Federal Aviation Administration (FAA), DOT.
Notice of proposed rulemaking (NPRM).
We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model CL–600–2B16 (CL–601–3A, CL–601–3R, and CL–604 Variants) airplanes. This proposed AD was prompted by a report indicating that the lanyard length of the passenger drop down oxygen masks is too long. This proposed AD would require replacing the existing oxygen mask lanyards with lanyards of the correct length. We are proposing this AD to address the unsafe condition on these products.
We must receive comments on this proposed AD by July 6, 2017.
You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods:
•
•
•
•
For service information identified in this NPRM, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; telephone 514–855–5000; fax 514–855–7401; email
You may examine the AD docket on the Internet at
Cesar A. Gomez, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE–171, FAA, New York Aircraft Certification Office (ACO), 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516–228–7318; fax 516–794–5531.
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the
We will post all comments we receive, without change, to
Transport Canada Civil Aviation (TCCA), which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF–2016–15, dated June 1, 2016 (referred to after this as the Mandatory Continuing Airworthiness Information, or ”the MCAI”), to correct an unsafe condition for certain Bombardier, Inc., Model CL–600–2B16 (CL–601–3A, CL–601–3R, and CL–604 Variants) airplanes. The MCAI states:
Bombardier (BA) has determined that the lanyard length of the passenger drop down oxygen masks is too long and may cause the safety pin tethered to the opposite end of the lanyard to remain engaged in the oxygen flow mechanism when the mask is pulled to the passenger's face. In an emergency situation where oxygen is required, it is possible that certain passengers may not receive oxygen
[Bombardier] has issued service bulletin (SB) 605–35–003 to replace the existing lanyards in the passenger oxygen box assemblies with lanyards of the correct length. Incorporation of this [Bombardier service bulletin] will restore the proper oxygen flow functionality to the passenger oxygen masks in the event of an emergency.
This [Canadian] AD mandates the incorporation of [Bombardier service bulletin] 605–35–003.
You may examine the MCAI in the AD docket on the Internet at
Bombardier, Inc., issued Service Bulletin 605–35–003, Revision 02, dated April 18, 2016. This service information describes procedures for replacing the existing oxygen mask lanyards with lanyards of the correct length. This service information is reasonably available because the interested parties have access to it through their normal course of business or by the means identified in the
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
We estimate that this proposed AD affects 120 airplanes of U.S. registry.
We estimate the following costs to comply with this proposed AD:
According to the manufacturer, some of the costs of this proposed AD may be covered under warranty, thereby reducing the cost impact on affected individuals. We do not control warranty coverage for affected individuals. As a result, we have included all costs in our cost estimate.
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
Air transportation, Aircraft, Aviation safety, Incorporation by reference, Safety.
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
49 U.S.C. 106(g), 40113, 44701.
We must receive comments by July 6, 2017.
None.
This AD applies to Bombardier, Inc., Model CL–600–2B16 (CL–601–3A, CL–601–3R, and CL–604 Variants) airplanes, certificated in any category, serial numbers 5702 through 5705 inclusive, 5707, 5709, 5710, 5712, 5714, 5715, 5718, 5719, 5722, 5723, 5725, 5727, 5728, 5731 through 5733 inclusive, 5735, 5736, 5740, 5742, 5743, 5745, 5746, 5748 through 5750 inclusive, 5752 through 5754 inclusive, 5756 through 5758 inclusive, 5760 through 5762 inclusive, 5764 through 5766 inclusive, 5768 through 5770 inclusive, 5772 through 5774 inclusive, 5776 through 5780 inclusive, 5782 through 5787 inclusive, 5790, 5791, 5793, 5794, 5796, 5797, 5799, 5800, 5802, 5803, 5805 through 5814 inclusive, 5816, 5818 through 5820 inclusive, 5823 through 5829 inclusive, 5831 through 5853 inclusive, 5856, 5857, 5859 through 5863 inclusive, 5865 through 5874 inclusive, 5876 through 5881 inclusive, 5883 through 5888 inclusive, 5890 through 5894 inclusive, 5896 through 5898 inclusive, 5900 through 5906 inclusive, 5908 through 5911 inclusive, 5913 through 5938 inclusive, 5940 through 5947 inclusive, 5949 through 5980 inclusive, 5982 through 5985 inclusive, 5987, and 5988.
Air Transport Association (ATA) of America Code 35, Oxygen.
This AD was prompted by a report indicating that the lanyard length of the passenger drop down oxygen masks is too long. The length of the oxygen mask lanyard might cause the safety pin tethered to the opposite end of the lanyard to remain
Comply with this AD within the compliance times specified, unless already done.
Within 2,400 flight hours or 60 months, whichever occurs first after the effective date of this AD, replace the existing lanyards in the passenger oxygen box assemblies with lanyards of the correct length, in accordance with the Accomplishment Instructions of Bombardier Service Bulletin 605–35–003, Revision 02, dated April 18, 2016.
This paragraph provides credit for actions required by paragraph (g) of this AD, if those actions were performed before the effective date of this AD using Bombardier Service Bulletin 605–35–003, dated January 28, 2016; or Bombardier Service Bulletin 605–35–003, Revision 01, dated February 10, 2016.
The following provisions also apply to this AD:
(1)
(2)
(1) Refer to Mandatory Continuing Airworthiness Information (MCAI) Canadian Airworthiness Directive CF–2016–15, dated June 1, 2016, for related information. This MCAI may be found in the AD docket on the Internet at
(2) For more information about this AD, contact Cesar A. Gomez, Aerospace Engineer, Airframe and Mechanical Systems Branch, ANE–171, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, NY 11590; telephone 516–228–7318; fax 516–794–5531.
(3) For service information identified in this AD, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; telephone 514–855–5000; fax 514–855–7401; email