Federal Aviation Administration, DOT.
This amendment adopts a new airworthiness directive (AD), applicable to certain Bombardier Model DHC-7 series airplanes, that requires modification of the pressure hoses to the ground spoiler actuators. This amendment is prompted by issuance of mandatory continuing airworthiness information by a foreign civil airworthiness authority. The actions specified by this AD are intended to prevent blockage of pressure hoses to the ground spoiler actuators, leading to uncommanded deployment of the ground spoilers, resulting in reduced controllability of the airplane. This action is intended to address the identified unsafe condition.
Effective July 24, 2001.
The incorporation by reference of certain publications listed in the regulations is approved by the Director of the Federal Register as of July 24, 2001.
The service information referenced in this AD may be obtained from Bombardier, Inc., Bombardier Regional Aircraft Division, 123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. This information may be examined at the Federal Aviation Administration (FAA), Transport Airplane Directorate, Rules Docket, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, New York Aircraft Certification Office, 10 Fifth Street, Third Floor, Valley Stream, New York; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Ezra Sasson, Aerospace Engineer, ANE-172, FAA, New York Aircraft Certification Office, 10 Fifth Street, Third Floor, Valley Stream, New York 11581; telephone (516) 256-7250; fax (516) 568-2716.End Further Info End Preamble Start Supplemental Information
A proposal to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) to include an airworthiness directive (AD) that is applicable to certain Bombardier Model DHC-7 series airplanes was published in the Federal Register on January 22, 2001 (66 FR 6495). That action proposed to require modifying the pressure hoses to the ground spoiler actuators.
Interested persons have been afforded an opportunity to participate in the making of this amendment. No comments were submitted in response to the proposal or the FAA's determination of the cost to the public.
The FAA has determined that air safety and the public interest require the adoption of the rule as proposed.
The FAA estimates that 30 Model DHC-7 series airplanes of U.S. registry will be affected by this AD, that it will take approximately 4 work hours per airplane to accomplish the required actions, and that the average labor rate is $60 per work hour. There will be no charge for required parts. Based on these figures, the cost impact of the AD on U.S. operators is estimated to be $7,200, or $240 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the requirements of this AD action, and that no operator would accomplish those actions in the future if this AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
The regulations adopted herein will not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this final rule does not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A final evaluation has been prepared for this action and it is contained in the Rules Docket. A copy of it may be obtained from the Rules Docket at the location provided under the caption ADDRESSES.Start List of Subjects
List of Subjects in 14 CFR Part 39End List of Subjects
Adoption of the AmendmentStart Amendment Part
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration amends part 39 of the Federal Aviation Regulations (End Amendment Part Start Part
PART 39—AIRWORTHINESS DIRECTIVESEnd Part Start Amendment Part
1. The authority citation for part 39 continues to read as follows:End Amendment Part
2. Section 39.13 is amended by adding the following new airworthiness directive:End Amendment Part
2001-12-11 Bombardier, Inc. (Formerly de Havilland, Inc.): Amendment 39-12266. Docket 2000-NM-272-AD.
Applicability: Model DHC-7 series airplanes, manufacturer's serial numbers 003 through 113 inclusive; certificated in any category.
This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent blockage of pressure hoses to the ground spoiler actuators, leading to uncommanded deployment of the ground Start Printed Page 32896spoilers, resulting in reduced controllability of the airplane, accomplish the following:
(a) Within 12 months after the effective date of this AD: Modify the pressure hoses on each ground spoiler actuator, in accordance with Bombardier Service Bulletin 7-27-90, dated September 3, 1999.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, New York Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, New York ACO.
Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the New York ACO.
Special Flight Permits
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
Incorporation by Reference
(d) The modification shall be done in accordance with Bombardier Service Bulletin 7-27-90, dated September 3, 1999. This incorporation by reference was approved by the Director of the Federal Register in accordance with 5 U.S.C. 552(a) and 1 CFR part 51. Copies may be obtained from Bombardier, Inc., Bombardier Regional Aircraft Division, 123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. Copies may be inspected at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, New York Aircraft Certification Office, 10 Fifth Street, Third Floor, Valley Stream, New York; or at the Office of the Federal Register, 800 North Capitol Street, NW., suite 700, Washington, DC.
The subject of this AD is addressed in Canadian airworthiness directive CF-99-29, dated November 3, 1999.
(e) This amendment becomes effective on July 24, 2001.Start Signature
Issued in Renton, Washington, on June 8, 2001.
Donald L. Riggin,
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 01-15088 Filed 6-18-01; 8:45 am]
BILLING CODE 4910-13-P