Federal Aviation Administration, DOT.
Notice of proposed rulemaking (NPRM).
This document proposes the adoption of a new airworthiness directive (AD) that is applicable to certain Bombardier Model DHC-8-100, -200, and -300 series airplanes. This proposal would require replacement of the observer's seat latch assembly with a new, approved seat latch assembly. This action is necessary to prevent the observer's seat separating from its attachment points in the event of an accident or emergency landing due to an understrength seat latch assembly. This action is intended to address the identified unsafe condition.Start Printed Page 48992
Comments must be received by October 25, 2001.
Submit comments in triplicate to the Federal Aviation Administration (FAA), Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-241-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056. Comments may be inspected at this location between 9:00 a.m. and 3:00 p.m., Monday through Friday, except Federal holidays. Comments may be submitted via fax to (425) 227-1232. Comments may also be sent via the Internet using the following address: email@example.com. Comments sent via fax or the Internet must contain “Docket No. 2001-NM-241-AD” in the subject line and need not be submitted in triplicate. Comments sent via the Internet as attached electronic files must be formatted in Microsoft Word 97 for Windows or ASCII text.
The service information referenced in the proposed rule may be obtained from Bombardier, Inc., Bombardier Regional Aircraft Division, 123 Garratt Boulevard, Downsview, Ontario M3K 1Y5, Canada. This information may be examined at the FAA, Transport Airplane Directorate, 1601 Lind Avenue, SW., Renton, Washington; or at the FAA, New York Aircraft Certification Office, 10 Fifth Street, Third Floor, Valley Stream, New York.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Serge Napoleon, Aerospace Engineer, Airframe and Propulsion Branch, ANE-171, FAA, New York Aircraft Certification Office, 10 Fifth Street, Third Floor, Valley Stream, New York 11581; telephone (516) 256-7512; fax (516) 568-2716.End Further Info End Preamble Start Supplemental Information
Interested persons are invited to participate in the making of the proposed rule by submitting such written data, views, or arguments as they may desire. Communications shall identify the Rules Docket number and be submitted in triplicate to the address specified above. All communications received on or before the closing date for comments, specified above, will be considered before taking action on the proposed rule. The proposals contained in this action may be changed in light of the comments received.
Submit comments using the following format:
- Organize comments issue-by-issue. For example, discuss a request to change the compliance time and a request to change the service bulletin reference as two separate issues.
- For each issue, state what specific change to the proposed AD is being requested.
- Include justification (e.g., reasons or data) for each request.
Comments are specifically invited on the overall regulatory, economic, environmental, and energy aspects of the proposed rule. All comments submitted will be available, both before and after the closing date for comments, in the Rules Docket for examination by interested persons. A report summarizing each FAA-public contact concerned with the substance of this proposal will be filed in the Rules Docket.
Commenters wishing the FAA to acknowledge receipt of their comments submitted in response to this action must submit a self-addressed, stamped postcard on which the following statement is made: “Comments to Docket Number 2001-NM-241-AD.” The postcard will be date stamped and returned to the commenter.
Availability of NPRMs
Any person may obtain a copy of this NPRM by submitting a request to the FAA, Transport Airplane Directorate, ANM-114, Attention: Rules Docket No. 2001-NM-241-AD, 1601 Lind Avenue, SW., Renton, Washington 98055-4056.
Transport Canada Civil Aviation (TCCA), which is the airworthiness authority for Canada, notified the FAA that an unsafe condition may exist on certain Bombardier Model DHC-8-102, -103, -106, -201, -202, -301, -311, -314, and -315 airplanes. TCCA advises that the observer's seat latch assembly in the flight compartment and its attachment to the cockpit door frame have been found to be understrength on airplanes equipped with Hunting interiors. This condition, if not corrected, could result in the observer's seat separating from its attachment in the event of an accident or emergency landing.
Explanation of Relevant Service Information
Bombardier has issued Service Bulletin 8-25-307, dated November 13, 2000, which describes procedures for replacing the observer's seat latch components with new approved seat latch components in Hunting interior airplanes. Accomplishment of the actions specified in the service bulletin is intended to adequately address the identified unsafe condition. TCCA classified this service bulletin as mandatory and issued Canadian airworthiness directive CF-2001-18, dated May 4, 2001, in order to assure the continued airworthiness of these airplanes in Canada.
These airplane models are manufactured in Canada and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement. Pursuant to this bilateral airworthiness agreement, TCCA has kept the FAA informed of the situation described above. The FAA has examined the findings of TCCA, reviewed all available information, and determined that AD action is necessary for products of this type design that are certificated for operation in the United States.
Explanation of Requirements of Proposed Rule
Since an unsafe condition has been identified that is likely to exist or develop on other airplanes of the same type design registered in the United States, the proposed AD would require accomplishment of the actions specified in the service bulletin described previously.
The FAA estimates that 35 airplanes of U.S. registry would be affected by this proposed AD, that it would take approximately 4 work hours per airplane to accomplish the proposed replacement, and that the average labor rate is $60 per work hour. Required parts would cost approximately $1,372 per airplane. Based on these figures, the cost impact of the proposed AD on U.S. operators is estimated to be $56,420, or $1,612 per airplane.
The cost impact figure discussed above is based on assumptions that no operator has yet accomplished any of the proposed requirements of this AD action, and that no operator would accomplish those actions in the future if this proposed AD were not adopted. The cost impact figures discussed in AD rulemaking actions represent only the time necessary to perform the specific actions actually required by the AD. These figures typically do not include incidental costs, such as the time required to gain access and close up, planning time, or time necessitated by other administrative actions.
The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national Government and Start Printed Page 48993the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposal would not have federalism implications under Executive Order 13132.
For the reasons discussed above, I certify that this proposed regulation (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under the DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action is contained in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption “ADDRESSES.”Start List of Subjects
List of Subjects in 14 CFR Part 39End List of Subjects
The Proposed Amendment
Accordingly, pursuant to the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:Start Part
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. Section 39.13 is amended by adding the following new airworthiness directive:
Bombardier, Inc. (Formerly de Havilland, Inc.): Docket 2001-NM-241-AD.
Applicability: Model DHC-8-102, -103, -106, -201, -202, -301, -311, -314, and -315 airplanes, certificated in any category, serial numbers 408, 413, 434 through 507 inclusive, excluding serial numbers 452, 464, 490, and 506.
This AD applies to each airplane identified in the preceding applicability provision, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (b) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if the unsafe condition has not been eliminated, the request should include specific proposed actions to address it.
Compliance: Required as indicated, unless accomplished previously.
To prevent the observer's seat separating from its attachment points in the event of an accident or emergency landing, accomplish the following:
(a) Within 12 months after the effective date of this AD, replace the observer's seat latch assembly by incorporating ModSum 8Q100890 (including removing and discarding existing latch and installing serrated plate, shim, and new latch assembly), in accordance with Bombardier Service Bulletin 8-25-307, dated November 13, 2000.
Alternative Methods of Compliance
(b) An alternative method of compliance or adjustment of the compliance time that provides an acceptable level of safety may be used if approved by the Manager, New York Aircraft Certification Office (ACO), FAA. Operators shall submit their requests through an appropriate FAA Principal Maintenance Inspector, who may add comments and then send it to the Manager, New York ACO.
Information concerning the existence of approved alternative methods of compliance with this AD, if any, may be obtained from the New York ACO.
Special Flight Permits
(c) Special flight permits may be issued in accordance with sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate the airplane to a location where the requirements of this AD can be accomplished.
The subject of this AD is addressed in Canadian airworthiness directive CF-2001-18, dated May 4, 2001.
Issued in Renton, Washington, on September 18, 2001.
Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.
[FR Doc. 01-23842 Filed 9-24-01; 8:45 am]
BILLING CODE 4910-13-U