This site displays a prototype of a “Web 2.0” version of the daily Federal Register. It is not an official legal edition of the Federal Register, and does not replace the official print version or the official electronic version on GPO’s govinfo.gov.
The documents posted on this site are XML renditions of published Federal Register documents. Each document posted on the site includes a link to the corresponding official PDF file on govinfo.gov. This prototype edition of the daily Federal Register on FederalRegister.gov will remain an unofficial informational resource until the Administrative Committee of the Federal Register (ACFR) issues a regulation granting it official legal status. For complete information about, and access to, our official publications and services, go to About the Federal Register on NARA's archives.gov.
The OFR/GPO partnership is committed to presenting accurate and reliable regulatory information on FederalRegister.gov with the objective of establishing the XML-based Federal Register as an ACFR-sanctioned publication in the future. While every effort has been made to ensure that the material on FederalRegister.gov is accurately displayed, consistent with the official SGML-based PDF version on govinfo.gov, those relying on it for legal research should verify their results against an official edition of the Federal Register. Until the ACFR grants it official status, the XML rendition of the daily Federal Register on FederalRegister.gov does not provide legal notice to the public or judicial notice to the courts.
FederalRegister.gov retrieves relevant information about this document from Regulations.gov to provide users with additional context. This information is not part of the official Federal Register document.
National Highway Traffic Safety Administration (NHTSA), Department of Transportation (DOT).
Notice and request for comments on a reinstatement with change of a previously approved information collection.
NHTSA invites public comments about our intention to request approval from the Office of Management and Budget (OMB) for a reinstatement of a previously approved information collection. Before a federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. This document describes an Information Collection Request (ICR) for which NHTSA intends to seek OMB approval on labeling requirements under 49 CFR 571.403, Platform lift systems for motor vehicles, and 49 CFR 571.404, Platform lift installations in motor vehicles.
Comments must be submitted on or before June 8, 2026.
You may submit comments identified by the Docket No. NHTSA-2026-0661 through any of the following methods:
Instructions: All submissions must include the agency name and docket number for this notice. Note that all comments received will be posted without change to http://www.regulations.gov, including any personal information provided. Please see the Privacy Act heading below.
Privacy Act: Anyone is able to search the electronic form of all comments received into any of our dockets by the name of the individual submitting the comment (or signing the comment, if submitted on behalf of an association, business, labor union, etc.). You may review DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78) or you may visit https://www.transportation.gov/privacy.
Docket: For access to the docket to read background documents or comments received, go to http://www.regulations.gov or the street address listed above. Follow the online instructions for accessing the dockets via internet.
For additional information or access to background documents, contact David V. Freeman, at (202) 366-1810, Office of Rulemaking (NRM230), National Highway Traffic Safety Administration, U.S. Dept. of Transportation, 1200 New Jersey Avenue SE, Room W43-431, Washington, DC 20590. Please identify the relevant collection of information by referring to its OMB Control Number.
Under the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), before an agency submits a proposed collection of information to OMB for approval, it ( printed page 17827) must first publish a document in the Federal Register providing a 60-day comment period and otherwise consult with members of the public and affected agencies concerning each proposed collection of information. The OMB has promulgated regulations describing what must be included in such a document. Under OMB's regulation (at 5 CFR 1320.8(d)), an agency must ask for public comment on the following: (a) whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility; (b) the accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used; (c) how to enhance the quality, utility, and clarity of the information to be collected; and (d) how to minimize the burden of the collection of information on those who are to respond, including the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g., permitting electronic submission of responses. In compliance with these requirements, NHTSA asks for public comments on the following proposed collection of information for which the agency is seeking approval from OMB.
Title:49 CFR 571.403, Platform lift systems for motor vehicles, and 49 CFR 571.404, Platform lift installations in motor vehicles.
OMB Control Number: 2127-0621.
Form Number(s): N/A.
Type of Request: Reinstatement with change of a previously approved information collection.
Type of Review Requested: Regular.
Requested Expiration Date of Approval: Three years from date of approval.
Summary of the Collection of Information: Federal Motor Vehicle Safety Standard (FMVSS) No. 403, Platform lift systems for motor vehicles, establishes minimum performance standards for platform lifts intended for installation in motor vehicles to assist wheelchair users and other persons of limited mobility in entering and exiting a vehicle. The standard's purpose is to prevent injuries and fatalities to passengers and bystanders during the operation of platform lifts. The related standard, FMVSS No. 404, Platform lift installations in motor vehicles, establishes specific requirements for vehicle manufacturers or alterers that install platform lifts in new vehicles.
Lift manufacturers must certify that their lifts meet the requirements of FMVSS No. 403 and must declare in the owner's manual, in the installation instructions, and on the operating instruction label that the lift is certified. Certification of compliance with FMVSS No. 404 is included on the vehicle certification label required on all motor vehicles under 49 CFR part 567. Both FMVSS No. 403 and FMVSS No. 404 contain requirements related to information collections.
FMVSS No. 403 requires lift manufacturers to produce an insert that is placed in the vehicle owner's manual and lift installation instructions. In addition, lift manufacturers must affix either one or two labels to be placed near the controls for the lift. The latter illustrate and describe procedures for operating the lift. Our estimates of burden and cost to lift manufacturers to meet these requirements are described below. FMVSS No. 404 requires manufacturers or alterers that install platform lifts to insert the instructions provided by the lift manufacturer into the vehicle owners' manuals and ensure that labels with lift operating procedures are affixed to a location adjacent to the controls.
Description of the Need for the Information and Proposed Use of the Information: The information is used by:
Affected Public: Platform lift manufacturers and vehicle manufacturers or alterers that install platform lifts in motor vehicles prior to first vehicle sale. There is no burden to the general public.
Estimated Number of Respondents: Ten.
NHTSA estimates that there are ten platform lift manufacturers doing business at a given time. Platform lift manufacturers typically have a design cycle of approximately five years. Therefore, there are aspects of the information collection that only require the manufacturers to incur burden every five years, such as changing the owner's manual inserts and labels. However, other aspects of the information collection, such as printing the inserts and labeling the lifts, require manufacturers to incur burden every year.
Frequency: On occasion.
Estimated Total Annual Burden Hours: 1,562 hours.
NHTSA estimates that a total of ten lift manufacturers will incur 1,562 hours of burden annually. This estimate is comprised of time to make changes to required language and the time to distribute that information by affixing labels or placards, placing inserts into owners' manuals, and providing installation instructions.
NHTSA estimates that every year approximately two lift manufacturers will need to change the language of the insert for the vehicle owners' manual stating the lift's platform operating volume, maintenance schedule, and operating procedures. NHTSA estimates that it will take manufacturers approximately 24 hours to make those changes. Therefore, NHTSA estimates that changes to the owners' manual inserts will take 48 hours annually (two manufacturers × 24 hrs = 48 hours per year). NHTSA estimates that every year approximately two manufacturers will need to change the installation instructions identifying the types of vehicles on which each lift is designed to be installed. NHTSA estimates that it will take manufacturers approximately 24 hours to make those changes. Therefore, NHTSA estimates that changes to the installation instructions will take 48 hours annually (two manufacturers × 24 hrs = 48 hours per year). NHTSA estimates that every year approximately two manufacturers will need to make changes to labels or placards which identify the operating functions of the lift. NHTSA estimates that it will take manufacturers approximately 24 hours to make those changes. Therefore, NHTSA estimates that changes to the labels or placards for lift functions will take 48 hours annually (two manufacturers × 24 hours = 48 hours per year). NHTSA estimates that every year approximately two lift manufacturers will need to make changes to labels and placards detailing back-up operating procedures. NHTSA estimates that it will take manufacturers approximately 24 hours to make those changes. Therefore, NHTSA estimates that changes to the language of labels or placards for back-up operating procedures will take 48 hours annually (two manufacturers × 24 hours = 48 hours per year). In addition to making periodic changes to the wording of the owners' manual inserts, installation instructions, label or placard for lift operating procedures, and the label or ( printed page 17828) placard for lift back-up operation, lift manufacturers also incur burden associated with distributing that information by affixing labels or placards, placing inserts into owners' manuals, and providing installation instructions. NHTSA estimates that there will be 27,398 lifts manufactured in each of the next three years. NHTSA estimates that distributing the required information will take approximately 3 minutes per lift or approximately 1,370 hours for all lifts annually (27,398 lifts × 3 minutes per lift = 82,194 minutes, 82,194 minutes ÷ 60 = 1,370 hours).
| Lift manufacturers | Hours to make change | Annual hours | |
|---|---|---|---|
| Per Year Insert Language | 2 | 24 | 48 |
| Per Year Install Instruct | 2 | 24 | 48 |
| Per Year Label Change/Operating | 2 | 24 | 48 |
| Per Year Label Change/Back-up | 2 | 24 | 48 |
| Lifts— each year next 3 years | Mins. to distribute | Total hours | |
|---|---|---|---|
| Distribution | 27,398 | 3 | 1,370 |
| Estimated Total Burden Hours | 1,562 |
Estimated Cost for This Information Collection: The cost of this collection of information will comprise printing costs. NHTSA's estimate of printing costs can be broken down as follows:
Based on this breakdown, NHTSA estimates the total printing cost associated with this information collection is $11,507.16 annually.
| Lifts— each year next 3 years | Per unit | Total cost | |
|---|---|---|---|
| Owner's Manual Insert | 27,398 | $0.05 | $1,369.90 |
| Install Instructions | 27,398 | 0.05 | 1,369.90 |
| Label Change/Operating Procedure | 27,398 | 0.16 | 4,383.68 |
| Label Change/Back-up Operation | 27,398 | 0.16 | 4,383.68 |
| Estimated Annual Printing Cost for This Information Collection | 11,507.16 |
Public Comments Invited: The OMB has promulgated regulations describing what must be included in such a document. Under OMB's regulation at 5 CFR 1320.8(d), an agency must ask for public comment on the following: (1) Whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility. (2) the accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used; (3) how to enhance the quality, utility, and clarity of the information to be collected; and (4) how to minimize the burden of the collection of information on those who are to respond, including the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g., permitting electronic submission of responses.
Authority: The Paperwork Reduction Act of 1995; 44 U.S.C. chapter 35; as amended; 49 CFR 1.49; and DOT Order 1351.29A.
Jane Doherty,
Acting Associate Administrator for Rulemaking.
[FR Doc. 2026-06737 Filed 4-7-26; 8:45 am]
BILLING CODE 4910-59-P
2 comments have been received at Regulations.gov.
Agencies review all submissions and may choose to redact, or withhold, certain submissions (or portions thereof). Submitted comments may not be available to be read until the agency has approved them.