Skip to Content

Proposed Rule

Approval and Promulgation of Air Quality Implementation Plans; Pennsylvania; VOC and NOX

Document Details

Information about this document as published in the Federal Register.

Published Document

This document has been published in the Federal Register. Use the PDF linked in the document sidebar for the official electronic format.

Start Preamble Start Printed Page 46537

AGENCY:

Environmental Protection Agency (EPA).

ACTION:

Proposed rule.

SUMMARY:

EPA proposes to approve the State Implementation Plan (SIP) revisions submitted by the Commonwealth of Pennsylvania to establish and require reasonably available control technology (RACT) related requirements to limit volatile organic compounds (VOCs) and nitrogen oxides (NOX) from two sources. In the Final Rules section of this Federal Register, EPA is approving the Commonwealth's SIP revisions as a direct final rule without prior proposal because the Agency views this as a noncontroversial submittal and anticipates no adverse comments. The rationale for the approval is set forth in the direct final rule. If no adverse comments are received in response to this action, no further activity is contemplated. If EPA receives adverse comments, the direct final rule will be withdrawn and all public comments received will be addressed in a subsequent final rule based on this proposed rule. EPA will not institute a second comment period. Any parties interested in commenting on this action should do so at this time.

DATES:

Comments must be received in writing by September 5, 2003.

ADDRESSES:

Comments may be submitted either by mail or electronically. Written comments should be mailed to Makeba Morris, Chief, Air Quality Planning Branch, Mailcode 3AP21, U.S. Environmental Protection Agency, Region III, 1650 Arch Street, Philadelphia, Pennsylvania 19103. Electronic comments should be sent either to morris.makeba@epa.gov or to http://www.regulations.gov, which is an alternative method for submitting electronic comments to EPA. To submit comments, follow the detailed instructions described in the Supplementary Information section. Copies of the documents relevant to this action are available for public inspection during normal business hours at the Air Protection Division, U.S. Environmental Protection Agency, Region III, 1650 Arch Street, Philadelphia, Pennsylvania 19103; and the Maryland Department of the Environment, 1800 Washington Boulevard, Suite 705, Baltimore, Maryland, 21230.

Start Further Info

FOR FURTHER INFORMATION CONTACT:

Janice Lewis, (215) 814-2185, or by e-mail at lewis.janice@epa.gov.

End Further Info End Preamble Start Supplemental Information

SUPPLEMENTARY INFORMATION:

You may submit comments either electronically or by mail. To ensure proper receipt by EPA, identify the appropriate rulemaking identification number MD140-3094b in the subject line on the first page of your comment. Please ensure that your comments are submitted within the specified comment period. Comments received after the close of the comment period will be marked “late.” EPA is not required to consider these late comments.

1. Electronically. If you submit an electronic comment as prescribed below, EPA recommends that you include your name, mailing address, and an e-mail address or other contact information in the body of your comment. Also include this contact information on the outside of any disk or CD ROM you submit, and in any cover letter accompanying the disk or CD ROM. This ensures that you can be identified as the submitter of the comment and allows EPA to contact you in case EPA cannot read your comment due to technical difficulties or needs further information on the substance of your comment. EPA's policy is that EPA will not edit your comment, and any identifying or contact information provided in the body of a comment will be included as part of the comment that is placed in the official public docket, and made available in EPA's electronic public docket. If EPA cannot read your comment due to technical difficulties and cannot contact you for clarification, EPA may not be able to consider your comment.

i. E-mail. Comments may be sent by electronic mail (e-mail) to morris.makeba@epa.gov, attention PA203-4210b. EPA's e-mail system is not an “anonymous access” system. If you send an e-mail comment directly without going through Regulations.gov, EPA's e-mail system automatically captures your e-mail address. E-mail addresses that are automatically captured by EPA's e-mail system are included as part of the comment that is placed in the official public docket, and made available in EPA's electronic public docket.

ii. Regulations.gov. Your use of Regulation.gov is an alternative method of submitting electronic comments to EPA. Go directly to http://www.regulations.gov, then select “Environmental Protection Agency” at the top of the page and use the “go” button. The list of current EPA actions available for comment will be listed. Please follow the online instructions for submitting comments. The system is an “anonymous access” system, which means EPA will not know your identity, e-mail address, or other contact information unless you provide it in the body of your comment.

iii. Disk or CD ROM. You may submit comments on a disk or CD ROM that you mail to the mailing address identified in the ADDRESSES section of this document. These electronic submissions will be accepted in WordPerfect, Word or ASCII file format. Avoid the use of special characters and any form of encryption.

2. By Mail. Written comments should be addressed to the EPA Regional office listed in the ADDRESSES section of this document.

Please note that if EPA receives adverse comment on an amendment, paragraph, or section of this rule and if that provision may be severed from the remainder of the rule, EPA may adopt as final those provisions of the rule that are not the subject of an adverse comment.

Start Signature

Dated: June 26, 2003.

Donald S. Welsh,

Regional Administrator, Region III.

End Signature End Supplemental Information

[FR Doc. 03-19923 Filed 8-5-03; 8:45 am]

BILLING CODE 6560-50-P