Federal Aviation Administration (FAA), Department of Transportation (DOT).
Final rule; request for comments.
We are adopting a new airworthiness directive (AD) for all Dassault Aviation Model FALCON 2000EX airplanes. This AD requires revising the airplane flight manual to include a procedure for addressing minimum fan speed rotation (N1) values during stand-alone engine anti-ice system operation for engines equipped with certain air inlets. This AD was prompted by a quality review of recently delivered airplanes which identified a manufacturing deficiency of some engine air inlet anti-ice piccolo tubes. We are issuing this AD to detect and correct reduced performance of the engine anti-ice protection system, leading to ice accretion and ingestion into the engines, which could result in dual engine power loss and consequent reduced controllability of the airplane.
This AD becomes effective June 30, 2015.
We must receive comments on this AD by August 14, 2015.
You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
•
•
•
•
You may examine the AD docket on the Internet at
Tom Rodriguez, Aerospace Engineer, International Branch, ANM–116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057–3356; telephone 425–227–1137; fax 425–227–1149.
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, has issued EASA Emergency Airworthiness Directive 2015–0102–E, dated June 8, 2015 (referred to after this as the Mandatory Continuing Airworthiness Information, or “the MCAI”), to correct an unsafe condition for all Dassault Aviation Model FALCON 2000EX airplanes. The MCAI states:
A quality review of recently delivered aeroplanes identified a manufacturing deficiency of some engine air inlet anti ice piccolo tubes.
This condition, if not detected and corrected, could lead to reduced performance of the engine anti-ice protection system, with consequent ice accretion and ingestion, possibly resulting in dual engine power loss and reduced control of an aeroplane.
The Falcon 2000EX Aircraft Flight Manual (AFM) contains a procedure 4–200–05, “Operations in Icing Conditions”, addressing minimum fan speed rotation (N1) during combined operation of wing anti-ice and engine anti-ice systems. However, the AFM does not specify minimum N1 values for stand-alone engine anti-ice system operation. The subsequent investigation demonstrated that the operation of an engine at or above the minimum N1 value applicable for combined wing and engine anti-ice operations, provides efficient engine anti ice performance during stand-alone engine anti-ice operation, for engines equipped with an air inlet affected by the manufacturing deficiency.
For the reasons described above, this [EASA] AD requires amendment of the applicable AFM which can be removed (or is not applicable) for aeroplanes having both engine air inlet[s] marked “NRK” on the associated data plate.
This [EASA] AD is considered to be an interim measure and further AD action may follow.
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are issuing this AD because we evaluated all pertinent information and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design.
An unsafe condition exists that requires the immediate adoption of this AD. The FAA has found that the risk to the flying public justifies waiving notice and comment prior to adoption of this rule because the identified unsafe condition could result in engine inlet ice accretion with possible ice separation in volumes beyond engine ingestion capability. These conditions could lead to engine damage or engine shutdown. Therefore, we determined that notice and opportunity for public comment before issuing this AD are impracticable and that good cause exists for making this amendment effective in fewer than 30 days.
This AD is a final rule that involves requirements affecting flight safety, and we did not precede it by notice and opportunity for public comment. We invite you to send any written relevant data, views, or arguments about this AD. Send your comments to an address listed under the
We will post all comments we receive, without change, to
We estimate that this AD affects 120 airplanes of U.S. registry.
We also estimate that it will take about 1 work-hour per product to comply with the basic requirements of this AD. The average labor rate is $85 per work-hour. Based on these figures, we estimate the cost of this AD on U.S. operators to be $10,200, or $85 per product.
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify that this AD:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Accordingly, under the authority delegated to me by the Administrator, the FAA amends 14 CFR part 39 as follows:
49 U.S.C. 106(g), 40113, 44701.
This AD becomes effective June 30, 2015.
None.
This AD applies to all Dassault Aviation Model FALCON 2000EX airplanes, certificated in any category.
Air Transport Association (ATA) of America Code 30, Ice and Rain Protection.
This AD was prompted by a quality review of recently delivered airplanes which identified a manufacturing deficiency of some engine air inlet anti-ice piccolo tubes. We are issuing this AD to detect and correct reduced performance of the engine anti-ice protection system, leading to ice accretion and ingestion into the engines, which could result in dual engine power loss and consequent reduced controllability of the airplane.
Comply with this AD within the compliance times specified, unless already done.
(1) Within 10 flight cycles after the effective date of this AD: Revise the Limitations Section of the Dassault Falcon 2000EX AFM to include the statement in figure 1 to this paragraph. This may be done by inserting a copy of this AD in the AFM. When a statement identical to that in figure 1 to this paragraph has been included in the general revisions of the AFM, the general revisions may be inserted into the AFM, and the copy of this AD may be removed from the AFM.
(2) Airplanes on which the air engine inlet on both engines has a mark “NRK” on the associated data plate are not affected by the requirements in paragraph (g)(1) of this AD.
Engine air inlets which have been refurbished and comply with the design standard are marked as “NRK” on the air inlet data plate.
The following provisions also apply to this AD:
(1)
(2)
Refer to Mandatory Continuing Airworthiness Information (MCAI) EASA Emergency Airworthiness Directive 2015–0102–E, dated June 8, 2015, for related information. You may examine the MCAI on the Internet at
None.