Airworthiness Directives; Rolls-Royce Deutschland Ltd & Co KG Turbofan Engines
Notice Of Proposed Rulemaking (Nprm).
We propose to adopt a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd & Co KG (RRD) Tay 611-8 turbofan engines. This proposed AD was prompted by a recent quality review determination that bolts with reduced material properties may have been installed in some engines. This proposed AD would require inspection and replacement if necessary, of affected bolts. We are proposing this AD to prevent uncontained turbine disc fracture and damage to the airplane.
1 action from November 2013
- Actions Will Continue Through
Table of Contents Back to Top
- Examining the AD Docket
- FOR FURTHER INFORMATION CONTACT:
- SUPPLEMENTARY INFORMATION:
- Comments Invited
- Relevant Service Information
- FAA's Determination and Requirements of This Proposed AD
- Costs of Compliance
- Authority for This Rulemaking
- Regulatory Findings
- List of Subjects in 14 CFR Part 39
- The Proposed Amendment
- PART 39—AIRWORTHINESS DIRECTIVES
- (a) Comments Due Date
- (b) Affected Airworthiness Directives (ADs)
- (c) Applicability
- (d) Reason
- (e) Actions and Compliance
- (f) Installation Prohibition
- (g) Paperwork Reduction Act Burden Statement
- (h) Alternative Methods of Compliance (AMOCs)
- (i) Related Information
- (j) Material Incorporated by Reference
DATES: Back to Top
We must receive comments on this proposed AD by January 14, 2013.
ADDRESSES: Back to Top
You may send comments by any of the following methods:
- Federal eRulemaking Portal: Go to http://www.regulations.gov and follow the instructions for sending your comments electronically.
- Mail: Docket Management Facility, U.S. Department of Transportation, 1200 New Jersey Avenue SE., West Building Ground Floor, Room W12-140, Washington, DC 20590-0001.
- Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays.
- Fax: 202-493-2251.
For service information identified in this proposed AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.
Examining the AD Docket Back to Top
You may examine the AD docket on the Internet at http://www.regulations.gov; or in person at the Docket Operations office between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this proposed AD, the regulatory evaluation, any comments received, and other information. The street address for the Docket Operations office (phone: 800-647-5527) is the same as the Mail address provided in the ADDRESSES section. Comments will be available in the AD docket shortly after receipt.
FOR FURTHER INFORMATION CONTACT: Back to Top
Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7779; fax: 781-238-7199; email: email@example.com.
SUPPLEMENTARY INFORMATION: Back to Top
Comments Invited Back to Top
We invite you to send any written relevant data, views, or arguments about this proposed AD. Send your comments to an address listed under the ADDRESSES section. Include “Docket No. FAA-2012-1031; Directorate Identifier 2012-NE-31-AD” at the beginning of your comments. We specifically invite comments on the overall regulatory, economic, environmental, and energy aspects of this proposed AD. We will consider all comments received by the closing date and may amend this proposed AD based on those comments.
We will post all comments we receive, without change, to http://www.regulations.gov, including any personal information you provide. We will also post a report summarizing each substantive verbal contact with FAA personnel concerning this proposed AD. Using the search function of the Web site, anyone can find and read the comments in any of our dockets, including, if provided, the name of the individual who sent the comment (or signed the comment on behalf of an association, business, labor union, etc.). You may review the DOT's complete Privacy Act Statement in the Federal Register published on April 11, 2000 (65 FR 19477-78).
Discussion Back to Top
The European Aviation Safety Agency (EASA), which is the Technical Agent for the Member States of the European Community, has issued EASA AD 2012-0163, dated August 28, 2012 (referred to hereinafter as “the MCAI”), to correct an unsafe condition for the specified products. The MCAI states:
The results of a recent quality review of low pressure turbine (LPT) stage 1 static air seal and high pressure turbine (HPT) stage 1 air seal support bolts identified that, before installation, those bolts may have not been inspected. As a consequence, bolts with reduced material properties may have been installed in some engines.
This condition, if not detected and corrected, could lead to failure of a bolt, potentially causing turbine disc fracture and release of high-energy debris, possibly resulting in damage to the aeroplane and/or injury to the occupants.
You may obtain further information by examining the MCAI in the AD docket.
Relevant Service Information Back to Top
RRD has issued Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012. The actions described in this service information are intended to correct the unsafe condition identified in the MCAI.
FAA's Determination and Requirements of This Proposed AD Back to Top
This product has been approved by EASA, and is approved for operation in the United States. Pursuant to our bilateral agreement with the European Community, EASA has notified us of the unsafe condition described in the MCAI and service information referenced above. We are proposing this AD because we evaluated all information provided by EASA and determined the unsafe condition exists and is likely to exist or develop on other products of the same type design. This proposed AD would require inspection and replacement if necessary, of affected bolts.
Costs of Compliance Back to Top
Based on the service information, we estimate that this proposed AD would affect about 20 engines installed on airplanes of U.S. registry. We also estimate that it would take about 4 hours per engine to comply with this proposed AD. The average labor rate is $85 per hour. Required parts would cost about $1,848. Based on these figures, we estimate the cost of the proposed AD on U.S. operators to be $43,760.
Authority for This Rulemaking Back to Top
Title 49 of the United States Code specifies the FAA's authority to issue rules on aviation safety. Subtitle I, section 106, describes the authority of the FAA Administrator. “Subtitle VII: Aviation Programs,” describes in more detail the scope of the Agency's authority.
We are issuing this rulemaking under the authority described in “Subtitle VII, Part A, Subpart III, Section 44701: General requirements.” Under that section, Congress charges the FAA with promoting safe flight of civil aircraft in air commerce by prescribing regulations for practices, methods, and procedures the Administrator finds necessary for safety in air commerce. This regulation is within the scope of that authority because it addresses an unsafe condition that is likely to exist or develop on products identified in this rulemaking action.
Regulatory Findings Back to Top
We determined that this proposed AD would not have federalism implications under Executive Order 13132. This proposed AD would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government.
For the reasons discussed above, I certify this proposed regulation:
1. Is not a “significant regulatory action” under Executive Order 12866;
2. Is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and
3. Will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.
We prepared a regulatory evaluation of the estimated costs to comply with this proposed AD and placed it in the AD docket.
The Proposed Amendment Back to Top
Accordingly, under the authority delegated to me by the Administrator, the FAA proposes to amend 14 CFR part 39 as follows:
PART 39—AIRWORTHINESS DIRECTIVES Back to Top
1. The authority citation for part 39 continues to read as follows:
§ 39.13 [Amended]
2. The FAA amends § 39.13 by adding the following new AD:
Rolls-Royce Deutschland Ltd & Co KG (Formerly Rolls-Royce Deutschland GmbH, Formerly Rolls-Royce plc): Docket No. FAA-2012-1031; Directorate Identifier 2012-NE-31-AD.
(a) Comments Due Date Back to Top
We must receive comments by January 14, 2013.
(b) Affected Airworthiness Directives (ADs) Back to Top
(c) Applicability Back to Top
This AD applies to Rolls-Royce Deutschland Ltd & Co KG (RRD) Tay 611-8 turbofan engines, serial numbers 16245, 16256, 16417, 16418, 16584, 16585, 16639, 16640, 16701, 16702, 16813, 16814, 16853, 16854, 16879, 16880, 16898, 16905, 16906, 16911, 16923, 16935, and 16936, with a date of the last shop visit before December 8, 2006.
(d) Reason Back to Top
This AD was prompted by a recent quality review determination that bolts with reduced material properties may have been installed in some engines. We are issuing this AD to prevent uncontained turbine disc fracture and damage to the airplane.
(e) Actions and Compliance Back to Top
Unless already done, for engines with a date of the last shop visit before December 8, 2006, do the following actions:
(1) If engine cycles accumulated since the last engine shop visit is 5,400 cycles or more on the effective date of this AD, inspect the bolts installed in the low-pressure turbine (LPT) stage 1 static seal and high-pressure turbine (HPT) stage 1 air seal support within 100 engine cycles-in-service.
(2) If engine cycles accumulated since the last engine shop visit is fewer than 5,400 cycles on the effective date of this AD, inspect the bolts installed in the LPT stage 1 static seal and HPT stage 1 air seal support before accumulating 5,500 engine cycles since the last engine shop visit.
(3) If any broken bolt, brown bolt, or bolt with a rough oxidized surface is identified, then replace all bolts with new bolts before further flight.
(4) Within 30 days after the inspection, report the inspection findings to RRD service engineering. Guidance on reporting can be found in Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012.
(f) Installation Prohibition Back to Top
After the effective date of this AD, do not install any HPT module and/or LPT module into any engine, or any engine onto an airplane, unless the bolts have been inspected and replaced if necessary, as specified in paragraph (e) of this AD.
(g) Paperwork Reduction Act Burden Statement Back to Top
A federal agency may not conduct or sponsor, and a person is not required to respond to, nor shall a person be subject to a penalty for failure to comply with a collection of information subject to the requirements of the Paperwork Reduction Act unless that collection of information displays a current valid OMB Control Number. The OMB Control Number for this information collection is 2120-0056. Public reporting for this collection of information is estimated to be approximately 5 minutes per response, including the time for reviewing instructions, completing and reviewing the collection of information. All responses to this collection of information are mandatory. Comments concerning the accuracy of this burden and suggestions for reducing the burden should be directed to the FAA at: 800 Independence Ave. SW., Washington, DC 20591, Attn: Information Collection Clearance Officer, AES-200.
(h) Alternative Methods of Compliance (AMOCs) Back to Top
The Manager, Engine Certification Office, FAA, may approve AMOCs to this AD. Use the procedures found in 14 CFR 39.19 to make your request.
(i) Related Information Back to Top
(1) For more information about this AD, contact Frederick Zink, Aerospace Engineer, Engine Certification Office, FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA 01803; phone: 781-238-7779; fax: 781-238-7199; email: firstname.lastname@example.org.
(2) Refer to European Aviation Safety Agency AD 2012-0163, dated August 28, 2012, and RRD Alert Service Bulletin TAY-72-A1696, Revision 1, dated June 11, 2012, for related information.
(3) For service information identified in this AD, contact Rolls-Royce Deutschland Ltd & Co KG, Eschenweg 11, Dahlewitz, 15827 Blankenfelde-Mahlow, Germany; phone: 49 0 33-7086-1883; fax: 49 0 33-7086-3276. You may view this service information at the FAA, Engine & Propeller Directorate, 12 New England Executive Park, Burlington, MA. For information on the availability of this material at the FAA, call 781-238-7125.
(j) Material Incorporated by Reference Back to Top
Issued in Burlington, Massachusetts, on November 1, 2012.
Colleen M. D'Alessandro,
Assistant Manager, Engine & Propeller Directorate, Aircraft Certification Service.
[FR Doc. 2012-27454 Filed 11-9-12; 8:45 am]
BILLING CODE 4910-13-P