Federal Aviation Administration, DOT.
Notice of proposed rulemaking (NPRM).
This document proposes to adopt a new airworthiness directive (AD) that would apply to all Britten Norman (Bembridge) Limited (Britten Norman) BN2A Mk. III series airplanes. This proposed AD would require you to repetitively inspect the rear engine-mounting frame for cracks and replace the frame if cracks are found. This proposed AD is the result of mandatory continuing airworthiness information (MCAI) issued by the airworthiness authority for the United Kingdom. The actions specified by this proposed AD are intended to detect and correct cracks in the rear engine-mounting frame, which could lead to engine mount failure. Such failure could result in separation of the engine from the airplane.
The Federal Aviation Administration (FAA) must receive any comments on this proposed rule on or before October 24, 2002.
Submit comments to FAA, Central Region, Office of the Regional Counsel, Attention: Rules Docket No. 2002-CE-36-AD, 901 Locust, Room 506, Kansas City, Missouri 64106. You may view any comments at this location between 8 a.m. and 4 p.m., Monday through Friday, except Federal holidays. You may also send comments electronically to the following address: 9-ACE-7-Docket@faa.gov. Comments sent electronically must contain “Docket No. 2002-CE-36-AD” in the subject line. If you send comments electronically as attached electronic files, the files must be formatted in Microsoft Word 97 for Windows or ASCII text.
You may get service information that applies to this proposed AD from Britten Norman (Bembridge) Limited Bembridge, Isle of Wight, United Kingdom PO35 5PR; telephone: +44 (0) 1983 872511; facsimile: +44 (0) 1983 873246. You may also view this information at the Rules Docket at the address above.Start Further Info
FOR FURTHER INFORMATION CONTACT:
Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; facsimile: (816) 329-4090.End Further Info End Preamble Start Supplemental Information
How Do I Comment on This Proposed AD?
The FAA invites comments on this proposed rule. You may submit whatever written data, views, or arguments you choose. You need to include the rule's docket number and submit your comments to the address specified under the caption ADDRESSES. We will consider all comments received on or before the closing date. We may amend this proposed rule in light of comments received. Factual information that supports your ideas and suggestions is extremely helpful in evaluating the effectiveness of this proposed AD action and determining whether we need to take additional rulemaking action.
Are There Any Specific Portions of This Proposed AD I Should Pay Attention to?
The FAA specifically invites comments on the overall regulatory, economic, environmental, and energy aspects of this proposed rule that might suggest a need to modify the rule. You may view all comments we receive before and after the closing date of the rule in the Rules Docket. We will file a report in the Rules Docket that summarizes each contact we have with Start Printed Page 58547the public that concerns the substantive parts of this proposed AD.
How Can I Be Sure FAA Receives My Comment?
If you want FAA to acknowledge the receipt of your mailed comments, you must include a self-addressed, stamped postcard. On the postcard, write “Comments to Docket No. 2002-CE-36-AD.” We will date stamp and mail the postcard back to you.
What Events Have Caused This Proposed AD?
The Civil Aviation Authority (CAA), which is the airworthiness authority for the United Kingdom, recently notified FAA that an unsafe condition may exist on all Britten Norman BN2A Mk. III series airplanes. The CAA reports that the manufacturer has reported three occurrences of cracks in the rear engine-mounting frame detected by operators during routine inspections.
What Are the Consequences if the Condition Is Not Corrected?
These cracks could lead to engine mount failure with consequent separation of the engine from the airplane.
Is There Service Information That Applies to This Subject?
Britten Norman has issued Service Bulletin No. SB 281, Issue 1, dated May 1, 2002.
What Are the Provisions of This Service Information?
The service bulletin includes procedures for:
—Inspecting the rear engine-mount frame for cracks; and
—Replacing the frame if cracks are found.
What Action Did the CAA Take?
The CAA classified this service bulletin as mandatory and issued British AD Number 001-05-2002, not dated, in order to ensure the continued airworthiness of these airplanes in the United Kingdom.
Was This in Accordance With the Bilateral Airworthiness Agreement?
These airplane models are manufactured in the United Kingdom and are type certificated for operation in the United States under the provisions of section 21.29 of the Federal Aviation Regulations (14 CFR 21.29) and the applicable bilateral airworthiness agreement.
Pursuant to this bilateral airworthiness agreement, the CAA has kept FAA informed of the situation described above.
The FAA's Determination and an Explanation of the Provisions of This Proposed AD
What Has FAA Decided?
The FAA has examined the findings of the CAA; reviewed all available information, including the service information referenced above; and determined that:
—The unsafe condition referenced in this document exists or could develop on other Britten Norman BN2A Mk. III series airplanes of the same type design that are on the U.S. registry;
—The actions specified in the previously-referenced service information should be accomplished on the affected airplanes; and
—AD action should be taken in order to correct this unsafe condition.
What Would This Proposed AD Require?
This proposed AD would require you to incorporate the actions in the previously-referenced service bulletin.
How Many Airplanes Would This Proposed AD Impact?
We estimate that this proposed AD affects 7 airplanes in the U.S. registry.
What Would Be the Cost Impact of This Proposed AD on Owners/Operators of the Affected Airplanes?
We estimate the following costs to accomplish each proposed inspection:
|Labor cost||Parts cost||Total cost per airplane||Total cost on U.S. operators|
|4 workhours × $60 per hour = $240||No cost for parts||$240||7 × $240 = $1,680|
We estimate the following costs to accomplish any necessary replacements that would be required based on the results of the proposed inspection. We have no way of determining the number of airplanes that may need such replacement:
|Labor cost||Parts cost||Total cost per airplane|
|30 workhours × $60 per hour = $1,800||$10,000||$11,800|
Would This Proposed AD Impact Various Entities?
The regulations proposed herein would not have a substantial direct effect on the States, on the relationship between the national government and the States, or on the distribution of power and responsibilities among the various levels of government. Therefore, it is determined that this proposed rule would not have federalism implications under Executive Order 13132.
Would This Proposed AD Involve a Significant Rule or Regulatory Action?
For the reasons discussed above, I certify that this proposed action (1) is not a “significant regulatory action” under Executive Order 12866; (2) is not a “significant rule” under DOT Regulatory Policies and Procedures (44 FR 11034, February 26, 1979); and (3) if promulgated, will not have a significant economic impact, positive or negative, on a substantial number of small entities under the criteria of the Regulatory Flexibility Act. A copy of the draft regulatory evaluation prepared for this action has been placed in the Rules Docket. A copy of it may be obtained by contacting the Rules Docket at the location provided under the caption ADDRESSES.Start List of Subjects Start Printed Page 58548
List of Subjects in 14 CFR Part 39
- Air transportation
- Aviation safety
The Proposed Amendment
Accordingly, under the authority delegated to me by the Administrator, the Federal Aviation Administration proposes to amend part 39 of the Federal Aviation Regulations (14 CFR part 39) as follows:Start Part
PART 39—AIRWORTHINESS DIRECTIVES
1. The authority citation for part 39 continues to read as follows:
2. FAA amends § 39.13 by adding a new airworthiness directive (AD) to read as follows:
Britten Norman (Bembridge) Limited: Docket No. 2002-CE-36-AD.
(a) What airplanes are affected by this AD? This AD affects Models BN2A MK. III, BN2A MK. III-2, and BN2A MK. III-3 airplanes, all serial numbers, that are certificated in any category.
(b) Who must comply with this AD? Anyone who wishes to operate any of the airplanes identified in paragraph (a) of this AD must comply with this AD.
(c) What problem does this AD address? The actions specified by this AD are intended to detect and correct cracks in the rear engine-mounting frame, which could lead to engine mount failure with consequent separation of the engine from the airplane.
(d) What actions must I accomplish to address this problem? To address this problem, you must accomplish the following:
|(1) Inspect the rear engine-mounting frame, part number (P/N) NB51-H-1021, or FAA-approved equivalent part number, for cracks||Initially upon accumulating 1,000 hours time-in-service (TIS) on the engine mounting frame or within the next 50 hours TIS after the effective date of this AD, whichever occurs later. If no cracks are found on the initial inspection, repetitively inspect every 200 hours TIS||In accordance with Britten-Norman Service Bulletin No. SB 281, Issue 1, dated May 1, 2002.|
|(2) If cracks are found during any inspection required in paragraph (d)(1) of this AD, replace the mounting frame with a new frame, P/N NB51-H-1021, or FAA-approved equivalent part number||Prior to further flight after the inspection in which any crack and/or damage is found. After installing the new frame, inspect as required in paragraph (d)(1) of this AD||In accordance with Britten-Norman Service Bulletin No. SB 281, Issue 1, dated May 1, 2002.|
When you replace the engine-mounting frame, this AD requires you to inspect per paragraph (d)(1) of this AD upon accumulating 1,000 hours TIS.
(e) Can I comply with this AD in any other way? You may use an alternative method of compliance or adjust the compliance time if:
(1) Your alternative method of compliance provides an equivalent level of safety; and
(2) The Standards Office Manager, Small Airplane Directorate, approves your alternative. Submit your request through an FAA Principal Maintenance Inspector, who may add comments and then send it to the Standards Office Manager.
This AD applies to each airplane identified in paragraph (a) of this AD, regardless of whether it has been modified, altered, or repaired in the area subject to the requirements of this AD. For airplanes that have been modified, altered, or repaired so that the performance of the requirements of this AD is affected, the owner/operator must request approval for an alternative method of compliance in accordance with paragraph (e) of this AD. The request should include an assessment of the effect of the modification, alteration, or repair on the unsafe condition addressed by this AD; and, if you have not eliminated the unsafe condition, specific actions you propose to address it.
(f) Where can I get information about any already-approved alternative methods of compliance? Contact Doug Rudolph, Aerospace Engineer, FAA, Small Airplane Directorate, 901 Locust, Room 301, Kansas City, Missouri 64106; telephone: (816) 329-4059; facsimile: (816) 329-4090.
(g) What if I need to fly the airplane to another location to comply with this AD? The FAA can issue a special flight permit under sections 21.197 and 21.199 of the Federal Aviation Regulations (14 CFR 21.197 and 21.199) to operate your airplane to a location where you can accomplish the requirements of this AD.
(h) How do I get copies of the documents referenced in this AD? You may get copies of the documents referenced in this AD from Britten Norman (Bembridge) Limited Bembridge, Isle of Wight, United Kingdom PO35 5PR; telephone: +44 (0) 1983 872511; facsimile: +44 (0) 1983 873246. You may view these documents at FAA, Central Region, Office of the Regional Counsel, 901 Locust, Room 506, Kansas City, Missouri 64106.
The subject of this AD is addressed in British AD 001-05-2002, not dated.
Issued in Kansas City, Missouri, on September 9, 2002.
Manager, Small Airplane Directorate, Aircraft Certification Service.
[FR Doc. 02-23515 Filed 9-16-02; 8:45 am]
BILLING CODE 4910-13-P