Airworthiness Directives; Airbus Airplanes
Notice Of Proposed Rulemaking (Nprm).
We propose to adopt a new airworthiness directive (AD) for all Airbus Model A300 B4-603, B4-605R, and B4-622R airplanes; Model A300 C4-605R Variant F airplanes; and Model A300 F4-600R series airplanes. This proposed AD was prompted by a report that chafing was detected between the autopilot electrical wiring conduit and the wing bottom skin. This proposed AD would require modifying the wiring installation on the right-hand wing. We are proposing this AD to prevent sparking due to electrical chafing when flammable vapors are present in the area, which could cause an uncontrolled fire.
1 action from November 2013
- Actions Will Continue Through
Table of Contents Back to Top
- Examining the AD Docket
- FOR FURTHER INFORMATION CONTACT:
- SUPPLEMENTARY INFORMATION:
- Comments Invited
- Relevant Service Information
- FAA's Determination and Requirements of This Proposed AD
- Costs of Compliance
- Authority for This Rulemaking
- Regulatory Findings
- List of Subjects in 14 CFR Part 39
- The Proposed Amendment
- PART 39—AIRWORTHINESS DIRECTIVES
- (a) Comments Due Date
- (b) Affected ADs
- (c) Applicability
- (d) Subject
- (e) Reason
- (f) Compliance
- (g) Modification
- (h) Other FAA AD Provisions
- (i) Related Information
DATES: Back to Top
We must receive comments on this proposed AD by April 30, 2012.
ADDRESSES: Back to Top
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
- Fax: (202) 493-2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
- Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Airbus SAS—EAW (Airworthiness Office), 1 Rond Point Maurice Bellonte, 31707 Blagnac Cedex, France; telephone +33 5 61 93 36 96; fax +33 5 61 93 44 51; email firstname.lastname@example.org; Internet http://www.airbus.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221.
Examining the AD Docket Back to Top
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Back to Top
Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: (425) 227-2125; fax: (425) 227-1149; email: Dan.Rodina@faa.gov.
SUPPLEMENTARY INFORMATION: Back to Top
Comments Invited Back to Top
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-0264; Directorate Identifier 2011-NM-179-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion Back to Top
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA Airworthiness Directive 2011-0161, dated August 26, 2011 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
During a scheduled general visual inspection in a zone adjacent to a fuel tank (zone 675) chafing was detected between the autopilot electrical wiring conduit and the wing bottom skin.
This condition, in the scope of published FAA SFAR88 [Special Federal Aviation Regulation] and JAA [Joint Aviation Authority] Internal Policy INT/POL/25/12, is considered on ground to be a potential source of explosive condition due to the risk of a spark with electrical wire chafing when flammable vapours are present in the area. If left uncorrected, this condition could lead to an uncontrolled fire.
For the reasons described above, this [EASA] AD requires modification of the wiring installation to improve the routing and the protection of the harnesses in the zone 675/Rib 6 of the Right Hand wing.
You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information Back to Top
Airbus has issued Mandatory Service Bulletin A300-24-6109, dated July 4, 2011. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD Back to Top
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance Back to Top
Based on the service information, we estimate that this proposed AD would affect about 132 products of U.S. registry. We also estimate that it would take about 7 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $1,720 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $305,580, or $2,315 per product.
Authority for This Rulemaking Back to Top
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings Back to Top
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
The Proposed Amendment Back to Top
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES Back to Top
1. The authority citation for part 39 continues to read as follows:
§ 39.13 [Amended]
2. The FAA amends § 39.13 by adding the following new AD:
Airbus: Docket No. FAA-2012-0264; Directorate Identifier 2011-NM-179-AD.
(a) Comments Due Date Back to Top
We must receive comments by April 30, 2012.
(b) Affected ADs Back to Top
(c) Applicability Back to Top
This AD applies to Airbus Model A300 B4-603, B4-605R, and B4-622R airplanes; Model A300 C4-605R Variant F airplanes; and Model A300 F4-605R and F4-622R airplanes; certificated in any category; all serial numbers.
(d) Subject Back to Top
Air Transport Association (ATA) of America Code 92.
(e) Reason Back to Top
This AD was prompted by a report that chafing was detected between the autopilot electrical wiring conduit and the wing bottom skin. We are issuing this AD to prevent sparking due to electrical chafing when flammable vapors are present in the area, which could cause an uncontrollable fire.
(f) Compliance Back to Top
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Modification Back to Top
Within 30 months or 4,500 flight hours after the effective date of this AD, whichever occurs first: Modify the wiring in zone 675 of the right-hand wing, in accordance with the Accomplishment Instructions of Airbus Mandatory Service Bulletin A300-24-6109, dated July 4, 2011.
(h) Other FAA AD Provisions Back to Top
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, International Branch, ANM-116, Transport Airplane Directorate, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the International Branch, send it to ATTN: Dan Rodina, Aerospace Engineer, International Branch, ANM-116, Transport Airplane Directorate, FAA, 1601 Lind Avenue SW., Renton, WA 98057-3356; phone: (425) 227-2125; fax: (425) 227-1149; email: Dan.Rodina@faa.gov. Information may be emailed to: 9-ANM-116-AMOC-REQUESTS@faa.gov. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(i) Related Information Back to Top
Refer to MCAI European Aviation Safety Agency Airworthiness Directive 2011-0161, dated August 26, 2011; and Airbus Mandatory Service Bulletin A300-24-6109, dated July 4, 2011; for related information.
Issued in Renton, Washington, on March 1, 2012.
Jeffrey E. Duven,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 2012-6246 Filed 3-14-12; 8:45 am]
BILLING CODE 4910-13-P