Skip to Content

Notice

Certain Carbon and Alloy Steel Cut-to-Length Plate From France: Correction to the Amended Preliminary Determination of Sales at Less Than Fair Value

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble Start Printed Page 90780

AGENCY:

Enforcement and Compliance, International Trade Administration, Department of Commerce.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Brandon Custard or Terre Keaton Stefanova, AD/CVD Operations, Office II, Enforcement and Compliance, International Trade Administration, U.S. Department of Commerce, 1401 Constitution Avenue NW., Washington, DC 20230; telephone: (202) 482-1823 or (202) 482-1280, respectively.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

On December 2, 2016, the Department of Commerce (the Department) published in the Federal Register the amended preliminary determination in the less than fair value investigation for certain carbon and alloy steel cut-to-length plate from France.[1]

The Department is issuing this notice to correct two inadvertent errors in the Amended Preliminary Determination. First, the Department listed the case number as A-427-428. The correct case number is A-427-828. Second, the Department stated an incorrect all-others rate of 6.33 percent.[2] The correct all-others rate is 6.34 percent, as stated in the calculation memorandum accompanying the Amended Preliminary Determination.[3] Therefore, the Department is hereby correcting the Amended Preliminary Determination.

This correction to the amended preliminary determination of sales at less than fair value is issued and published in accordance with sections 733(f) and 777(i)(1) of the Tariff Act of 1930, as amended.

Start Signature

Dated: December 9, 2016.

Paul Piquado,

Assistant Secretary for Enforcement and Compliance.

End Signature End Supplemental Information

Footnotes

1.  See Certain Carbon and Alloy Steel Cut-to-Length Plate From France: Amended Preliminary Determination of Sales at Less Than Fair Value, 81 FR 87019 (December 2, 2016) (Amended Preliminary Determination).

Back to Citation

3.  See Memorandum to the file from Terre Keaton Stefanova entitled, “Amended Preliminary Determination Margin Calculation for Dillinger France S.A. for the Antidumping Duty Investigation of Certain Carbon and Alloy Steel Cut-To-Length Plate from France,” dated November 29, 2016, at 4.

Back to Citation

[FR Doc. 2016-30148 Filed 12-14-16; 8:45 am]

BILLING CODE 3510-DS-P