Federal Aviation Administration (FAA), DOT.
This action establishes Class E airspace at Kenmare, ND. An Area Navigation (RNAV) Standard Instrument Approach Procedure (SIAP) to Runway 26 has been developed for Kenmare Municipal Airport. Controlled airspace extending upward from 700 feet above the surface is needed to contain aircraft executing this approach. This action creates Class E airspace for Kenmare, ND.
0901 UTC, February 21, 2002.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Denis C. Burke, Air Traffic Division, Airspace Branch, AGL-520, Federal Aviation Administration, 2300 East Devon Avenue, Des Plaines, Illinois 60018, telephone (847) 294-7568.End Further Info End Preamble Start Supplemental Information
On Thursday, October 19, 2000, the FAA proposed to amend 14 CFR part 71 to establish Class E airspace at Kenmare, ND (65 FR 62655). The proposal was to create controlled airspace extending upward from 700 feet above the surface to contain Instrument Flight Rules (IFR) operations in controlled airspace during portions of the terminal operation and while transiting between the enroute and terminal environments.
Interested parties were invited to participate in this rulemaking proceeding by submitting written comments on the proposal to the FAA. No comments objecting to the proposal were received. Class E airspace areas extending upward from 700 feet or more above the surface of the earth are published in paragraph 6005 of FAA Order 7400.9J dated August 31, 2001, and effective September 16, 2001, which is incorporated by reference in 14 CFR 71.1. The Class E airspace designations listed in this document will be published subsequently in the Order.
This amendment to 14 CFR part 71 establishes Class E airspace at Kenmare, ND, to accommodate aircraft executing instrument flight procedures into and out of Kenmare Municipal Airport. The area will be depicted on appropriate aeronautical charts.
The FAA has determined that this regulation only involves an established body of technical regulations for which frequent and routine amendments are necessary to keep them operationally current. Therefore, this regulation—(1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034; February 26, 1979); and (3) does not warrant preparation of a Regulatory Evaluation as the anticipated impact is so minimal. Since this is a routine matter that will only affect air traffic procedures and air navigation, it is certified that this rule will not have a significant economic impact on a substantial number of small entities under the criteria of the Regulatory Flexibility Act.Start List of Subjects
List of Subjects in 14 CFR Part 71End List of Subjects
Adoption of the AmendmentStart Amendment Part
In consideration of the foregoing, the Federal Aviation Administration amendsEnd Amendment Part Start Part
PART 71—DESIGNATION OF CLASS A, CLASS B, CLASS C, CLASS D, AND CLASS E AIRSPACE AREAS; AIRWAYS; ROUTES; AND REPORTING POINTSEnd Part Start Amendment Part
1. The authority citation for part 71 continues to read as follows:End Amendment Part
2. The incorporation by reference inEnd Amendment Part
Paragraph 6005 Class E airspace areas extending upward from 700 feet or more above the surface of the earth.
AGL ND E5 Kenmare, ND [New]
Kenmare Municipal Airport, ND
(Lat. 48°40′03″ N, long. 102°02′51″ W)
That airspace extending upward from 700 feet above the surface within a 6.3-mile radius of the Kenmare Municipal Airport, and that airspace extending upward from 1200 feet above the surface beginning at lat. 49°00′00″ N., long. 103°00′00″ W., to lat. 48°30′00″ N., long. 103°00′00″ W., to lat. 48°30′00″ N., long. 101°00′00″ W., to lat. 49°00′00″ N., long. 101°00′00″ W., thence to the point of beginning, excluding that airspace within the Minot AFB, ND, Mohall, ND, and Tioga, ND, Class E airspace areas.
Issued in Des Plaines, Illinois on December 5, 2001.
Nancy B. Shelton,
Manager, Air Traffic Division, Great Lakes Region.
[FR Doc. 02-253 Filed 1-3-02; 8:45 am]
BILLING CODE 4910-13-M