Skip to Content

Notice

Reports, Forms, and Recordkeeping Requirements

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

National Highway Traffic Safety Administration (NHTSA), Department of Transportation.

ACTION:

Request for public comment on proposed collections of information.

SUMMARY:

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatement of previously approved collections. This document describes one collection of information for which NHTSA intends to seek OMB approval.

DATES:

Comments must be received on or before July 9, 2001.

ADDRESSES:

Comments must refer to the docket notice numbers cited at the beginning of this notice and be submitted to Docket Management, Room PL-401, 400 Seventh Street, SW., Washington, DC 20590. Please identify the proposed collection of information for which a comment is provided, by referencing its OMB clearance Number. It is requested, but not required, that 2 copies of the comment be provided.

The Docket Section is open on weekdays from 10 a.m. to 5 p.m.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

For further information, contact Mr. Joseph Scott, Office of Crash Avoidance Standards, 400 Seventh Street, SW., DC 20590. Mr. Scott's telephone number is (202) 366-8525. His FAX number is (202) 493-2739. Please identify the relevant collection of information by referring to its OMB Control Number.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Under the Paperwork Reduction Act of 1995, before an agency submits a proposed collection of information to OMB for approval, it must first publish a document in the Federal Register providing a 60-day comment period and otherwise consult with members of the public and affected agencies concerning each proposed collection of information. The OMB has promulgated regulations describing what must be included in such a document. Under OMB's regulation (at 5CFR 1320.8(d)), an agency must ask for public comment on the following:

(i) whether the proposed collection of information is necessary for the proper performance of the functions of the agency, including whether the information will have practical utility;

(ii) the accuracy of the agency's estimate of the burden of the proposed collection of information, including the validity of the methodology and assumptions used;

(iii) how to enhance the quality, utility, and clarity of the information to be collected;

(iv) how to minimize the burden of the collection of information on those who are to respond, including the use of appropriate automated, electronic, mechanical, or other technological collection techniques or other forms of information technology, e.g. permitting electronic submission of responses.

In compliance with these requirements, NHTSA asks for public comments on the following proposed collections of information:

Title: Brake Hose Manufacturing Identification, Federal Motor Vehicle Safety Standard (FMVSS) No. 106.

OMB Control Number: 2127-0052.

Affected Public: Business or other for profit.

Abstract: Under the authority of the National Traffic and Motor Vehicle Safety Act of 1966, as amended, Title 15 United States Code 1932, Section 103, authorizes the issuance of Federal Motor Vehicle Safety Standards (FMVSS). The Act mandates that in issuing any Federal motor vehicle safety standards, the agency is to consider whether the standard is reasonable and appropriate for the particular type of motor vehicle or item of motor vehicle equipment for which it is prescribed. Using this authority, Standard 106, Brake Hoses, was issued. This standard specifies labeling and performance requirements for all motor vehicle brake hose assemblers, brake hose and brake hose end fittings manufacturers for automotive vehicles. These entities must register their identification marks with NHTSA to comply with this standard.

Estimated Annual Burden: 30 hours.

Estimated Number of Respondents: 20.

Start Signature

Issued on: May 3, 2001.

Stephen R. Kratzke,

Associate Administrator for Safety Performance Standards.

End Signature End Supplemental Information

[FR Doc. 01-11565 Filed 5-7-01; 8:45 am]

BILLING CODE 4910-59-P