Federal Aviation Administration, DOT.
This amendment adopts a new airworthiness directive (AD), applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes, that requires a one-time inspection to detect chafing of the wires and harnesses in the cabin compartment ceiling; repair, if necessary; and installation of protective sleeving. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent false warnings of a hot engine exhaust tailpipe and intermittent signal failure, which could result in the consequent execution of unnecessary procedures by the flightcrew.
Effective July 24, 2000.
The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of July 24, 2000.
The service information referenced in this AD may be obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-581.88, Linköping, Start Printed Page 37852Sweden. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Norman B. Martenson, Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington 98055-4056; telephone (425) 227-2110; fax (425) 227-1149.End Further Info End Preamble Start Supplemental Information
A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes was published in the Federal Register on April 24, 2000 (65 FR 21677). That action proposed to require a one-time inspection to detect chafing of the wires and harnesses in the cabin compartment ceiling; repair, if necessary; and installation of protective sleeving.
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.
The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.
The FAA estimates that 288 airplanes of U.S. registry will be affected by this AD, that it will take approximately 36 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. Required parts for the sleeving installation will cost approximately $358 per airplane. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $725,184, or $2,518 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted.
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.Start List of Subjects
List of Subjects in 14 CFR Part 39
- Air transportation
- Aviation safety
- Incorporation by reference
Adoption of the AmendmentStart Amendment Part
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:End Amendment Part Start Part
PART 39—AIRWORTHINESS DIRECTIVESEnd Part Start Amendment Part
1. The authority citation for part 39 continues to read as follows:End Amendment Part
2. Section 39.13 is amended by adding the following new airworthiness directive:End Amendment Part
2000-12-14 SAAB Aircraft AB: Amendment 39-11792. Docket 2000-NM-25-AD.
Applicability: Model SAAB SF340A, serial numbers -004 through -159 inclusive; and SAAB 340B series airplanes, serial numbers -160 through -459 inclusive; certificated in any category.
This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (c) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent false warning of a hot engine exhaust tailpipe and intermittent signal failure, the consequent execution of unnecessary procedures by the flightcrew, accomplish the following:
(a) Prior to the accumulation of 14,000 total flight hours, or within 4,000 flight hours after the effective date of this AD, whichever occurs later: Perform a detailed visual inspection to detect chafing of the wires and harnesses in the cabin compartment ceiling, and install protective sleeving on all of the harnesses routed in the inspection area; in accordance with Saab Service Bulletin 340-92-027, dated December 10, 1999. Except as provided by paragraph (b) of this AD, prior to further flight, repair any chafing in accordance with the service bulletin.
For the purposes of this AD, a detailed visual inspection is defined as: “An intensive visual examination of a specific structural area, system, installation, or assembly to detect damage, failure, or irregularity. Available lighting is normally supplemented with a direct source of good lighting at intensity deemed appropriate by the inspector. Inspection aids such as mirror, magnifying lenses, etc., may be used. Surface cleaning and elaborate access procedures may be required.”
(b) For any chafing detected during the inspection required by paragraph (a) of this AD for which the service bulletin specifies to contact Saab for appropriate action: Prior to further flight, repair in accordance with a method approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate; or the Luftfartsverket (LFV) (or its delegated agent). For a repair method to be approved by the Manager, International Branch, ANM-116, as required by this paragraph, the Manager's approval letter must specifically reference this AD.
Alternative Methods of Compliance
(c) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, International Branch, ANM-116, FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, International Branch, ANM-116.
Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the International Branch, ANM-116.
Special Flight Permits
(d) Special flight permits may be issued in accordance with §§ 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished. Start Printed Page 37853
Incorporation by Reference
(e) Except as provided by paragraph (b) of this AD, the actions shall be done in accordance with Saab Service Bulletin 340-92-027, dated December 10, 1999. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Saab Aircraft AB, SAAB Aircraft Product Support, S-581.88, Linkoping, Sweden. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
The subject of this AD is addressed in Swedish airworthiness directive 1-149, dated December 10, 1999.
(f) This amendment becomes effective on July 24, 2000.Start Signature
Issued in Renton, Washington, on June 9, 2000.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 00-15184 Filed 6-16-00; 8:45 am]
BILLING CODE 4910-13-U