Skip to Content


Notice of Application for Special Permits

Document Details

Information about this document as published in the Federal Register.

Enhanced Content

Relevant information about this document from provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


Office of Hazardous Materials Safety, Pipeline and Hazardous Materials Safety Administration (PHMSA), DOT.


List of applications for special permits.


In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the “Nature of Application” portion of the table below as follows: 1—Motor vehicle, 2—Rail freight, 3—Cargo vessel, 4—Cargo aircraft only, 5—Passenger-carrying aircraft.


Comments must be received on or before February 2, 2015.

Address Comments to: Record Center, Pipeline and Hazardous Materials, Safety Administration, U.S. Department of Transportation, Washington, DC 20590.

Comments should refer to the application number and be submitted in triplicate. If confirmation of receipt of comments is desired, include a self-addressed stamped postcard showing the special permit number.

For Further Information:

Copies of the applications are available for inspection in the Records Center, East Building, PHH-30, 1200 New Jersey Avenue Southeast, Washington, DC or at

This notice of receipt of applications for special permit is published in accordance with part 107 of the Federal hazardous materials transportation law (49 U.S.C. 5117(b); 49 CFR 1.53(b)).

Start Signature

Issued in Washington, DC, on December 8, 2014.

Donald Burger,

Chief, General Approvals and Permits.

End Signature
Application No.Docket No.ApplicantRegulation(s) affectedNature of special permits thereof
16316-NGreen Auto Products International, Inc., Orlando, FL49 CFR 171.2(k), 172.202(a)(5)(iii)(b), part 172, subpart HTo authorize the transportation in commerce of certain used DOT 3AL cylinders that contain oxygen, but not necessarily in an amount qualifying as hazardous material. (modes 1, 2, 3)
16318-NTechnical Chemical Company, Cleburne, TX49 CFR 173.304(d), 173.306(a)(3)To authorize the manufacture, mark, sale and use of a non-DOT specification packaging conforming in part with specification DOT 2Q. (modes 1, 2, 3, 4, 5)
16320-NDigital Wave Corporation, Centennial, CO49 CFR 180.205(g)To authorize the extension of the service life of certain DOT-CFFC cylinders which are subjected to certain requalification and operational controls. (modes 1, 2, 3, 4, 5)
16321-NChina Oilfield Services Limited Beijing49 CFR 173.201, 173.301(f), 173.302, 173.304aTo authorize the manufacture, mark, sale, and use of certain non-DOT specification cylinders containing certain Division 2.1, 2.2, and Class 3 materials used for oil well sampling. (modes 1, 2, 3, 4)
16323-NFibre Drum Sales, Inc., Blue Island, IL49 CFR 172.203(a), 172.302(c), 180.352To authorize installation of a tested inner receptacle of a composite IBC without subjecting the inner receptacle to a leakproofness test after installation. (modes 1, 2, 3)
16331-NAirgas Specialty Products, Inc., Lawrenceville, GA49 CFR 173.301(f), 173.301(g)To authorize the transportation in commerce of DOT specification cylinders, UN cylinders, tube trailers, and multi-element gas containers containing hydrogen chloride without pressure relief devices. (modes 1, 2, 3)
Start Printed Page 105
16332-NNalco Company, Naperville, IL49 CFR 172.302(c), 178.705(c)(1)To authorize the transportation in commerce of certain existing UN 31A IBCs manufactured of stainless steel and modified with a lid manufactured of Linear Medium Density Polyethylene. (modes 1, 2, 3)
16334-NICL Performance Products LP, St. Louis, MO49 CFR 178.255-11, 178.274(h)(1)To authorize the transportation in commerce of an ISO tank with a damaged frame. (mode 1)
16337-NVolkswagen Group of America (VWGoA), Herndon, VA49 CFR 172.102(c)(2), Special Provision A54, ICAO TI Special Provision A99To authorize the transportation in commerce of certain lithium ion batteries each with a net weight greater than 35 kg by cargo aircraft only. (mode 4)
16338-NOrion Polyurethanes, sp. z.o.o. S.K.A. Dzierzoniow49 CFR 173.306(a)(3)(v)To authorize the transportation in commerce of Division 2.1 hazardous materials in certain DOT Specification 2Q non-refillable inside containers which have been tested by an alternative method in lieu of the hot water bath test. (modes 1, 2, 3, 4, 5)
16346-NFIBA Technologies, Inc., Littleton, MA49 CFR 173.301(a)(1), 178.71To authorize the manufacture, mark, sale and use of Type 2, hoop-wrapped, refillable, composite reinforced UN pressure receptacles. (modes 1, 2, 3)
End Preamble

[FR Doc. 2014-30538 Filed 12-31-14; 8:45 am]