Skip to Content


Agency Information Collection Activities; Submission for OMB Review; Comment Request; Current Good Manufacturing Practice Regulations for Type A Medicated Articles

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


Food and Drug Administration, HHS.




The Food and Drug Administration (FDA) is announcing that the proposed collection of information listed below has been submitted to the Office of Management and Budget (OMB) for review and clearance under the Paperwork Reduction Act of 1995.


Submit written comments on the collection of information by July 16, 2001.


Submit written comments on the collection of information to the Office of Information and Regulatory Affairs, OMB, New Executive Office Bldg., 725 17th St. NW., rm. 10235, Washington, DC 20503, Attn: Wendy Taylor, Desk Officer for FDA.

Start Further Info


Denver Presley, Office of Information Resources Management (HFA-250), Food and Drug Administration, 5600 Fishers Lane, Rockville, MD 20857, 301-827-1472.

End Further Info End Preamble Start Supplemental Information


In compliance with 44 U.S.C. 3507, FDA has submitted the following proposed collection of information to OMB for review and clearance.

Current Good Manufacturing Practice Regulations for Type A Medicated Articles—21 CFR Part 226 (OMB Control No. 0910-0154)—Extension

Under section 501 of the Federal Food, Drug, and Cosmetic Act (the act) (21 U.S.C. 351), FDA has the statutory authority to issue current good manufacturing practice (CGMP) regulations for drugs, including Type A medicated articles. A Type A medicated article is a feed product containing a concentrated drug diluted with a feed carrier substance. A Type A medicated article is intended solely for use in the manufacture of another Type A medicated article or a Type B or Type C medicated feed. Medicated feeds are administered to animals for the prevention, cure, mitigation, or treatment of disease or for growth promotion and feed efficiency.

Statutory requirements for CGMPs for Type A medicated articles have been codified at part 266 (21 CFR part 226). Type A medicated articles that are not manufactured in accordance with these regulations are considered adulterated under section 501(a)(2)(B) of the act. Under part 226, a manufacturer is required to establish, maintain, and retain records for Type A medicated articles, including records to document procedures required under the manufacturing process to assure that proper quality control is maintained. Such records would, for example, contain information concerning receipt and inventory of drug components, batch production, laboratory assay results (i.e., batch and stability testing), and product distribution. This information is needed so that FDA can monitor drug usage and possible misformulation of Type A medicated articles. The information could also prove useful to FDA in investigating product defects when a drug is recalled. In addition, FDA will use the CGMP criteria in part 226 to determine whether or not the systems used by manufacturers of Type A medicated articles are adequate to assure that their medicated articles meet the requirements of the act as to safety and also meet the articles, claimed identity, strength, quality, and purity, as required by section 501(a)(2)(B) of the act.

The respondents for Type A medicated articles are pharmaceutical firms that manufacture both human and veterinary drugs, those firms that produce only veterinary drugs and commercial feed mills.

FDA estimates the burden of this collection of information as follows:

Table 1.—Estimated Annual Recordkeeping Burden1

21 CFR SectionNo. ­of ­RecordkeepersAnnual ­Frequency ­of ­RecordkeepingTotal ­Annual ­RecordsHours ­per ­RecordkeeperTotal Hours
1 There are no capital costs or operating and maintenance costs associated with this collection of information.

The estimate of the time required for record preparation and maintenance is based on agency communications with industry. Other information needed to calculate the total burden hours (i.e., manufacturing sites, number of Type A medicated articles being manufactured, etc.) is derived from agency records and experience.

Start Signature

Dated: June 8, 2001.

Margaret M. Dotzel,

Associate Commissioner for Policy.

End Signature End Supplemental Information

[FR Doc. 01-15080 Filed 6-14-01; 8:45 am]