Skip to Content


Reports, Forms and Record Keeping Requirements; Agency Information Collection Activity Under OMB Review

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble


National Highway Traffic Safety Administration, DOT.




In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comment. The ICR describes the nature of the information collections and their expected burden. The Federal Register Notice with a 60-day comment period was published on May 8, 2001 [66 FR 23315].


Comments must be submitted on or before November 19, 2001.

Start Further Info


Joseph Scott at the National Highway Traffic Safety Administration (NHTSA), Office of Crash Avoidance Standards, 202-366-8525. 400 Seventh Street, SW, Room 6240, Washington, DC 20590.

End Further Info End Preamble Start Supplemental Information


National Highway Traffic Safety Administration

Title: Brake Hose Manufacturers Identification.

OMB Number: 2127-0052.

Type of Request: Extension of a currently approved collection.

Abstract: Under the authority of the National Highway Traffic and Motor Vehicle Safety Act of 1966, as amended, Title 15 United States Code 1932, Section 103, authorizes the issuance of Federal Motor Vehicle Safety Standards (FMVSS). The Act mandates that in issuing any FMVSS, the agency is to consider whether the standard is reasonable and appropriate for the particular type of motor vehicle or item of motor vehicle equipment for which it is prescribed. Using this authority, Standard 106, Brake Hoses, was issued. This standard specifies labeling and performance requirements for all motor vehicle brake hose assemblers, brake hose and brake hose end fittings manufacturers for automotive vehicles. These entities must register their identification marks with NHTSA to comply with this standard.

Affected Public: Business of other for profit organizations.

Estimated Total Annual Burden: 30.


Send comments, within 30 days, to the Office of Information and Regulatory Affairs, Office of Management and Budget, 725—17th Street, NW, Washington, D.C. 20503, Attention NHTSA Desk Officer.

Comments Are Invited On

Whether the proposed collection of information is necessary for the proper performance of the functions of the Department, including whether the information will have practical utility; the accuracy of the Departments estimate of the burden of the proposed information collection; ways to enhance the quality, utility and clarity of the information to be collected; and ways to minimize the burden of the collection of information on respondents, including the use of automated collection techniques or other forms of information technology.

A Comment to OMB is most effective if OMB receives it within 30 days of publication.

Start Signature

Issued in Washington, DC, on October 5, 2001.

Herman L. Simms,

Associate Administrator for Administration.

End Signature End Supplemental Information

[FR Doc. 01-26231 Filed 10-17-01; 8:45 am]