Skip to Content


Reports, Forms and Recordkeeping Requirements Agency Information Collection Activity Under OMB Review

Document Details

Information about this document as published in the Federal Register.

Enhanced Content

Relevant information about this document from provides additional context. This information is not part of the official Federal Register document.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


National Highway Traffic Safety Administration (NHTSA), DOT.


Notice and request for comment on renewal of a previously approved information collection.


In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comment. A Federal Register Notice with a 60-day comment period soliciting comments on this information collection was published on April 20, 2015 (80 FR 21796).


Comments must be submitted on or before August 21, 2015.

Start Further Info


Michael Pyne, Office of Crash Avoidance Standards (NVS-123), National Highway Traffic Safety Administration, W43-457, 1200 New Jersey Avenue SE., Washington, DC 20590. Mr. Pyne can be reached at (202) 366-4171.

End Further Info End Preamble Start Supplemental Information


Title: 49 CFR 571.403, Platform lift systems for motor vehicles and 49 CFR 571.404, Platform lift installations in motor vehicles. Start Printed Page 43555

Type of Request: Renewal of a currently approved collection.

OMB Control Number: 2127-0621.

Form Number: None.

Abstract: FMVSS No. 403, Platform lift systems for motor vehicles, establishes minimum performance standards for platform lifts designed for installation on motor vehicles. Its purpose is to prevent injuries and fatalities to passengers and bystanders during the operation of platform lifts that assist wheelchair users and other persons with limited mobility in entering and leaving a vehicle. FMVSS No. 404, Platform lift installations in motor vehicles, places specific requirements on vehicle manufacturers or alterers who install platform lifts in new vehicles. Under these regulations, lift manufacturers must certify that their lifts meet the requirements of FMVSS No. 403 and must declare the certification on the owner's manual insert, the installation instructions, and the lift operating instruction label. Certification of compliance with FMVSS No. 404 is on the certification label already required of vehicle manufacturers and alterers under 49 CFR part 567. Under these two safety standards, lift manufacturers must produce: An insert that is placed in the vehicle owner's manual; installation instructions; and one or two labels that are placed near the controls for operating the lift in normal mode and in back-up mode. The requirements and our estimates of burden and cost to the lift manufacturers are given below. There is no burden to the general public.

Affected Parties: Businesses or other for-profit entities.

Respondents: Platform lift manufacturers and vehicle manufacturers/alterers that install platform lifts in new motor vehicles before first vehicle sale.

Estimated Number of Respondents: 10.

Frequency of Collection: Per each production platform lift unit.

Estimated Total Annual Burden:

Estimated burden to lift manufacturers to produce an insert for the vehicle owner's manual stating the lift's platform operating volume, maintenance schedule, and instructions regarding the lift operating procedures:

—10 manufacturers × 24 hrs. amortized over 5 yrs. = 48 hrs. per year.

Estimated burden to lift manufacturers to produce lift installation instructions identifying the vehicles on which the lift is designed to be installed:

—10 manufacturers × 24 hrs. amortized over 5 yrs. = 48 hrs. per year.

Estimated burden to lift manufacturers to produce two labels for operating and backup lift operation:

—10 manufacturers × 48 hrs. amortized over 5 yrs. = 96 hrs. per year.

Estimated cost to lift manufacturers to produce:

—Label for operating instructions—27,398 lifts × $0.13 per label = $3,561.74.

—Label for backup operations—27,398 lifts × $0.13 per label = $3,561.74.

—Owner's manual insert—27,398 lifts ×$0.04 per page × 1 page = $1,095.92.

—Installation instructions—27,398 lifts × $0.04 per page × 1 page = $1,095.92.

Although lift installation instructions are considerably more than one page, lift manufacturers already provide lift installation instructions in the normal course of business and one additional page should be adequate to allow the inclusion of FMVSS-specific information.

Total estimated annual cost = $9,315.32.

Total estimated hour burden per year = 192 hours.

Addressee: Send comments regarding the burden estimate, including suggestions for reducing the burden, to the Office of Management and Budget, Attention: Desk Officer for the Office of the Secretary of Transportation, 725 17th Street NW., Washington, DC 20503.

Comments are invited on: Whether the proposed collection of information is necessary for the proper performance of the functions of the Department, including whether the information will have practical utility; the accuracy of the Department's estimate of the burden of the proposed information collection; ways to enhance the quality, utility and clarity of the information to be collected; and ways to minimize the burden of the collection of information on respondents, including the use of automated collection techniques or other forms of information technology.

Start Authority

Authority: The Paperwork Reduction Act of 1995; 44 U.S.C. chapter 35, as amended; and 49 CFR 1:48.

End Authority Start Signature

Raymond R. Posten,

Associate Administrator for Rulemaking.

End Signature End Supplemental Information

[FR Doc. 2015-17931 Filed 7-21-15; 8:45 am]