Skip to Content

Proposed Rule

Small Business Size Standards; Waiver of the Nonmanufacturer Rule; Rule for Bearings, Plain, Unmounted and Bearings, Mounted; Notice of Intent

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Small Business Administration.

ACTION:

Notice of intent to waive.

SUMMARY:

The Small Business Administration (SBA) is considering a waiver of the Nonmanufacturer Rule for bearings, plain, unmounted and bearings, mounted. The basis for waivers is that no small business manufacturers are supplying these classes of products to the Federal Government. The effect of a waiver would be to allow otherwise qualified regular dealers to supply the products of any domestic manufacturer on a Federal contract set aside for small businesses or awarded through the SBA 8(a) Program. The purpose of this notice of intent is to solicit comments and source information from interested parties.

DATES:

Comments and sources must be submitted on or before April 15, 2002.

ADDRESSES:

Edith Butler, Program Analyst, U.S. Small Business Administration, 409 3rd Street, SW., Washington DC, 20416, Tel: (202) 619-0422.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Edith Butler, Program Analyst, (202) 619-0422 FAX (202) 205-7280.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

Public Law 100-656, enacted on November 15, 1988, incorporated into the Small Business Act the previously existing regulation that recipients of Federal contracts set aside for small businesses or SBA 8(a) Program procurement must provide the product of a small business manufacturer or processor, if the recipient is other than the actual manufacturer or processor. This requirement is commonly referred to as the Nonmanufacturer Rule. The SBA regulations imposing this requirement are found at 13 CFR 121.906(b) and 121.1106(b). Section 303(h) of the law provides for waiver of this requirement by SBA for any “class of products” for which there are no small business manufacturers or processors in the Federal market.Start Printed Page 16064

To be considered available to participate in the Federal market on these classes of products, a small business manufacturer must have submitted a proposal for a contract solicitation or received a contract from the Federal government within the last 24 months. The SBA defines “class of products” based on two coding systems. The first is the Office of Management and Budget North American Industry Classification System (NAICS). The second is the Product and Service Code established by the Federal Procurement Data System.

This notice of intent proposes to waive the Nonmanufacturer Rule for bearings, plain, unmounted and bearings unmounted, North American Industry Classification System (NAICS)333613, public is invited to comment or provide source information to SBA on the proposed waiver of the nonmanufacturer rule for bearings, plain, unmounted and bearings, mounted, and invites the public to comment or provide information on potential small business manufacturers for these products.

In an effort to identify potential small business manufacturers, the SBA has searched Procurement Marketing & Access Network (PRO-Net) and the SBA will publish a notice in the FedBizOpps. The public is invited to comment or provide source information to SBA on the proposed waiver of the Nonmanufacturer Rule for these classes of products.

Start Signature

Luz A. Hopewell,

Associate Administrator for Government Contracting.

End Signature End Supplemental Information

[FR Doc. 02-7958 Filed 4-3-02; 8:45 am]

BILLING CODE 8025-01-P