AGENCY:

Enforcement and Compliance, International Trade Administration, Department of Commerce.

SUMMARY:

On October 7, 2015, the Department of Commerce (the Department) published the Preliminary Results of the administrative review of the antidumping duty order on certain lined paper products (CLPP) from India in accordance with section 751(a)(1)(B) of the Tariff Act of 1930, as amended (the Act).^[1] The period of review (POR) is September 1, 2013, through August 31, 2014. This review covers two ( printed page 5987) mandatory respondents, Kokuyo Riddhi Paper Products Private Limited ^[2] (Kokuyo Riddhi) and SAB International (SAB), and one respondent not individually examined, Navneet Publications (India) Ltd./Navneet Education Limited (Navneet).^[3] We invited interested parties to comment on the Preliminary Results. We received no comments or hearing requests from any interested parties. Therefore, we have made no changes for the final results. The final weighted-average dumping margins for Kokuyo Riddhi, SAB and Navneet are listed below in the section titled “Final Results of the Review.”

DATES:

Effective Date: February 4, 2016.

FOR FURTHER INFORMATION CONTACT:

Cindy Robinson or George McMahon, AD/CVD Operations, Office III, Enforcement and Compliance, International Trade Administration, U.S. Department of Commerce, 14th Street and Constitution Avenue NW., Washington, DC 20230; telephone (202) 482-3797 or (202) 482-1167, respectively.

Background

On October 7, 2015, the Department published the Preliminary Results. In accordance with 19 CFR 351.309(c)(1)(ii), we invited interested parties to comment on our Preliminary Results. We received no comments or requests for a hearing from any party. The Department conducted this administrative review in accordance with section 751(a)(2) of the Act.

Scope of the Order

The scope of this order includes certain lined paper products, typically school supplies (for purposes of this scope definition, the actual use of or labeling these products as school supplies or non-school supplies is not a defining characteristic) composed of or including paper that incorporates straight horizontal and/or vertical lines on ten or more paper sheets (there shall be no minimum page requirement for looseleaf filler paper) including but not limited to such products as single- and multi-subject notebooks, composition books, wireless notebooks, looseleaf or glued filler paper, graph paper, and laboratory notebooks, and with the smaller dimension of the paper measuring 6 inches to 15 inches (inclusive) and the larger dimension of the paper measuring 8 3/4 inches to 15 inches (inclusive). Page dimensions are measured size (not advertised, stated, or “tear-out” size), and are measured as they appear in the product ( i.e., stitched and folded pages in a notebook are measured by the size of the page as it appears in the notebook page, not the size of the unfolded paper). However, for measurement purposes, pages with tapered or rounded edges shall be measured at their longest and widest points. Subject lined paper products may be loose, packaged or bound using any binding method (other than case bound through the inclusion of binders board, a spine strip, and cover wrap). Subject merchandise may or may not contain any combination of a front cover, a rear cover, and/or backing of any composition, regardless of the inclusion of images or graphics on the cover, backing, or paper. Subject merchandise is within the scope of this order whether or not the lined paper and/or cover are hole punched, drilled, perforated, and/or reinforced. Subject merchandise may contain accessory or informational items including but not limited to pockets, tabs, dividers, closure devices, index cards, stencils, protractors, writing implements, reference materials such as mathematical tables, or printed items such as sticker sheets or miniature calendars, if such items are physically incorporated, included with, or attached to the product, cover and/or backing thereto.

Specifically excluded from the scope of this order are:

• Unlined copy machine paper;
• writing pads with a backing (including but not limited to products commonly known as “tablets,” “note pads,” “legal pads,” and “quadrille pads”), provided that they do not have a front cover (whether permanent or removable). This exclusion does not apply to such writing pads if they consist of hole-punched or drilled filler paper;
• three-ring or multiple-ring binders, or notebook organizers incorporating such a ring binder provided that they do not include subject paper;
• index cards;
• printed books and other books that are case bound through the inclusion of binders board, a spine strip, and cover wrap;
• newspapers;
• pictures and photographs;
• desk and wall calendars and organizers (including but not limited to such products generally known as “office planners,” “time books,” and “appointment books”);
• telephone logs;
• address books;
• columnar pads & tablets, with or without covers, primarily suited for the recording of written numerical business data;
• lined business or office forms, including but not limited to: pre-printed business forms, lined invoice pads and paper, mailing and address labels, manifests, and shipping log books;
• lined continuous computer paper;
• boxed or packaged writing stationary (including but not limited to products commonly known as “fine business paper,” “parchment paper”, and “letterhead”), whether or not containing a lined header or decorative lines;
• Stenographic pads (“steno pads”), Gregg ruled (“Gregg ruling” consists of a single- or double-margin vertical ruling line down the center of the page. For a six-inch by nine-inch stenographic pad, the ruling would be located approximately three inches from the left of the book), measuring 6 inches by 9 inches.

Also excluded from the scope of this order are the following trademarked products:

• Fly ^TM lined paper products: A notebook, notebook organizer, loose or glued note paper, with papers that are printed with infrared reflective inks and readable only by a Fly ^TM pen-top computer. The product must bear the valid trademark Fly ^TM (products found to be bearing an invalidly licensed or used trademark are not excluded from the scope).
• Zwipes ^TM: A notebook or notebook organizer made with a blended polyolefin writing surface as the cover and pocket surfaces of the notebook, suitable for writing using a specially-developed permanent marker and erase system (known as a Zwipes ^TM pen). This system allows the marker portion to mark the writing surface with a permanent ink. The eraser portion of the marker dispenses a solvent capable of solubilizing the permanent ink allowing the ink to be removed. The product must bear the valid trademark Zwipes ^TM (products found to be bearing an invalidly licensed or used trademark are not excluded from the scope).
• FiveStar®Advance ^TM: A notebook or notebook organizer bound by a continuous spiral, or helical, wire and with plastic front and rear covers made of a blended polyolefin plastic material ( printed page 5988) joined by 300 denier polyester, coated on the backside with PVC (poly vinyl chloride) coating, and extending the entire length of the spiral or helical wire. The polyolefin plastic covers are of specific thickness; front cover is 0.019 inches (within normal manufacturing tolerances) and rear cover is 0.028 inches (within normal manufacturing tolerances). Integral with the stitching that attaches the polyester spine covering, is captured both ends of a 1” wide elastic fabric band. This band is located 2 3/8 ″ from the top of the front plastic cover and provides pen or pencil storage. Both ends of the spiral wire are cut and then bent backwards to overlap with the previous coil but specifically outside the coil diameter but inside the polyester covering. During construction, the polyester covering is sewn to the front and rear covers face to face (outside to outside) so that when the book is closed, the stitching is concealed from the outside. Both free ends (the ends not sewn to the cover and back) are stitched with a turned edge construction. The flexible polyester material forms a covering over the spiral wire to protect it and provide a comfortable grip on the product. The product must bear the valid trademarks FiveStar®Advance ^TM (products found to be bearing an invalidly licensed or used trademark are not excluded from the scope).
• FiveStar Flex ^TM: A notebook, a notebook organizer, or binder with plastic polyolefin front and rear covers joined by 300 denier polyester spine cover extending the entire length of the spine and bound by a 3-ring plastic fixture. The polyolefin plastic covers are of a specific thickness; front cover is 0.019 inches (within normal manufacturing tolerances) and rear cover is 0.028 inches (within normal manufacturing tolerances). During construction, the polyester covering is sewn to the front cover face to face (outside to outside) so that when the book is closed, the stitching is concealed from the outside. During construction, the polyester cover is sewn to the back cover with the outside of the polyester spine cover to the inside back cover. Both free ends (the ends not sewn to the cover and back) are stitched with a turned edge construction. Each ring within the fixture is comprised of a flexible strap portion that snaps into a stationary post which forms a closed binding ring. The ring fixture is riveted with six metal rivets and sewn to the back plastic cover and is specifically positioned on the outside back cover. The product must bear the valid trademark FiveStar Flex ^TM (products found to be bearing an invalidly licensed or used trademark are not excluded from the scope).

Merchandise subject to this order is typically imported under headings 4811.90.9035, 4811.90.9080, 4820.30.0040, 4810.22.5044, 4811.90.9050, 4811.90.9090, 4820.10.2010, 4820.10.2020, 4820.10.2030, 4820.10.2040, 4820.10.2050, 4820.10.2060, and 4820.10.4000 of the HTSUS. The HTSUS headings are provided for convenience and customs purposes; however, the written description of the scope is dispositive.

Final Results of the Review

As noted above, the Department received no comments concerning the Preliminary Results. As there are no changes from, or comments upon, the Preliminary Results, the Department finds that there is no reason to modify its analysis and calculations. Accordingly, no decision memorandum accompanies this Federal Register notice. For further details of the issues addressed in this proceeding, see the Preliminary Results and the accompanying Preliminary Decision Memorandum.

The final weighted-average dumping margins for the POR are as follows:

 

Assessment Rates

The Department shall determine and Customs and Border Protection (CBP) shall assess antidumping duties on all appropriate entries in this review, in accordance with section 751(a)(2)(C) of the Act.^[5] For any individually examined respondents whose weighted-average dumping margin is above de minimis, we calculated importer-specific ad valorem duty assessment rates based on the ratio of the total amount of dumping calculated for the importer's examined sales to the total entered value of those same sales in accordance with 19 CFR 351.212(b)(1). Upon issuance of the final results of this administrative review, if any importer-specific assessment rates calculated in the final results are above de minimis ( i.e., at or above 0.5 percent), the Department will issue instructions directly to CBP to assess antidumping duties on appropriate entries.

In accordance with the Department's “automatic assessment” practice,^[6] for entries of subject merchandise during the POR produced by the respondent for which it did not know its merchandise was destined for the United States, we will instruct CBP to liquidate unreviewed entries at the all-others rate if there is no rate for the intermediate company(ies) involved in the transaction. For a full discussion of this practice, see the Automatic Assessment Clarification. We intend to issue instructions to CBP 15 days after publication of the final results of this review.

Cash Deposit Requirements

The following cash deposit requirements will be effective upon publication of the notice of final results of administrative review for all shipments of subject merchandise entered, or withdrawn from warehouse, for consumption on or after the publication date of the final results of this administrative review, as provided by section 751(a)(2) of the Act: (1) The ( printed page 5989) cash deposit rate for Kokuyo Riddhi, SAB and Navneet will be the rate established in the final results of this administrative review; (2) for merchandise exported by manufacturers or exporters not covered in this administrative review but covered in a prior segment of the proceeding, the cash deposit rate will continue to be the company specific rate published for the most recently completed segment of this proceeding; (3) if the exporter is not a firm covered in this review, a prior review, or the original investigation, but the manufacturer is, the cash deposit rate will be the rate established for the most recently completed segment of this proceeding for the manufacturer of the subject merchandise; and (4) the cash deposit rate for all other manufacturers or exporters will continue to be 3.91 percent, the all-others rate established in the original antidumping duty investigation.^[7] These cash deposit requirements, when imposed, shall remain in effect until further notice.

Notification to Importers

This notice also serves as a final reminder to importers of their responsibility under 19 CFR 351.402(f) to file a certificate regarding the reimbursement of antidumping and/or countervailing duties prior to liquidation of the relevant entries during the POR. Failure to comply with this requirement could result in the Department's presumption that reimbursement of antidumping and/or countervailing duties occurred and the subsequent assessment of doubled antidumping duties.

Administrative Protective Order

This notice also serves as a reminder to parties subject to administrative protective orders (APO) of their responsibility concerning the return or destruction of proprietary information disclosed under APO in accordance with 19 CFR 351.305(a)(3), which continues to govern business proprietary information in this segment of the proceeding. Timely written notification of the return/destruction of APO materials, or conversion to judicial protective order, is hereby requested. Failure to comply with the regulations and the terms of an APO is a sanctionable violation.

We are issuing and publishing this notice in accordance with sections 751(a)(1) and 777(i)(1) of the Act and 19 CFR 351.213(h).