This PDF is the current document as it appeared on Public Inspection on 02/04/2015 at 08:45 am.
Nuclear Regulatory Commission.
The U.S. Nuclear Regulatory Commission (NRC) is proposing to amend its spent fuel storage regulations by revising the Holtec International HI-STORM 100 Cask System listing within the “List of approved spent fuel storage casks” to add Amendment No. 8, Revision No. 1, to the Certificate of Compliance (CoC) No. 1014. Amendment No. 8, Revision No. 1, changes burnup/cooling time limits for thimble plug devices; changes Metamic-HT material testing requirements; changes Metamic-HT material minimum guaranteed values; and updates fuel definitions to allow boiling water reactor fuel affected by certain corrosion mechanisms with specific guidelines to be classified as undamaged fuel.
Submit comments by March 9, 2015. Comments received after this date will be considered if it is practical to do so, but the NRC staff is able to ensure consideration only for comments received on or before this date.
You may submit comments by any one of the following methods (unless this document describes a different method for submitting comments on a specific subject):
- Federal Rulemaking Web site: Go to http://www.regulations.gov and search for Docket ID NRC-2014-0233. Address questions about NRC dockets to Carol Gallagher, telephone: 301-287-3422; email: Carol.Gallagher@nrc.gov. For technical questions, please contact the individual listed in the FOR FURTHER INFORMATION CONTACT section of this document.
- Email comments to: Rulemaking.Comments@nrc.gov. If you do not receive an automatic email reply confirming receipt, then contact us at 301-415-1677.
- Fax comments to: Secretary, U.S. Nuclear Regulatory Commission at 301-415-1101.
- Mail comments to: Secretary, U.S. Nuclear Regulatory Commission, Washington, DC 20555-0001, ATTN: Rulemakings and Adjudications Staff.
- Hand deliver comments to: 11555 Rockville Pike, Rockville, Maryland 20852, between 7:30 a.m. and 4:15 p.m. (Eastern Time) Federal workdays; telephone: 301-415-1677.
For additional direction on obtaining information and submitting comments, see “Obtaining Information and Submitting Comments” in the SUPPLEMENTARY INFORMATION section of this document.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Gregory R. Trussell, Office of Nuclear Material Safety and Safeguards, U.S. Nuclear Regulatory Commission, Washington, DC 20555-0001; telephone: 301-415-6445, email: Gregory.Trussell@nrc.gov.End Further Info End Preamble Start Supplemental Information
I. Obtaining Information and Submitting Comments
A. Obtaining Information
Please refer to Docket ID NRC-2014-0233 when contacting the NRC about the availability of information for this action. You may obtain publicly-available information related to this action by any of the following methods:
- Federal Rulemaking Web site: Go to http://www.regulations.gov and search for Docket ID NRC-2014-0233.
- NRC's Agencywide Documents Access and Management System (ADAMS): You may obtain publicly-available documents online in the ADAMS Public Documents collection at http://www.nrc.gov/reading-rm/adams.html. To begin the search, select “ADAMS Public Documents” and then select “Begin Web-based ADAMS Search.” For problems with ADAMS, please contact the NRC's Public Document Room (PDR) reference staff at 1-800-397-4209, 301-415-4737, or by email to: firstname.lastname@example.org. For the convenience of the reader, instructions about obtaining materials referenced in this document are provided in the “Availability of Documents” section.
- NRC's PDR: You may examine and purchase copies of public documents at the NRC's PDR, Room O1-F21, One White Flint North, 11555 Rockville Pike, Rockville, Maryland 20852.
B. Submitting Comments
Please include Docket ID NRC-2014-0233 in the subject line of your comment submission, in order to ensure that the NRC is able to make your comment submission available to the public in this docket.
The NRC cautions you not to include identifying or contact information in comment submissions that you do not want to be publicly disclosed in your comment submission. The NRC will post all comment submissions at http://www.regulations.gov as well as enter the comment submissions into ADAMS, and the NRC does not routinely edit comment submissions to remove identifying or contact information.
If you are requesting or aggregating comments from other persons for submission to the NRC, then you should inform those persons not to include identifying or contact information that they do not want to be publicly disclosed in their comment submission. Your request should state that the NRC does not routinely edit comment submissions to remove such information before making the comment submissions available to the public or entering the comment into ADAMS.
II. Procedural Background
This proposed rule is limited to adding Amendment No. 8, Revision No. 1, which will supersede Amendment No. 8 (effective May 2, 2012, and corrected on November 16, 2012), to CoC No. 1014 to the “List of approved spent fuel storage casks,” and does not include other aspects of the Holtec International HI-STORM 100 Cask System design. Amendment No. 8 continues to be effective but is now being modified with respect to certain specified provisions, as outlined in Amendment No. 8, Revision No. 1, which apply to all general licensees using the casks for Independent Spent Fuel Storage Installations (ISFSI). Thus, Amendment No. 8, Revision No. 1, supersedes the previously issued Amendment No. 8. In requesting this Start Printed Page 6467revision, Holtec indicated that it has not manufactured any cask under CoC No. 1014, Amendment No. 8, and, consequently, no ISFSI licensee has placed such a cask into service. Because the NRC considers this action noncontroversial and routine, the NRC is publishing this proposed rule concurrently with a direct final rule in the Rules and Regulations section of this issue of the Federal Register. Adequate protection of public health and safety continues to be ensured. The direct final rule will become effective on April 21, 2015. However, if the NRC receives significant adverse comments on this proposed rule by March 9, 2015, then the NRC will publish a document that withdraws the direct final rule. If the direct final rule is withdrawn, the NRC will address the comments received in response to these proposed revisions in a subsequent final rule. Absent significant modifications to the proposed revisions requiring republication, the NRC will not initiate a second comment period on this action in the event the direct final rule is withdrawn.
A significant adverse comment is a comment where the commenter explains why the rule would be inappropriate, including challenges to the rule's underlying premise or approach, or would be ineffective or unacceptable without a change. A comment is adverse and significant if:
(1) The comment opposes the rule and provides a reason sufficient to require a substantive response in a notice-and-comment process. For example, a substantive response is required when:
(a) The comment causes the NRC staff to reevaluate (or reconsider) its position or conduct additional analysis;
(b) The comment raises an issue serious enough to warrant a substantive response to clarify or complete the record; or
(c) The comment raises a relevant issue that was not previously addressed or considered by the NRC staff.
(2) The comment proposes a change or an addition to the rule, and it is apparent that the rule would be ineffective or unacceptable without incorporation of the change or addition.
(3) The comment causes the NRC staff to make a change (other than editorial) to the rule, CoC, or Technical Specifications.
For additional procedural information, including the regulatory analysis and the environmental assessment and finding of no significant impact, see the direct final rule published in the Rules and Regulations section of this issue of the Federal Register.
Section 218(a) of the Nuclear Waste Policy Act (NWPA) of 1982, as amended, requires that “the Secretary [of the Department of Energy] shall establish a demonstration program, in cooperation with the private sector, for the dry storage of spent nuclear fuel at civilian nuclear power reactor sites, with the objective of establishing one or more technologies that the [Nuclear Regulatory] Commission may, by rule, approve for use at the sites of civilian nuclear power reactors without, to the maximum extent practicable, the need for additional site-specific approvals by the Commission.” Section 133 of the NWPA states, in part, that “[the Commission] shall, by rule, establish procedures for the licensing of any technology approved by the Commission under Section 219(a) [sic: 218(a)] for use at the site of any civilian nuclear power reactor.”
To implement this mandate, the Commission approved dry storage of spent nuclear fuel in NRC-approved casks under a general license by publishing a final rule which added a new subpart K in part 72 of Title 10 of the Code of Federal Regulations (10 CFR) entitled, “General License for Storage of Spent Fuel at Power Reactor Sites” (55 FR 29181; July 18, 1990). This rule also established a new subpart L in 10 CFR part 72 entitled, “Approval of Spent Fuel Storage Casks,” which contains procedures and criteria for obtaining NRC approval of spent fuel storage cask designs. The NRC subsequently issued a final rule on May 1, 2000 (65 FR 25241), that approved the Holtec International HI-STORM 100 Cask System design and added it to the list of NRC-approved cask designs in 10 CFR 72.214 as Coc No. 1014.
IV. Plain Writing
The Plain Writing Act of 2010 (Pub. L. 111-274) requires Federal agencies to write documents in a clear, concise, well-organized manner that also follows other best practices appropriate to the subject or field and the intended audience. The NRC has written this document to be consistent with the Plain Writing Act as well as the Presidential Memorandum, “Plain Language in Government Writing,” published June 10, 1998 (63 FR 31883). The NRC requests comment on the proposed rule with respect to clarity and effectiveness of the language used.
V. Availability of Documents
The documents identified in the following table are available to interested persons through one or more of the following methods, as indicated.
|Document||ADAMS accession No.|
|CoC No. 1014, Amendment No. 8, Revision No. 1||ML14262A478|
|Safety Evaluation Report||ML14262A476|
|Technical Specifications, Appendix A||ML14262A480|
|Technical Specifications, Appendix B||ML14262A479|
|Application (portions are non-public/proprietary)||ML13235A082|
|December 20, 2013, Application Supplement||ML14009A271|
|February 28, 2014, Application Supplement||ML14064A344|
The NRC may post materials related to this document, including public comments, on the Federal rulemaking Web site at http://www.regulations.gov under Docket ID NRC-2014-0233. The Federal rulemaking Web site allows you to receive alerts when changes or additions occur in a docket folder. To subscribe: 1) Navigate to the docket folder (NRC-2014-0233); 2) click the “Sign up for Email Alerts” link; and 3) enter your email address and select how frequently you would like to receive emails (daily, weekly, or monthly).Start List of Subjects
List of Subjects in 10 CFR Part 72
- Administrative practice and procedure
- Criminal penalties
- Manpower training programs
- Nuclear materials
- Occupational safety and health
- Radiation protection
- Reporting and recordkeeping requirements
- Security measures
- Spent fuel
For the reasons set out in the preamble and under the authority of the Atomic Energy Act of 1954, as amended; the Energy Reorganization Act of 1974, as amended; the Nuclear Waste Policy Act of 1982, as amended; and 5 U.S.C. 552 and 553; the NRC is proposing to adopt the following amendments to 10 CFR part 72.Start Part
PART 72—LICENSING REQUIREMENTS FOR THE INDEPENDENT STORAGE OF SPENT NUCLEAR FUEL, HIGH-LEVEL RADIOACTIVE WASTE, AND REACTOR-RELATED GREATER THAN CLASS C WASTEEnd Part Start Amendment Part
1. The authority citation for part 72 continues to read as follows:End Amendment Part
Section 72.44(g) also issued under Nuclear Waste Policy Act secs. 142(b) and 148(c), (d) (42 U.S.C. 10162(b), 10168(c), (d)).
Section 72.96(d) also issued under Nuclear Waste Policy Act sec. 145(g) (42 U.S.C. 10165(g)).
Subpart J also issued under Nuclear Waste Policy Act secs. 117(a), 141(h) (42 U.S.C. 10137(a), 10161(h)).
Subpart K also issued under Nuclear Waste Policy Act sec. 218(a) (42 U.S.C. 10198).Start Amendment Part
2. In § 72.214, Certificate of Compliance No. 1014 is revised to read as follows:End Amendment Part
Certificate Number: 1014.
Initial Certificate Effective Date: May 31, 2000.
Amendment Number 1 Effective Date: July 15, 2002.
Amendment Number 2 Effective Date: June 7, 2005.
Amendment Number 3 Effective Date: May 29, 2007.
Amendment Number 4 Effective Date: January 8, 2008.
Amendment Number 5 Effective Date: July 14, 2008.
Amendment Number 6 Effective Date: August 17, 2009.
Amendment Number 7 Effective Date: December 28, 2009.
Amendment Number 8 Effective Date: May 2, 2012, as corrected on November 16, 2012 (ADAMS Accession No. ML12213A170), superseded by Amendment 8, Revision 1 on April 21, 2015.
Amendment Number 8, Revision No. 1, Effective Date: April 21, 2015.
Amendment Number 9 Effective Date: March 11, 2014.
SAR Submitted by: Holtec International.
SAR Title: Final Safety Analysis Report for the HI-STORM 100 Cask System.
Docket Number: 72-1014.
Certificate Expiration Date: May 31, 2020.
Model Number: HI-STORM 100.
Dated at Rockville, Maryland, this 26 day of January.
For the Nuclear Regulatory Commission.
Mark A. Satorius,
Executive Director for Operations.
[FR Doc. 2015-02309 Filed 2-4-15; 8:45 am]
BILLING CODE 7590-01-P