Federal Aviation Administration, DOT.
Notice of proposed rulemaking (NPRM).
This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain McDonnell Douglas Model DC-9-10, -20, -30, and -40 series airplanes. This proposal would require rework and reidentification of certain reflector assemblies of the passenger ceiling lights; and installation of a support channel above the reflector, as applicable. This proposal is prompted by reports of heat damaged lamp reflectors and scorched insulation blankets in the main cabin due to the lamps inside the reflectors creating high temperatures. The actions specified by the proposed AD are intended to prevent overheating of the lamp reflectors, which could result in smoke and fire in the main cabin.
Comments must be received by September 6, 2001.
Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 99-NM-288-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9 a.m. and 3 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: firstname.lastname@example.org. Comments sent via fax or the Internet must contain “Docket No. 99-NM-288-AD” in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.
The service information referenced in the proposed rule may be obtained from Boeing Commercial Aircraft Group, Long Beach Division, 3855 Lakewood Boulevard, Long Beach, California 90846, Attention: Data and Service Management, Dept. C1-L5A (D800-0024). This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Elvin Wheeler, Aerospace Engineer, Systems and Equipment Branch, ANM-130L, FAA, Los Angeles Aircraft Certification Office, 3960 Paramount Boulevard, Lakewood, California 90712-4137; telephone (562) 627-5344; fax (562) 627-5210.End Further Info End Preamble Start Supplemental Information
Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.
Submit comments using the following format:
- Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
- For each issue, state what specific change to the proposed AD is being requested.
- Include justification (e.g., reasons or data) for each request.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket Number 99-NM-288-AD.” The postcard will be date stamped and returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 99-NM-288-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.
In July 1996, a Boeing Model 747 series airplane was involved in an accident. As part of re-examining all aspects of the service experience of the airplane involved in the accident, the FAA participated in design review and testing to determine possible sources of ignition in center fuel tanks. As part of the review, we examined fuel system wiring with regard to the possible effects that wire degradation may have on arc propagation.
In 1997 in a parallel preceding, at the recommendation of the White House Commission on Aviation Safety and Security, the FAA expanded its Aging Transport Program to include non-structural systems and assembled a team for evaluating these systems. This team performed visual inspections of certain transport category airplanes for which 20 years or more had passed since date of manufacture. In addition, the team gathered information from interviews with FAA Principal Maintenance Inspectors and meetings with representatives of airplane manufacturers. This evaluation revealed that the length of time in service is not the only cause of wire degradation; inadequate maintenance, contamination, improper repair, and mechanical damage are all contributing factors. From the compilation of this comprehensive information, we developed the Aging Transport Non-Start Printed Page 38169Structural Systems Plan to increase airplane safety by increasing knowledge of how non-structural systems degrade and how causes of degradation can be reduced.
In 1998, an accident occurred off the coast of Nova Scotia involving a McDonnell Douglas Model MD-11 series airplane. Investigation indicates that a fire broke out in the cockpit and first class overhead area. Although the ignition source of the fire has not been determined, the FAA, in conjunction with Boeing and operators of Model MD-11, DC-8, DC-9, DC-10, and DC-9-80 series airplanes, is reviewing all aspects of the service history of those airplanes to identify potential unsafe conditions associated with wire degradation due to various contributing factors (e.g., inadequate maintenance, contamination, improper repair, and mechanical damage) and to take appropriate corrective actions. We have issued a series of airworthiness directives (AD) that address unsafe conditions identified during that process. This process is continuing and we may consider additional rulemaking actions as further results of the review become available. The cause of the Nova Scotia MD-11 accident has not yet been determined.
In 1999, the FAA Administrator established a formal advisory committee to facilitate the implementation of the Aging Transport Non-Structural Systems Plan. This committee, the Aging Transport Systems Rulemaking Advisory Committee (ATSRAC), is made up of representatives of airplane manufacturers, operators, user groups, aerospace and industry associations, and government agencies. As part of its mandate, ATSRAC will recommend rulemaking to increase transport category airplane safety in cases where solutions to safety problems connected to aging systems have been found and must be applied. Detailed analyses of certain transport category airplanes that have been removed from service, studies of service bulletins pertaining to certain wiring systems, and reviews of previously issued airworthiness directives (AD) requiring repetitive inspections of certain wiring systems, have resulted in valuable information on the cause and prevention of wire degradation due to various contributing factors (e.g., inadequate maintenance, contamination, improper repair, and mechanical damage).
In summary, as a result of the investigations described above, the FAA has determined that corrective action may be necessary to minimize the potential hazards associated with wire degradation. Such corrective action can be addressed in future ADs to provide an acceptable level of safety for the transport airplane fleet.
Identification of Unsafe Condition
The FAA has become aware of instances of heat damage to the reflector assemblies of the passenger compartment ceiling lights and scorching of the insulation blankets above the reflectors. These incidents occurred on McDonnell Douglas Model DC-9 series airplanes. Investigation revealed that the lamps inside the reflectors created high temperatures. The temperatures inside the reflector reached a point where the reflector material became soft enough to distort and come in contact with the lamps. The heat of the lamps melted holes through the reflectors and scorched the insulation blanket located directly above. Overheating of lamp reflectors, if not corrected, could result in smoke and fire in the main cabin.
Other Related Rulemaking
This proposed AD is one of a series of actions identified as part of the ATSRAC program initiative to maintain continued operational safety of aging non-structural systems in transport category airplanes. The program is continuing and the FAA may consider additional rulemaking actions as further results of the review become available.
Explanation of Relevant Service Information
The FAA has reviewed and approved McDonnell Douglas Alert Service Bulletin DC9-33A037, Revision 02, dated July 27, 1999, which describes procedures for rework and reidentification of the reflector assemblies of the passenger ceiling lights, and installation of a support channel above the reflector, as applicable. The rework involves replacing the resistor assemblies with new assemblies; and drilling a hole in the reflector parabola. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition.
Explanation of Requirements of Proposed Rule
Since an unsafe condition has been identified that is likely to exist or develop on other products of this same type design, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.
There are approximately 273 Model DC-9-10, -20, -30, and -40 series airplanes of the affected design in the worldwide fleet. The FAA estimates that 177 airplanes of U.S. registry would be affected by this proposed AD, that it would take between 8 and 12 work hours per airplane to accomplish the proposed actions, and that the average labor rate is $60 per work hour. Required parts would cost between $1,607 and $6,463 per airplane. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be between $369,399 and $1,271,391, or between $2,087 and $7,183 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this proposed regulation (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.Start List of Subjects
List of Subjects in 14 CFR Part 39
- Air transportation
- Aviation safety
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the Start Printed Page 38170Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:Start Part
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. Section 39.13 is amended by adding the following new airworthiness directive:
McDonnell Douglas: Docket 99-NM-288-AD.
Applicability: Model DC-9-10, -20, -30, and -40 series airplanes, as listed in McDonnell Douglas Alert Service Bulletin DC9-33A037, Revision 02, dated July 27, 1999; certificated in any category.
This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent overheating of the lamp reflectors, which could result in smoke and fire in the main cabin, accomplish the following:
(a) Within 1 year after the effective date of this AD, rework and reidentify the reflector assemblies of the passenger ceiling lights and install a support channel above the reflector, as applicable, in accordance with McDonnell Douglas Alert Service Bulletin DC9-33A037, Revision 02, dated July 27, 1999.
Rework and reidentification of reflector assemblies, and installation of support channels prior to the effective date of this AD in accordance with McDonnell Douglas Service Bulletin DC9-33-037, dated July 18, 1968, or Revision 1, dated May 6, 1971, is an acceptable method of compliance for the requirements of paragraph (a) of this AD.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, Los Angeles Aircraft Certification Office (ACO), FAA, Transport Airplane Directorate. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, Los Angeles ACO.
Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the Los Angeles ACO.
Special Flight Permit
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
Issued in Renton, Washington, on July 9, 2001.
Vi L. Lipski,
Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 01-17584 Filed 7-20-01; 8:45 am]
BILLING CODE 4910-13-U