Skip to Content

Notice

Petitions for Modification

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble

The following parties have filed petitions to modify the application of existing safety standards under section 101(c) of the Federal Mine Safety and Health Act of 1977.

1. Jim Walter Resources, Inc.

Jim Walter Resources, Inc., P.O. Box 133, Brookwood, Alabama 35444 has filed a petition to modify the application of 30 CFR 75.1002 (Installation of electric equipment and conductors; permissibility) to its No. 7 Mine (MSHA I.D. No. 01-01401) located in Tuscaloosa County, Alabama. The petitioner proposes to use a 2,400-volt power center with a high-voltage trailing cable to power a continuous miner inby the last open crosscut and within 150 feet of pillar workings. The petitioner has listed in this petition for modification specific terms and conditions that would be followed when its proposed alternative method is implemented. The petitioner asserts that the proposed alternative method would provide at least the same measure of protection as the existing standard.

Request for Comments

Persons interested in these petitions are encouraged to submit comments via e-mail to comments@msha.gov, or on a computer disk along with an original hard copy to the Office of Standards, Start Printed Page 10049Regulations, and Variances, Mine Safety and Health Administration, 1100 Wilson Boulevard, Room 2352, Arlington, Virginia 22209. All comments must be postmarked or received in that office on or before April 2, 2003. Copies of these petitions are available for inspection at that address.

Start Signature

Dated at Arlington, Virginia, this 25th day of February, 2003.

Marvin W. Nichols, Jr.,

Director, Office of Standards, Regulations, and Variances.

End Signature End Preamble

[FR Doc. 03-4860 Filed 2-28-03; 8:45 am]

BILLING CODE 4510-43-P