This PDF is the current document as it appeared on Public Inspection on 12/15/2014 at 08:45 am.
The Department of Labor (DOL) is submitting the Occupational Safety and Health Administration (OSHA) sponsored information collection request (ICR) titled, “Forging Machines,” to the Office of Management and Budget (OMB) for review and approval for continued use, without change, in accordance with the Paperwork Reduction Act of 1995 (PRA), 44 U.S.C. 3501 et seq. Public comments on the ICR are invited.
The OMB will consider all written comments that agency receives on or before January 15, 2015.
A copy of this ICR with applicable supporting documentation; including a description of the likely respondents, proposed frequency of response, and estimated total burden may be obtained free of charge from the RegInfo.gov Web site at http://www.reginfo.gov/public/do/PRAViewICR?ref_nbr=201409-1218-001 (this link will only become active on the day following publication of this notice) or by contacting Michel Smyth by telephone at 202-693-4129, TTY 202-693-8064, (these are not toll-free numbers) or by email at DOL_PRA_PUBLIC@dol.gov.
Submit comments about this request by mail or courier to the Office of Information and Regulatory Affairs, Attn: OMB Desk Officer for DOL-OSHA, Office of Management and Budget, Room 10235, 725 17th Street NW., Washington, DC 20503; by Fax: 202-395-5806 (this is not a toll-free number); or by email: OIRA_submission@omb.eop.gov. Commenters are encouraged, but not required, to send a courtesy copy of any comments by mail or courier to the U.S. Department of Labor—OASAM, Office of the Chief Information Officer, Attn: Departmental Information Compliance Management Program, Room N1301, 200 Constitution Avenue NW., Washington, DC 20210; or by email: DOL_PRA_PUBLIC@dol.gov.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Michel Smyth by telephone at 202-693-4129, TTY 202-693-8064, (these are not toll-free numbers) or by email at DOL_PRA_PUBLIC@dol.gov.End Further Info End Preamble Start Supplemental Information
This ICR seeks to extend PRA authority for the Forging Machines information collection. Under regulations 29 CFR 1910.218, it is mandatory for covered employers to conduct and to document periodic inspections of forging machines, guards, and point-of-operation protection devices and to mark manually controlled valves and switches. These requirements reduce workers' risks of death or serious injury by ensuring that forging machines used by them are in safe operating condition and that the workers are able to identify manually operated valves and switches. Occupational Safety and Health Act sections 2, 6, and 8 authorize this information collection. See 29 U.S.C. 651, 655, and 657.
This information collection is subject to the PRA. A Federal agency generally cannot conduct or sponsor a collection of information, and the public is generally not required to respond to an information collection, unless it is approved by the OMB under the PRA and displays a currently valid OMB Control Number. In addition, notwithstanding any other provisions of law, no person shall generally be subject to penalty for failing to comply with a collection of information that does not display a valid Control Number. See 5 CFR 1320.5(a) and 1320.6. The DOL obtains OMB approval for this information collection under Control Number 1218-0228.
OMB authorization for an ICR cannot be for more than three (3) years without renewal, and the current approval for this collection is scheduled to expire on January 31, 2015. The DOL seeks to extend PRA authorization for this information collection for three (3) more years, without any change to existing requirements. The DOL notes that existing information collection requirements submitted to the OMB receive a month-to-month extension while they undergo review. For additional substantive information about this ICR, see the related notice published in the Federal Register on June 30, 2014 (79 FR 36832).
Interested parties are encouraged to send comments to the OMB, Office of Information and Regulatory Affairs at the address shown in the ADDRESSES section within thirty (30) days of publication of this notice in the Federal Register. In order to help ensure appropriate consideration, comments should mention OMB Control Number 1218-0228. The OMB is particularly interested in comments that:
- Evaluate whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility;
- Evaluate the accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used;
- Enhance the quality, utility, and clarity of the information to be collected; and
- Minimize the burden of the collection of information on those who are to respond, including through the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g., permitting electronic submission of responses.
Title of Collection: Forging Machines.
OMB Control Number: 1218-0228.
Affected Public: Private sector—businesses or other for-profits and not for profit institutions.
Total Estimated Number of Respondents: 27,700.
Total Estimated Number of Responses: 1,440,788.
Total Estimated Annual Time Burden: 187,264 hours.
Total Estimated Annual Other Costs Burden: $0.Start Signature
Dated: December 10, 2014.
Departmental Clearance Officer.
[FR Doc. 2014-29389 Filed 12-15-14; 8:45 am]
BILLING CODE 4510-26-P