Airworthiness Directives; Bombardier, Inc. Airplanes
Notice Of Proposed Rulemaking (Nprm).
We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2A12 (CL-601) and CL-600-2B16 (CL-601-3A, CL-601-3R, and CL-604 Variants) airplanes. This proposed AD was prompted by reports of jamming/malfunctioning of the left-hand engine thrust control mechanism. This proposed AD would require modifying the left-hand engine upper core-cowl. We are proposing this AD to prevent jamming/malfunctioning of the left-hand engine thrust control mechanism, which could lead to loss of control of the airplane.
1 action from November 2013
- Actions Will Continue Through
Table of Contents Back to Top
- Examining the AD Docket
- FOR FURTHER INFORMATION CONTACT:
- SUPPLEMENTARY INFORMATION:
- Comments Invited
- Relevant Service Information
- FAA's Determination and Requirements of This Proposed AD
- Costs of Compliance
- Authority for This Rulemaking
- Regulatory Findings
- List of Subjects in 14 CFR Part 39
- The Proposed Amendment
- PART 39—AIRWORTHINESS DIRECTIVES
- (a) Comments Due Date
- (b) Affected ADs
- (c) Applicability
- (d) Subject
- (e) Reason
- (f) Compliance
- (g) Modification
- (h) Other FAA AD Provisions
- (i) Related Information
DATES: Back to Top
We must receive comments on this proposed AD by August 6, 2012.
ADDRESSES: Back to Top
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov. Follow the instructions for submitting comments.
- Fax: (202) 493-2251.
- Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC 20590.
- Hand Delivery: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE., Washington, DC, between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
For service information identified in this proposed AD, contact Bombardier, Inc., 400 Côte-Vertu Road West, Dorval, Québec H4S 1Y9, Canada; telephone 514-855-5000; fax 514-855-7401; email firstname.lastname@example.org; Internet http://www.bombardier.com. You may review copies of the referenced service information at the FAA, Transport Airplane Directorate, 1601 Lind Avenue SW., Renton, Washington. For information on the availability of this material at the FAA, call 425-227-1221.
Examining the AD Docket Back to Top
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (telephone (800) 647-5527) is in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Back to Top
Mazdak Hobbi, Aerospace Engineer,Propulsion and Services Branch, ANE-173, FAA, New York Aircraft Certification Office, 1600 Stewart Avenue, Westbury, NY 11590; telephone (516) 228-7330;fax (516) 794-5531.
SUPPLEMENTARY INFORMATION: Back to Top
Comments Invited Back to Top
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-0641; Directorate Identifier 2011-NM-258-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact we receive about this proposed AD.
Discussion Back to Top
Transport Canada Civil Aviation, which is the aviation authority for Canada, has issued Canadian Airworthiness Directive CF-2011-37, dated October 19, 2011 (referred to after this as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
There have been several reported incidents of jamming/malfunctioning of the left hand (L/H) engine thrust control mechanism on the affected aeroplanes. The investigation has shown that an improperly stowed or dislodged upper core-cowl-door Hold Open Rod, can impede a Fuel Control Unit (FCU) function by obstructing the movement of the FCU actuating lever arm, hence rendering the L/H engine thrust control inoperable.
Due to the engine's orientation, the subject FCU fouling is limited only to the L/H engine installation on the affected twin engine powered aeroplanes; however the potential hazard of any in-flight engine shut down caused by jammed engine fuel control lever is a safety concern that warrants mitigating action.
In order to help alleviate the possibility of an in-flight engine shut down due to the subject fouling of the FCU lever by the core-cowl-door Hold Open Rod, Bombardier has issued three Service Bulletins to [modify the L/H engine upper core cowl by] install[ing] a new bracket at the L/H engine upper core-cowl-door location. This [Canadian] directive is issued to mandate the incorporation of the Service Bulletins 604-71-005, 601-0609 or 605-71-002, as applicable on the affected aeroplanes.
You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information Back to Top
Bombardier, Inc. has issued the following service bulletins:
- Bombardier Service Bulletin 601-0609, dated August 31, 2011 (for Model CL-600-2A12 airplanes)
- Bombardier Service Bulletin 604-71-005, dated July 18, 2011 (for Model CL-600-2B16 airplanes)
- Bombardier Service Bulletin 605-71-002, dated July 18, 2011 (for Model CL-600-2B16 airplanes).
The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD Back to Top
This product has been approved by the aviation authority of another country, and is approved for operation in the United States. Pursuant to our bilateral agreement with the State of Design Authority, we have been notified of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all pertinent information and determined an unsafe condition exists and is likely to exist or develop on other products of the same type design.
Costs of Compliance Back to Top
Based on the service information, we estimate that this proposed AD would affect about 407 products of U.S. registry. We also estimate that it would take about 3 work-hours per product to comply with the basic requirements of this proposed AD. The average labor rate is $85 per work-hour. Required parts would cost about $203 per product. Where the service information lists required parts costs that are covered under warranty, we have assumed that there will be no charge for these parts. As we do not control warranty coverage for affected parties, some parties may incur costs higher than estimated here. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $186,406, or $458 per product.
Authority for This Rulemaking Back to Top
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings Back to Top
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979);
3. Will not affect intrastate aviation in Alaska; and
4. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
The Proposed Amendment Back to Top
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES Back to Top
1. The authority citation for part 39 continues to read as follows:
§ 39.13 [Amended]
2. The FAA amends § 39.13 by adding the following new AD:
Bombardier, Inc.: Docket No. FAA-2012-0641; Directorate Identifier2011-NM-258-AD.
(a) Comments Due Date Back to Top
We must receive comments by August 6, 2012.
(b) Affected ADs Back to Top
(c) Applicability Back to Top
This AD applies to Bombardier, Inc. airplanes identified in paragraphs (c)(1) and (c)(2) of this AD, certificated in any category:
(1) Bombardier, Inc. Model CL-600-2A12 (CL-601) airplanes, serial numbers (S/Ns) 3001 through 3066 inclusive.
(2) Bombardier, Inc. Model CL-600-2B16 (CL-601-3A, CL-601-3R, and CL-604 Variants) airplanes, S/Ns 5001 through 5194 inclusive, 5301 through 5665 inclusive, and 5701 through 5884 inclusive.
(d) Subject Back to Top
Air Transport Association (ATA) of America Code 71: Powerplant.
(e) Reason Back to Top
This AD was prompted by reports of jamming/malfunctioning of the left-hand engine thrust control mechanism. We are issuing this AD to prevent jamming/malfunctioning of the left-hand engine thrust control mechanism, which could lead to loss of control of the airplane.
(f) Compliance Back to Top
You are responsible for having the actions required by this AD performed within the compliance times specified, unless the actions have already been done.
(g) Modification Back to Top
Within 36 months or 6,000 flight hours, whichever occurs first after the effective date of this AD: Modify the left-hand engine upper core-cowl, in accordance with the Accomplishment Instructions of the applicable service bulletin specified in paragraph (g)(1), (g)(2), or (g)(3) of this AD.
(1) Bombardier Service Bulletin 601-0609, dated August 31, 2011 (for Model CL-600-2A12 airplanes having S/Ns 3001 through 3066 inclusive, and Model CL-600-2B16 airplanes having S/Ns 5001 through 5194 inclusive).
(2) Bombardier Service Bulletin 604-71-005, dated July 18, 2011 (for Model CL-600-2B16 airplanes having S/Ns 5301 through 5665 inclusive).
(3) Bombardier Service Bulletin 605-71-002, dated July 18, 2011 (for Model CL-600-2B16 airplanes having S/Ns 5701 through 5884 inclusive).
(h) Other FAA AD Provisions Back to Top
The following provisions also apply to this AD:
(1) Alternative Methods of Compliance (AMOCs): The Manager, New York Aircraft Certification Office (ACO), ANE-170, FAA, has the authority to approve AMOCs for this AD, if requested using the procedures found in 14 CFR 39.19. In accordance with 14 CFR 39.19, send your request to your principal inspector or local Flight Standards District Office, as appropriate. If sending information directly to the New York ACO, send it to ATTN: Program Manager, Continuing Operational Safety, FAA, New York ACO, 1600 Stewart Avenue, Suite 410, Westbury, New York 11590; telephone 516-228-7300; fax 516-794-5531. Before using any approved AMOC, notify your appropriate principal inspector, or lacking a principal inspector, the manager of the local flight standards district office/certificate holding district office. The AMOC approval letter must specifically reference this AD.
(2) Airworthy Product: For any requirement in this AD to obtain corrective actions from a manufacturer or other source, use these actions if they are FAA-approved. Corrective actions are considered FAA-approved if they are approved by the State of Design Authority (or their delegated agent). You are required to assure the product is airworthy before it is returned to service.
(i) Related Information Back to Top
Refer to MCAI Canadian Airworthiness Directive CF-2011-37, dated October 19, 2011, and the service bulletins specified in paragraphs (i)(1), (i)(2), and (i)(3) of this AD, for related information.
(1) Bombardier Service Bulletin 601-0609, dated August 31, 2011.
(2) Bombardier Service Bulletin 604-71-005, dated July 18, 2011.
(3) Bombardier Service Bulletin 605-71-002, dated July 18, 2011.
Issued in Renton, Washington, on June 12, 2012.
Kalene C. Yanamura,
Acting Manager,Transport Airplane Directorate,Aircraft Certification Service.
[FR Doc. 2012-15167 Filed 6-20-12; 8:45 am]
BILLING CODE 4910-13-P