Skip to Content

Rule

Special Conditions: Avions Marcel Dassault-Breguet Aviation (AMD/BA) Model Falcon 10 Series AirPlanes; High-Intensity Radiated Fields (HIRF)

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

AGENCY:

Federal Aviation Administration (FAA), DOT.

ACTION:

Final special conditions; request for comments.

SUMMARY:

These special conditions are issued for Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes modified by Garrett Aviation Services. These airplanes, as modified, will have a novel or unusual design feature when compared to the state of technology envisioned in the airworthiness standards for transport category airplanes. The modification incorporates the installation of dual Innovative Solutions & Support Air Data Display Units (ADDU) with the IS&S Air Start Printed Page 65693Data Sensor and an analog interface unit (AIU) that perform critical functions. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for the protection of these systems from the effects of high-intensity-radiated fields (HIRF). These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

DATES:

The effective date of these special conditions is October 15, 2002. Comments must be received on or before November 27, 2002.

ADDRESSES:

Comments on these special conditions may be mailed in duplicate to: Federal Aviation Administration, Transport Airplane Directorate, Attn: Rules Docket (ANM-113), Docket No. NM232, 1601 Lind Avenue SW., Renton, Washington 98055-4056; or delivered in duplicate to the Transport Directorate at the above address. All comments must be marked: Docket No. NM232. Comments may be inspected in the Rules Docket weekdays, except Federal holidays, between 7:30 a.m. and 4 p.m.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Greg Dunn, FAA, Airplane and Flight Crew Interface Branch, ANM-111, Transport Airplane Directorate, Aircraft Certification Service, 1601 Lind Avenue SW., Renton, Washington 98055-4056; telephone (425) 227-2799; facsimile (425) 227-1149.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

FAA's Determination as to Need for Public Process

The FAA has determined that notice and opportunity for prior public comment are unnecessary in accordance with 14 CFR 11.38, because the FAA has provided previous opportunities to comment on substantially identical special conditions and has fully considered and addressed all the substantive comments received. Based on a review of the comment history and the comment resolution, the FAA is satisfied that new comments are unlikely. The FAA, therefore, finds that good cause exists for making these special conditions effective upon issuance. However, the FAA invites interested persons to participate in this rulemaking by submitting comments, data, or views. The most helpful comments reference a specific portion of the special conditions, explain the reason for any recommended change, and include supporting data. We ask that you send us two copies of written comments.

We will file in the docket all comments we receive, as well as a report summarizing each substantive public contact with FAA personnel concerning these special conditions. The docket is available for public inspection before and after the comment closing date. If you wish to review the docket in person, go to the address in the ADDRESSES section of this preamble between 7:30 a.m. and 4 p.m., Monday through Friday, except Federal holidays.

We will consider all comments we receive on or before the closing date for comments. We will consider comments filed late if it is possible to do so without incurring expense or delay. We may change these special conditions in light of the comments we receive.

If you want the FAA to acknowledge receipt of your comments on this proposal, include with your comments a pre-addressed, stamped postcard on which the docket number appears. We will stamp the date on the postcard and mail it back to you.

Background

On August 22, 2002, Garrett Aviation Services, 1200 North Airport Drive, Capital Airport, Springfield, IL 62707, applied for a supplemental type certificate (STC) to modify Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes approved under Type Certificate No. A33EU. The Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplane is a small category airplane powered by two Airesearch Manufacturing Company TFE731-2-1C turbofan engines and having a maximum takeoff weight of 18,300 pounds. This airplane operates with a 2-pilot crew and can hold up to 9 passengers. The modification incorporates the installation of Innovative Solutions & Support Air Data Display Units (ADDU) and an analog interface unit (AIU). The ADDU replaces the existing analog flight instrumentation and provides additional functional capability and redundancy in the system. The AIU is a digital-to-analog adapter used to adapt signals driving the existing Sperry Flight Guidance Computer. The avionics/electronics and electrical systems installed in this airplane have the potential to be vulnerable to high-intensity radiated fields (HIRF) external to the airplane.

Type Certification Basis

Under the provisions of 14 CFR 21.101, Amendment 21-69, effective September 16, 1991, Garrett Aviation Services must show that the Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes, as changed, continue to meet the applicable provisions of the regulations incorporated by reference in Type Certificate No. A33EU, or the applicable regulations in effect on the date of application for the change. Subsequent changes have been made to § 21.101 as part of Amendment 21-77, but those changes do not become effective until June 10, 2003. The regulations incorporated by reference in the type certificate are commonly referred to as the “original type certification basis.” The original type certification basis for the modified Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes includes 14 CFR part 25 as amended by Amendments 25-1 through 25-20, dated February 1, 1964, except for special conditions and exceptions noted in Type Certificate Data Sheet (TDCS) A33EU.

If the Administrator finds that the applicable airworthiness regulations (that is, 14 CFR part 25, as amended) do not contain adequate or appropriate safety standards for the Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes because of novel or unusual design features, special conditions are prescribed under the provisions of § 21.16.

In addition to the applicable airworthiness regulations and special conditions, the Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes must comply with the fuel vent and exhaust emission requirements of 14 CFR part 34 and the noise certification requirement of part 36, including Amendment 36-1.

Special conditions, as defined in 14 CFR 11.19, are issued in accordance with § 11.38 and become part of the type certification basis in accordance with § 21.101(b)(2).

Special conditions are initially applicable to the model for which they are issued. Should Garrett Aviation Services apply at a later date for a supplemental type certificate to modify any other model included on the same type certificate to incorporate the same novel or unusual design feature, these special conditions would also apply to the other model under the provisions of 14 CFR 21.101(a)(1).

Novel or Unusual Design Features

The Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes modified by Garrett Aviation Services will incorporate systems comprised of dual Air Data Display Units and an analog interface unit that will perform critical functions. These systems have the potential to be vulnerable to high-intensity radiated Start Printed Page 65694fields (HIRF) external to the airplane. The current airworthiness standards (14 CFR part 25) do not contain adequate or appropriate safety standards for the protection of this equipment from the adverse effects of HIRF. Accordingly, this system is considered to be a novel or unusual design feature.

Discussion

There is no specific regulation that addresses protection requirements for electrical and electronic systems from HIRF. Increased power levels from ground-based radio transmitters and the growing use of sensitive avionics/electronics and electrical systems to command and control airplanes have made it necessary to provide adequate protection.

To ensure that a level of safety is achieved that is equivalent to that intended by the regulations incorporated by reference, special conditions are needed for Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes modified by Garrett Aviation Services. These special conditions require that new avionics/electronics and electrical systems that perform critical functions be designed and installed to preclude component damage and interruption of function due to both the direct and indirect effects of HIRF.

High-Intensity Radiated Fields (HIRF)

With the trend toward increased power levels from ground-based transmitters, plus the advent of space and satellite communications, coupled with electronic command and control of the airplane, the immunity of critical avionics/electronics and electrical systems to HIRF must be established.

It is not possible to precisely define the HIRF to which the airplane will be exposed in service. There is also uncertainty concerning the effectiveness of airframe shielding for HIRF. Furthermore, coupling of electromagnetic energy to cockpit-installed equipment through the cockpit window apertures is undefined. Based on surveys and analysis of existing HIRF emitters, an adequate level of protection exists when compliance with the HIRF protection special condition is shown in accordance with either paragraph 1, or 2 below:

1. A minimum threat of 100 volts rms (root-mean-square) per meter electric field strength from 10 KHz to 18 GHz.

a. The threat must be applied to the system elements and their associated wiring harnesses without the benefit of airframe shielding.

b. Demonstration of this level of protection is established through system tests and analysis.

2. A threat external to the airframe of the field strengths indicated in the table below for the frequency ranges indicated. Both peak and average field strength components from the table below are to be demonstrated.

FrequencyField strength (volts per meter)
PeakAverage
10 kHz-100 kHz5050
100 kHz-500 kHz5050
500 kHz kHz-2 MHz5050
2 MHz-30 MHz100100
30 MHz-705050
70 MHz-100 MHz5050
100 MHz-200 MHz100100
200 MHz-400 MHz;100100
400 MHz-700 MHz70050
700 MHz-1 GHz700100
1 GHz-2 GHz2000200
2 GHz-4 GHz3000200
4 GHz-6 GHz3000200
6 GHz-8 GHz1000200
8 GHz-12 GHz3000300
12 GHz-18 GHz2000200
18 GHz- 40600200
The field strengths are expressed in terms of peak of the root-mean-square (rms) over the complete modulation period.

The threat levels identified above are the result of an FAA review of existing studies on the subject of HIRF, in light of the ongoing work of the Electromagnetic Effects Harmonization Working Group of the Aviation Rulemaking Advisory Committee.

Applicability

As discussed above, these special conditions are applicable to Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes modified by Garret Aviation Services. Should Garrett Aviation Services apply at a later date for a supplemental type certificate to modify any other model included on the same type certificate to incorporate the same novel or unusual design feature, these special conditions would apply to that model as well under the provisions of § 21.101(a)(1).

Conclusion

This action affects only certain novel or unusual design features on the Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes modified by Garrett Aviation Services. It is not a rule of general applicability and affects only the applicant who applied to the FAA for approval of these features on the airplane.

The substance of these special conditions has been subjected to the notice and comment period in several prior instances and has been derived without substantive change from those previously issued. It is unlikely that prior public comment would result in a significant change from the substance contained herein. For this reason, and because a delay would significantly affect the certification of the airplane, which is imminent, the FAA has determined that prior public notice and comment are unnecessary and impracticable, and good cause exists for adopting these special conditions upon issuance. The FAA is requesting comments to allow interested persons to submit views that may not have been submitted in response to the prior opportunities for comment described above.

Start List of Subjects

List of Subjects in 14 CFR Part 25

End List of Subjects Start Amendment Part

The authority citation for these special conditions is as follows:

End Amendment Part Start Authority

Authority: 49 U.S.C. 106(g), 40113, 44701, 44702, 44704.

End Authority

The Special Conditions

Start Amendment Part

Accordingly, pursuant to the authority delegated to me by the Administrator, the following special conditions are issued as part of the supplemental type certification basis for the Avions Marcel Dassault-Breguet Aviation Model Falcon 10 series airplanes modified by Garrett Aviation Services.

End Amendment Part

1. Protection from Unwanted Effects of High-Intensity Radiated Fields (HIRF). Each electrical and electronic system that performs critical functions must be designed and installed to ensure that the operation and operational capability of these systems to perform critical functions are not adversely affected when the airplane is exposed to high-intensity radiated fields.

2. For the purpose of these special conditions, the following definition applies: Critical Functions: Functions whose failure would contribute to or cause a failure condition that would prevent the continued safe flight and landing of the airplane.

Start Signature

Issued in Renton, Washington, on October 15, 2002.

Ali Bahrami,

Acting Manager, Transport Airplane Directorate, Aircraft Certification Service.

End Signature End Supplemental Information

[FR Doc. 02-27379 Filed 10-25-02; 8:45 am]

BILLING CODE 4910-13-PStart Printed Page 65695