Skip to Content
Rule

Airworthiness Directives; Rolls-Royce plc (RR) RB211 Trent 500 Series Turbofan Engines

Action

Final Rule; Request For Comments.

Summary

The FAA is superseding an existing airworthiness directive (AD) for RR RB211 Trent 553-61, 553A2-61, 556-61, 556A2-61, 556B-61, 556B2-61, 560-61, and 560A2-61 turbofan engines. That AD currently requires removing certain serial-numbered intermediate pressure compressor (IPC) drums, part number (P/N) FK30102. This AD requires removing those same IPC drums, and requires a new reduced life limit for all other IPC drums, P/N FK30102. This AD results from an RR engineering assessment that it is necessary to reduce the cyclic lives of the other drums with the same P/N. We are issuing this AD to prevent uncontained loss of IPC stage 1 blades, which could result in damage to the airplane.

Unified Agenda

Airworthiness Directives

1 action from November 2013

  • November 2013
    • Actions Will Continue Through
 

Table of Contents Back to Top

Tables Back to Top

DATES: Back to Top

Effective July 7, 2008.

We must receive any comments on this AD by July 29, 2008.

ADDRESSES: Back to Top

Use one of the following addresses to comment on this AD.

  • Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
  • Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue, SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
  • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
  • Fax: (202) 493-2251.

Contact Rolls-Royce plc, P.O. Box 31, Derby, DE24 8BJ, United Kingdom; telephone: 44 (0) 1332 242424; fax: 44 (0) 1332 249936; e-mail http://tech.help@rolls-royce.com for the service information identified in this AD, or download the service information from https://www.aeromanager.com.

FOR FURTHER INFORMATION CONTACT: Back to Top

James Lawrence, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: james.lawrence@faa.gov; telephone (781) 238-7176, fax (781) 238-7199.

SUPPLEMENTARY INFORMATION: Back to Top

On September 11, 2007, the FAA issued AD 2007-19-10, Amendment 39-15201 (72 FR 53108, September 18, 2007). That AD requires replacing certain IPC drums, listed in that AD by serial number, before exceeding 2,910 cycles-since-new (CSN). That AD was the result of a discovery of strain-induced porosity in a Trent 500 IPC drum forging. That condition, if not corrected, could result in uncontained loss of IPC stage 1 blades, which could result in damage to the airplane.

Actions Since AD 2007-19-10 Was Issued Back to Top

Since that AD was issued, the European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Union, recently notified us that an unsafe condition may exist on RR RB211 Trent 553-61, 553A2-61, 556-61, 556A2-61, 556B-61, 556B2-61, 560-61, and 560A2-61 turbofan engines. The EASA advises that it is necessary to reduce the cyclic lives of the other drums with the same P/N. This AD requires:

  • Removing IPC drums, P/N FK30102, that have a serial number (SN) specified in this AD, within 2,910 CSN or the next overhaul after the effective date of this AD, whichever occurs first; and
  • Removing all other IPC drums, P/N FK30102, within 5,830 CSN.

We are issuing this AD to prevent uncontained loss of IPC stage 1 blades, which could result in damage to the airplane.

Bilateral Airworthiness Agreement Back to Top

This engine model is manufactured in the United Kingdom and is type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Under this bilateral airworthiness agreement, the EASA has kept the FAA informed of the situation described above. We have examined the findings of the EASA, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.

FAA's Determination and Requirements of This AD Back to Top

Although no airplanes that are registered in the United States use these engines, the possibility exists that the engines could be used on airplanes that are registered in the United States in the future. The unsafe condition described previously is likely to exist or develop on other RR RB211 Trent 553-61, 553A2-61, 556-61, 556A2-61, 556B-61, 556B2-61, 560-61, and 560A2-61 turbofan engines of the same type design. We are issuing this AD to prevent uncontained loss of IPC stage 1 blades, which could result in damage to the airplane. This AD requires:

  • Removing IPC drums, P/N FK30102, that have an SN specified in this AD, within 2,910 CSN or the next overhaul after the effective date of this AD, whichever occurs first, and
  • Removing all other IPC drums, P/N FK30102, within 5,830 CSN.

FAA's Determination of the Effective Date Back to Top

Since there are currently no domestic operators of this engine model, notice and opportunity for public comment before issuing this AD are unnecessary. Therefore, a situation exists that allows the immediate adoption of this regulation.

Comments Invited Back to Top

This AD is a final rule that involves requirements affecting flight safety and was not preceded by notice and an opportunity for public comment; however, we invite you to send us any written relevant data, views, or arguments regarding this AD. Send your comments to an address listed under ADDRESSES. Include “AD Docket No. FAA-2007-27955; Directorate Identifier 2007-NE-15-AD” in the subject line of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of the rule that might suggest a need to modify it.

We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this AD. Using the search function of the Web site, anyone can find and read the comments in any of our dockets, including the name, if provided, of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).

Examining the AD Docket Back to Top

You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.

Authority for This Rulemaking Back to Top

Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, Section 106, describes the authority of the FAA Administrator. Subtitle VII, Aviation Programs, describes in more detail the scope of the Agency's authority.

We are issuing this rulemaking under the authority described in Subtitle VII, Part A, Subpart III, Section 44701, “General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.

Regulatory Findings Back to Top

We have determined that this AD will not have federalism implications under Executive Order 13132. This AD will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.

For the reasons discussed above, I certify that this AD:

1. Is not a “significant regulatory action” under Executive Order 12866;

2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and

3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.

We prepared a summary of the costs to comply with this AD and placed it in the AD Docket. You may get a copy of this summary at the address listed under ADDRESSES.

List of Subjects in 14 CFR Part 39 Back to Top

begin regulatory text

Adoption of the Amendment Back to Top

Under the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:

PART 39—AIRWORTHINESS DIRECTIVES Back to Top

1.The authority citation for part 39 continues to read as follows:

Authority:

49 U.S.C. 106(g), 40113, 44701.

§ 39.13 [Amended]

2.The FAA amends § 39.13 by removing Amendment 39-15201 72 FR 53108, September 18, 2007, and by adding a new airworthiness directive, Amendment 39-15539, to read as follows:

2008-11-16Rolls-Royce plc: Amendment 39-15539. Docket No. FAA-2007-27955; Directorate Identifier 2007-NE-15-AD.

Effective Date Back to Top

(a) This airworthiness directive (AD) becomes effective July 7, 2008.

Affected ADs Back to Top

(b) This AD supersedes AD 2007-19-10, Amendment 39-15201.

Applicability Back to Top

(c) This AD applies to Rolls-Royce plc (RR) RB211 Trent 553-61, 553A2-61, 556-61, 556A2-61, 556B-61, 556B2-61, 560-61, and 560A2-61 turbofan engines with an intermediate pressure compressor (IPC) drum, part number (P/N) FK30102, installed. These engines are installed on, but not limited to, Airbus A340-500 and 600 series airplanes.

Unsafe Condition Back to Top

(d) This AD results from an RR engineering assessment that it is necessary to reduce the cyclic lives of the other drums with the same P/N. We are issuing this AD to prevent uncontained loss of IPC stage 1 blades, which could result in damage to the airplane.

Compliance Back to Top

(e) You are responsible for having the actions required by this AD performed within the compliance times specified unless the actions have already been done.

Removing IPC drums, P/N FK30102, With Certain Serial Numbers (SNs) Back to Top

(f) For engines with an IPC drum, P/N FK30102, that has an SN specified in Table 1 of this AD, remove the IPC within 2,910 cycles-since-new (CSN) or the next overhaul after the effective date of this AD, whichever occurs first.

Table 1.—IPC Drums by SN Back to Top
MW0134967 MW0131219 MW0156891
MW0158192 MW0164840 MW0168864
MW0168190 MW0171399 KHI00012

Removing All Other IPC Drums, P/N FK30102 Back to Top

(g) For engines with an IPC drum, P/N FK30102, that doesn't have an SN specified in Table 1 of this AD, remove the IPC drum within 5,830 CSN.

Prohibited Installation of IPC Drums, P/N FK30102 Back to Top

(h) After the effective date of this AD, do not install the following:

(1) IPC drums, P/N FK30102, that have an SN specified in Table 1 of this AD, and have accumulated or exceeded 2,910 CSN.

(2) IPC drums, P/N FK30102, that don't have an SN specified in Table 1 of this AD, and have accumulated or exceeded 5,830 CSN.

Alternative Methods of Compliance Back to Top

(i) The Manager, Engine Certification Office, has the authority to approve alternative methods of compliance for this AD if requested using the procedures found in 14 CFR 39.19.

Material Incorporated by Reference Back to Top

(j) None.

Related Information Back to Top

(k) EASA airworthiness directive 2008-0042, dated February 27, 2008, and RR Alert Service Bulletins RB.211-72-AF258, Revision 1, dated March 29, 2007; and RB.211-72-AF431, dated January 14, 2008, also address the subject of this AD.

(l) Contact James Lawrence, Aerospace Engineer, Engine Certification Office, FAA, Engine and Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; e-mail: james.lawrence@faa.gov; telephone (781) 238-7176; fax (781) 238-7199, for more information about this AD.

end regulatory text

Issued in Burlington, Massachusetts, on May 21, 2008.

Robert G. Mann,

Acting Manager, Engine and Propeller Directorate, Aircraft Certification Service.

[FR Doc. E8-11946 Filed 5-29-08; 8:45 am]

BILLING CODE 4910-13-P

Site Feedback