specifies a compliance time “after the original issue date of this service bulletin,” this AD requires compliance within the specified compliance time after the effective date of this AD.

(i) Parts Installation Prohibition

As of the effective date of this AD, no person may install any plastic potable water coupling having part number (P/N) CA620 or P/N CA625 on any airplane.

(j) Alternative Methods of Compliance (AMOCs)

(1) The Manager, Seattle Aircraft Certification Office (ACO), FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the manager of the ACO, send it to the attention of the person identified in paragraph (k)(1) of this AD. Information may be emailed to: 9-ANM-Seattle-ACO-AMOC-Requests@faa.gov.

(2) Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office.

(3) If the service information contains steps that are labeled as RC (Required for Compliance), those steps must be done to comply with this AD; any steps that are not labeled as RC are recommended. Those steps that are not labeled as RC may be deviated from, done as part of other actions, or done using accepted methods different from those identified in the specified service information without obtaining approval of an AMOC, provided the steps labeled as RC can be done and the airplane can be put back in a serviceable condition. Any substitutions or changes to steps labeled as RC require approval of an AMOC.

(k) Related Information

(1) For more information about this AD, contact Stanley Chen, Aerospace Engineer, Cabin Safety and Environmental Systems Branch, ANM-150S, FAA, Seattle Aircraft Certification Office (ACO), 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: 425-917-6585; fax: 425-917-6590; email: stanley.chen@faa.gov.

(2) For service information identified in this AD, contact Boeing Commercial Airplanes, Attention: Data & Services Management, P.O. Box 3707, MC 2H-65, Seattle, WA 98124-2207; telephone 206-544-5000, extension 1; fax 206-766-5680; Internet https://www.myboeingfleet.com. You may view this referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, WA. For information on the availability of this material at the FAA, call 425-227-1221.

Start Signature

Issued in Renton, Washington, on August 4, 2014.

Jeffrey E. Duven,

Manager, Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. 2014-19248 Filed 8-13-14; 8:45 am]

BILLING CODE 4910-13-P